Using Mesh analysis, find i3 in Amperes if Is = 2.44 A and R = 4.4 Ohms. Give answer in 3 decimal places. No need for unit, just give the numerical value. R 50 292 ww 6 A 492 Is

Q: write the factor governing height of pole

A:

Q: 10μF H 18V 30 kohm 0.5 Mom www 5.6 k ohmi 10F HE 4.7 km 3 µP 180

A:

Q: 1.a. Section 300.15(C) requires a fitting to be installed on each end of a conduit or tubing being…

A: 1.a. According to NEC section 300.15(C), A conduit or box body shall not be required where cables…

Q: Calculate the total current if the voltage v delivered by the generator is 30 Volts. 80 Ω 20 Ω Μ 10…

A:

Q: An 8.0-mH inductor and a 2.0-02 resistor are wired in series to an ideal battery. A switch in the…

A:

Q: Explain mounting arrangement and positioning of switch boards

A: According to Siemens switch boards instruction and installation guide, •Extreme care should be taken…

Q: 360 A unity feedback system has a forward path transfer function given by G(s)=; (s+3)(s+60) (a)…

A: Steps to draw the bode plot: 1. Arrange the transfer function in the proper form 2. obtain the…

Q: (b) A single-phase transformer has 2000 turns on the primary winding and 500 turns on the secondary…

A:

Q: For non-inverting amplifier as show in Fig. 1.26. Input voltage is 1 V and output voltage is 10 V…

A:

Q: 3. The radar in which both transmission and reception is done using the same antenna are called: a)…

A: here we have to identify which radar has done both transmission and reception is done using the same…

Q: 3. A relay coil has a resistance of 500 ohms and inductance of 10mH. The triggering current of relay…

A: Solution is attached with this notes.Thank you.

Q: Question 6 a) Obtain the transfer function for the block diagram shown, by using the signal flow…

A: Given data, The block diagram is

Q: A perfect conductor could not contain an electrostatic field inside it. How will this behaviour…

A:

Q: Can you please describe the following: 1.) n-Channel JFET 2.) p-Channel JFET 3.) n-Channel…

A:

Q: A capacitor in an LC oscillator has a maximum potential difference of 15V and a maximum energy of…

A:

Q: In the system shown in Fig. 6.12, two functions of time x₁(f) and (f) are multiplied together and…

A: Given data, X1(jω) = 0 for ω≥ω1X2(jω) = 0 for ω≥ω2

Q: conditions

A: So the correct option is option "A"...

Q: An offshore wave energy device with a frontal width of 5 metres, an overall efficiency of 38% and a…

A:

Q: Question 6 a) Obtain the transfer function for the block diagram shown, by using the signal flow…

A:

Q: For the below circuit, find the power dissipated in the 62 resistor 1.6 Ω 10 A Select one: O a.…

A: We need to find out power dissipation in the given circuit

Q: draw mounting arrangement  of distribution board and main switch

A: It is asked to draw the mounting arrangement of distribution board and main switch.

Q: 13. Find Vx in the circuit of following figure: ΤΩ M 15 V 2 Vx + 502 (4.167V)

A: Given circuit,

Q: 8. Design a synchronous counter, with module 11, NBC code using only T synchronous Flip Flops with…

A:

Q: Solar vehicle based on electrical machines and power systems for human applications with block…

A:

Q: what is safe ? ac or dc motor ?

A: Introduction:   Regardless of which current we’re working with, both AC and DC are highly dangerous…

Q: In a short circuit test on a circuit breaker, the following readings were obtained on single…

A: Given in a short circuit test on a circuit breaker following readings, Time to reach the peak…

Q: c) A level 200 engineering student took a critical look to analyze the sketch with his basic…

A: Note: We are authorized to answer one question at a time since you have not mentioned which question…

Q: differentiate between overhead service connection and under ground service connection with sketch

A: Overhead Service Connection:- Electric locomotives, trolleybuses, and trams receive their electrical…

Q: 5. For the following circuit, complete the timing diagram for the output (Y). Neglect hold time and…

A: A D Flip Flop is a type of digital electrical circuit that delays the state change of its output…

Q: 8. A series RL DC circuit needs 10 ms for the current to reach 90% of its steady state value.…

A: We need to find out time constant for the given circuit

Q: 12-17. Determine the frequencies for electromagnetic waves with the following wavelengths: 5 c 50…

A:

Q: evaluate the size of conductor for overhead transmission lines

A: In the past, copper was frequently used as a conductor for transmission lines, but aluminum…

Q: Factor to obtain a product of sums: (c) AB+ A'B'C + B'C'D + BC'D' (d) A'C'D + AB'D' + A'CD' + BD (e)…

A: It is given that: c) AB+A'B'C+B'C'D+BC'D'd)A'C'D+AB'D'+A'CD'+BDe)WXY+WX'Y+WYZ+XYZ'

Q: Using the IEEE 754 floating point format, write down the bit pattern that would represent 1/4. Can…

A: IEEE 754 is the most efficient way of representing floating point numbers. It has three components:…

Q: 10.55 Find I, in the network in Fig. P10.55. 2:1 36/0°v(+ ww 6Ω Figure P10.55 -j8 Ω Ideal 12 Ω | j4Ω…

A:

Q: A capacitance 50microfarad and an inductance of 0.2025 Henry are connected in series. if the…

A: Given parameters : Series LC circuit Capacitance, C = 50 uf Inductance, L = 0.2025 H Negligible…

Q: The value of voltages V₁ and V₂ for the circuit shown below is: (Use Nodal Analysis Node Node V1…

A: Given circuit,

Q: 80. A series circuit with one branch of R = 60 and a single unknown element in the other branch has…

A: Since you have asked multiple questions, we will solve the first question for you. If you want any…

Q: When Inverters are used as the input to a NAND gate, the circuit performs what logic function? When…

A: NAND and NOR gates are the universal gates, using the NAND and NOR any gate can be implemented.  Let…

Q: draw single line diagram of 33kv substation with explanation and not copied from anywhere

A: Single-Line Diagram or SLD A single-line diagram (SLD) is the simplest of the diagrams used to…

Q: electrical what is the disadvantages of potential transformer ?

A: Potential transformer : The definition of a potential transformer is a device used to transmit…

Q: An initially relaxed RC circuit with R = 2 M and C = 1 µF is switched on to a step voltage of 10V.…

A:

Q: Derive the equation for impedance and phase shift for series RLC circuit connected to the AC…

A: A series RLC circuit is formed by connecting a resistor, inductor, and capacitor in series across a…

Q: le (mA) VCE -7.5 V Vcc=24V Rc {2.5 k Re 1.Sk 90 μ.Χ. 10 80 µA 70 μ.Χ. 60 μA 15 50 µA 25 µA 40 μA 30…

A: The characteristics shows are the output characteristics of CE configuration of a BJT. Q-point is…

Q: 7. Assume Q = 0 initially and determine the waveform of Q for the NAND SR latch with the following…

A:

Q: Determine the time constant for the circuit in Fig. 10 ΚΩ 100 pF 20 ΚΩ 40 ΚΩ 30 ΚΩ

A: Given data, Circuit diagram is given as,

Q: Consider the following. (LetC₁ = 28.40 μF and C₂ = 22.40 μF.) 6.00 μF C₂ + 9.00 V C₁ (a) Find the…

A: Given a circuit with C1=28.40 micro Farad , C2=22.40 micro Farad

Q: 12-9. Determine the SWR for a transmission line with maximum voltage standing-wave ampl Vmax = 6 V…

A: It is given that: Vmax=6 VVmin=0.5 V

Q: 3. The radar in which both transmission and reception is done using the same antenna are called:

A: The correct option along with the explanation is provided in the following section.

Q: 3. In an ideal op-amp, which is not true? a) Open loop voltage gain is infinite b) Input resistance…

A: The input resistance of an ideal op amp is infinite so input of the op amp is open terminal so no…

Code Conversion

The method or technique used to convert code from one format to another is termed code conversion. Code conversions are most commonly used in computers, digital electronics, microprocessors, etc.