Use the References to access important values if needed for this question. A sample of oxygen gas at a pressure of 0.756 atm and a temperature of 109°C, occupies a volume of 510. mL. If the gas is heated at constant pressure until its volume is 673 mL, the temperature of the gas sample will be °C. Submit Answer Retry Entire Group 9 more group attempts remaining

Use the References to access important values if needed for this question. A sample of oxygen gas at a pressure of 0.756 atm and a temperature of 109°C, occupies a volume of 510. mL. If the gas is heated at constant pressure until its volume is 673 mL, the temperature of the gas sample will be °C. Submit Answer Retry Entire Group 9 more group attempts remaining

Introductory Chemistry: A Foundation

9th Edition

ISBN:9781337399425

Author:Steven S. Zumdahl, Donald J. DeCoste

Publisher:Steven S. Zumdahl, Donald J. DeCoste

Chapter13: Gases

Section: Chapter Questions

Problem 157CP

See similar textbooks

Similar questions

Given that a sample of air is made up of nitrogen, oxygen, and argon in the mole fractions 0.78 N2, 0.21 O2, and 0.010 Ar, what is the density of air at standard temperature and pressure?
How does hydraulic fracturing differ from previously used techniques for the recovery of natural gas from the earth?
At elevated temperatures, sodium chlorate decomposes to produce sodium chloride and oxygen gas. A 0.8765-g sample of impure sodium chlorate was heated until the production of oxygen gas ceased. The oxygen gas collected over water occupied 57.2 mL at a temperature of 22C and a pressure of 734 torr. Calculate the mass percent of NaClO3 in the original sample. (At 22C the vapor pressure of water is 19.8 torr.)
Explain how the volume of the bubbles exhausted by a scuba diver (Figure 9.16) change as they rise to the surface, assuming that they remain intact.
93 The complete combustion of octane can be used as a model for the burning of gasoline: 2C8H18+25O216CO2+18H2O Assuming that this equation provides a reasonable model of the actual combustion process, what volume of air at 1.0 atm and 25°C must be taken into an engine to burn 1 gallon of gasoline? (The partial pressure of oxygen in air is 0.21 atm and the density of liquid octane is 0.70 g/mL.)
An organic compound contains C, H, N, and O. Combustion of 0.1023 g of the compound in excess oxygen yielded 0.2766 g CO2 and 0.0991 g H2O. A sample of 0.4831 g of the compound was analyzed for nitrogen by the Dumas method (see Exercise 129). At STP, 27.6 mL of dry N2 was obtained. In a third experiment, the density of the compound as a gas was found to be 4.02 g/L at 127C and 256 torr. What are the empirical and molecular formulas of the compound?
You have a gas, one of the three known phosphorus-fluorine compounds (PF3, PF3, and P2F4). To find out which, you have decided to measure its molar mass. (a) First, yon determine that the density of the gas is 5.60 g/L at a pressure of 0.971 atm and a temperature of 18.2 C. Calculate the molar mass and identify the compound. (b) To check the results from part (a), you decide to measure the molar mass based on the relative rales of effusion of the unknown gas and CO2. You find that CO2 effuses at a rate of 0.050 mol/min, whereas the unknown phosphorus fluoride effuses at a rate of 0.028 mol/min. Calculate the molar mass of the unknown gas based on these results.
What possible uses exist for the natural gas liquids that are removed from natural gas during its processing?
You are given 1.56 g of a mixture of KClO3 and KCl. When heated, the KClO3 decomposes to KCl and O2, 2 KClO3(s) 2 KCl(s) + 3 O2(g) and 327 mL of O2 with a pressure of 735 mm Hg is collected at 19 C. What is the weight percentage of KClO3 in the sample?