Water flows from a hose that is connected to a main pipe that is at 400 kPa gauge pressure. A child places his thumb to cover most of the outlet of the hose, and makes a thin stream of water come out at high speed. If the hose is held up, how high could the jet go?

Q: Water flowing in a horizontal pipe is at a pressure of 1.40 x 10^5 Pa at a point where its cross…

A:

Q: A turbine is rated 620 hp when the flow of water through it is 22 ft3/s. Assuming an efficiency of…

A:

Q: In the pipe contraction shown in Fig. P3.70, water flows steadily with a velocity of V1 = 0.5 m/s…

A:

Q: Shuts the machines at wind speeds 10-16 km/h and 80-88km/h?

A: Ans: Anemometer

Q: Q2) A vertical wall is of 8 m in height as shown below. If a jet of water is coming out from a…

A:

Q: A lorry is carrying 4000 liters of water. It is driven from Kota Kinabalu to Mesilau and it was…

A: Given Data: The initial volume of water in the lorry is, V1=4000 litres. The change in the…

Q: In the pipe contraction shown in Fig. P3.70, water flows steadily with a velocity of V1 = 0.5 m/s…

A:

Q: there is friction in the piping, which means that an additional pressure equivalent to a height of…

A: In this problem, only height is given so answers will be in terms of parameters. Write the minimum…

Q: Problem Statement: A flow of water passes through a pipe and out of a nozzle as shown in the figure.…

A: Given , Water passes through a pipe then it flow through nozzle. Let the condition of pipe is…

Q: Water is flowing from a hose attached to a water main at 400 kPa gage see the figure. A child places…

A:

Q: Water is pumped from a lake through an 8-in. pipe at a rate of 10 ft'/s. if viscous effects are…

A: Given conditions; Flow rare = 10 ft^3/sec Viscous effects are negligible Diameter = 8 inch Z2=6ft…

Q: Theoretical horsepower required to pump water at 100 GPM from a larger reservoir to the surface of…

A:

Q: If a pump requires a minimum of 2.75 m of NPSHA, how high can the centerline of the pump be located…

A:

Q: Q2- Once it has been started by sufficient suction, the siphon in the Fig. will run continuously as…

A:

Q: Q3// What is the required force F applied on the bolts to keep the nozzle attached. 30kPa 2cm 4cm…

A:

Q: Say an aircraft equipped with a turbofan engine has a net thrust of 40,000 N. The mass of ai flowing…

A:

Q: • The firefighter holds the hose 1 m off the ground. What is the speed of the flow as it leaves the…

A: according to bartleby policy, answering first 3 subparts only.

Q: Water leaves a hose at a rate of 3.6-kg per 2.0-s with a speed of 19.3-m/s and is aimed at a toy car…

A:

Q: In the figure shown below the water comes out of a tank and runs through pipe 1 (D1=10cm) that…

A: The flow velocity in pipe 1 is 7.5 m/s.

Q: Water is flowing in a fire hose with a velocity of 1.0 m/s and a pressure of 200000 Pa. At the…

A: Given data: v1=1 m/sp1=200000 Pap2=101300 Pah1=h2ρ=1000 kg/m3g=9.8 m/s2 Need to determine the…

Q: A jet of water 50 mm in diameter strikes on a fixed plate normally with a velocity of 20 m/s. Find…

A: We must determine the force exerted on a flat plate by a jet of water with a diameter of 50 mm…

Q: What is the horsepower required for a fan to deliver 200ft/sec of air through a 2ft x 4ft duct under…

A:

Q: Air flows at a rate of 0.85 m3 /s through a horizontal round duet, which is reduced in diameter from…

A: Given:- Air is flowing through a horizontal round duct.     volume flow rate of air θ=0.85 m3/s…

Q: An office room has a dimensions of 3x4x3 meters. It is desired to ventilate theentire air in 20…

A:

Q: Water is flowing from a garden hose . A child places his thumb to cover most of the hose outlet,…

A: This numerical is an application of Bernoulli’s theorem According to Bernoulli’s theorem, the sum of…

Q: Two firefighters are fighting a fire with identical water hoses and nozzles, except that one is…

A:

Q: Water is flowing from hole 1cm radius at the bottom of a closed cylindrical container of 2m…

A:

Q: The pressure through a section of pipe is 21 PSI and the velocity of the fluid is 1 ft/sec. If the…

A: given data; pressure at section 1st (P1)=21PSI=144789.903pavelocity at section…

Q: Consider the water pump shown in fig, Determine the power that the pump supplies to the water if the…

A: The power that the pump supplies is 3186 W.

Q: water at 25 °C from a tank and takes it to point B at a rate of 0.095 m3/s. a) Calculate the height…

A: The power required by the pump can be calculated using the formula given below as- P=ρgQhm where, P…

Q: constant velocity of 3 m/s?[ Note: Neglect the pressure force effects] DA 7.6 cm jet of water…

A: When jet strikes normally on the plate, then Normal force exerted on the plate and its expressions…

Q: If a rocket propelled aircraft operates at an altitude of 13.03miles. What would be the ideal exit…

A:

Q: If you have a closed system that is filled with water on 2bar, the pump is selected for pressure…

A: 1) As it is a closed system, and the water inside the system is considered to be in static form…

Q: A jet of water 95 mm diameter is moving with a velocity of 25 m/s, strikes a stationary plate. Find…

A: A jet of water with a diameter of 95 mm and a velocity of 25 m/s collides with a stationary…

Q: The pressure through a section of pipe is 23 PSI and the velocity of the fluid is 3 ft/sec. If the…

A:

Q: The reservoir tank shown contains fresh water air pressurized to 200 kPa. There is a loss of 3.3…

A:

Q: Water flows into the atmosphere from a nozzle and strikes a vertical plate as shown in the figure…

A:

Q: Include appropriate diagram and sketch. Air flows steadily at low speed through a horizontal nozzle…

A:

Q: If a pipe with flowing water has a cross-sectional area nine times greater at point 2 than at point…

A: Find the velocity at point 2.

Q: Q4) A large tank with an open top, containing water. The water can drain from the tank through a…

A: Solution:

Q: This nozzle can be used to propel a rocket. As the rocket rises in altitude the atmospheric pressure…

A: With a change in local atmospheric pressure around the nozzle, the turning angle of the exhaust flow…

Q: A jet of water 50 mm in diameter strikes on a fixed plate normally with a velocity of 25 m/s. Find…

A: We have, Velocity of jet, V=25 m/s Diameter of jet, d=50 mm=501000=0.05 m

Q: Consider a venturi with a throat-to-inlet area ratio of 0.8 mounted in a flow at standard sea level…

A: a venturi with a throat-to-inlet area ratio=A2A1=0.8 P1-P2=7 lb/ft2=335.16181222222297 Pa≈335.162 Pa…