Two step-up transformers are connected in series, the secondary of the first to the primary of the second. Both transformers have the same turns ratio, and are identical. If the input voltage is 12.0 V AC and the output voltage is 300 V AC, what is the voltage, Vint, in between the two transformers? Vint=[?] V Voltage (V) Enter

Two step-up transformers are connected in series, the secondary of the first to the primary of the second. Both transformers have the same turns ratio, and are identical. If the input voltage is 12.0 V AC and the output voltage is 300 V AC, what is the voltage, Vint, in between the two transformers? Vint=[?] V Voltage (V) Enter

Delmar's Standard Textbook Of Electricity

7th Edition

ISBN:9781337900348

Author:Stephen L. Herman

Publisher:Stephen L. Herman

Chapter31: Three-phase Alternators

Section: Chapter Questions

Problem 1RQ: What conditions must be met before two alternators can be paralleled together?

See similar textbooks

Similar questions

what is the turns ratio or voltage ratio of the two transformers?
A three-winding transformer is connected to an AC voltage source as shown in the figure. The number of turns is as follows: N₁ = 100, N₂ = 50, N3 = 50. If the magnetizing current is neglected, and the currents in two windings on secondary side are 2230° and 22150°, then what is the value of the primary current in Ampere? I 0000000000- N₁ № ₂ Z 00000 00000 Z N3 H I₁₂ I₁₂₁ ¹3
In the circuit in Figure 2, the capacitor connected to the a-b terminals of the transformer anda circuit consisting of resistance is defined as a load circuit. a)Find the average power spent by the load circuit? b) How much of the average power calculated in a) by the resistance in the load circuit and how muchspent by the capacitor? Comment on the results obtained?
For performing dielectric-strength tests on insulating materials, two transformers are connected in a A. parallel combination.B. polyphase arrangement.C. series combination. D. cascade arrangement.
The dc armature resistance of delta-connected alternator measured across its two terminal is 0.8 ohm. The effective resistance per phase is?
A 200 V/100 V, 50 Hz transformer is to be excited at 40 Hz from 100 V side. For the exciting current to be constant, the applied voltage should be ?
In the circuit in Figure 2, the capacitor connected to the a-b terminals of the transformer anda circuit consisting of resistance is defined as a load circuit. Find the average power spent by the load circuit?
If you have 3-phase power and you need to step down (or up) in 3-phase voltage, how many single-phase transformers are needed? Explain.
When 120 V, 60 Hz is applied to the primary winding of a transformer, the core loss is 240 W. When 50 V, 25 Hz is applied, the core loss is 50 W. Determine the core loss when 230 V, 50 Hz is applied to the primary winding. Subject: Electrical Apparatus and Divices
The amount of inrush current in the primary of a transformer is limited by the........, A- amount of applied voltage, B- resistance of the wire in the primary winding, C- flux change of the magnetic field in the core, D - all of the above What precaution must be observed when working whit current transformers? A- never have a load on the secondary, B- always ha a load on the secondary, C- de-energize the primary whenever there is a load on the secondary, D - none The fact that the movable coil of a constant-current transformer moves further away from the stationary coil with a increase in load current is based on which fundamental priciple of magnetism? A- like magnetic poles attract, B- like magnetic poles repel, C- the amount of current flowing through a coil inverdely proportional to its flux density. D- none
In two winding transformers, windings are electrically isolated and magnetically connected. Select one: O True O False?
A 200 V/100 V, 50 Hz transformer is to be excited at 40 Hz from 100 V side. For the exciting current to be same, the applied voltage should be ?