tors with fiux per pole is 21 mwbD and the e m.f generated is 63 V, then the speed of the machine is O 655 rps O 0.66 rps O 38.46 rps O 115.38 rps The Auto transformers are used to provide a variable voltage output. Select one: O True OMEON De O False

tors with fiux per pole is 21 mwbD and the e m.f generated is 63 V, then the speed of the machine is O 655 rps O 0.66 rps O 38.46 rps O 115.38 rps The Auto transformers are used to provide a variable voltage output. Select one: O True OMEON De O False

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Related questions

Q: Approximate solution time is 5 minutes. A transformer supplies power to a feeder that has five…

Q: 9 A 100-ohm resistor is connected to the secondary winding of an ideal transformer with a turns…

Q: 19. On a short circuit test of a transformer, the readings are I = 10 A, E = 126 V, P = 400 W.…

A: Given data, Short circuit current Isc=10 A Power P = 400 W EMF V = 126 V

Q: 52 13 j2 12 ww 5:1 50 20 V 20 V1 For the circuit shown, the value of the primary side of the ideal…

Q: Current Transformer is used to step down the current of power system. Select one: True O False

A: current transformer is used to step down the current of power system.

Q: A 15hp full load induction motor (1hp=745.7W) operates at 480V, 60Hz and a delayed 0.7 power factor.…

Q: Find the Thévenin impedance seen looking into the terminals a,b ofthe circuit if the frequency of…

A: By using Thevenin's theorem Thevenin impedance is to find across terminal a,b is as follows;

Q: TWO transformers A and B are connected in parallel to a load of (2+j1.5) ohm. Their impedances in…

Q: A 100 KVA transformer has 3 kW iron loss and 4 kW copper loss at full load. Find out efficiency at…

Q: 2: A a full- load TOKVA distribution transformer has e fficiency at 0.85 p-f a 95% then beiny the…

A: The data given in the question are: The iron loss is fixed while copper loss keeps on varying…

Q: The transformer shown in Figure has severalsets of windings on the secondary side. The windingshave…

A: The ratio of each transformer is given. Hence, find the voltage of each secondary winding.

Q: Q1: The primary of a certain transformer takes 0.7 A at a power factor of 0.5 when it is connected…

Q: 50-kVA, 13,200/480-V distributed transformer, the no-load current will be around Select one: O a.…

A: No loade current is always (0-5%) ofRated currentif transformer iscase1 single phaseH.V…

Q: An autotransformer is used to transform from 500 to 440 V. The load is 20 kVA, at unity pf.…

Q: If the mesh current 12 = 0.827117.17° A, the supply curent l=1.2L45° A, and R=2.2 0, for the…

A: To find the power factor of current source in the given circuit

Q: A)The primary and secondary windings of a 500 kVA transformer have resistances of 0.42 2 and 0.0019…

A: Note: As per our guidelines, we are supposed to answer only one question. Kindly repost the other…

Q: Problem #4) Given the following circuit that contains two identical ideal transformers, determine…

A: Given: Is=20∠0° and the circuit diagram is:

Q: Q44. The overall power factor of the loads on the 6kV plant is: (a) 0.885 lag (b) 0.925 lag (c)…

A: The 3-phase device is a cost-effective way of bulk power transmission over lengthy distances and for…

Q: A 6 pulse thyristor converter is connected to the main through a transformer of 6% reactance. If the…

Q: 2.b. Find the unknown currents in the circuits shown below. 14 15A 20A 50 A 13 120A 15 F 40 A

A: we need to find out unknown currents in the given figure.

Q: Q2: A 1OKVA distribution transformer has full.load efficiency at o-85 p-f of 95% theca ppe and an…

A: All-day efficiency or energy efficiency: Power transformers are connected after generating station…

Q: An alternating voltage Vp is applied to the primary coil of a step-up transformer having N turns on…

Q: A difference between Transmission Substation (TS) and Power Plant Substation (PPS) is that TS has a…

A: Need to find true false

Q: An autotransformer is used to transform from 500 to 440V. The load is 20kW, at unity pf. Neglecting…

Q: You are to design a simple power supply made up of recycled electrical parts to drive a motor. To…

A: 1. The motor has a rating of 20 V and 100mA So rating of Resistor will be…

Q: We can apply lamination to the primary winding of transformers to reduce the cross section of the…

A: In this question, Choose the correct option The given Statment is true or false?

Q: A 6 KVA step-up transformer having a turns ratio of 1: 4 has a primary voltage of 1000V.calculate…

A: Given, A step-up transformer has, Rated KVA, S=6 kVA. Turns ratio N1N2=14. Primary voltage, V1=1000…

Q: A 15 kVA, 600/120 V, 0.95 efficient conventional transformer is from a 720 V source to a 600 V load…

A: Since you have posted a question with multiple sub-parts, we will first three subparts for you. To…

Q: AMohetone on ng uestion A transformer has 197 turms on the primary coll and 530 tums on the…

A: We need to find out current on secondary side of transformer .

Q: Approximate solution time is 5 minutes. A transformer supplies power to a feeder that has five…

A: Given a transformer supplies power to a feeder that has a 5 consumers. Daily maximum demands for…

Q: A single-phase transformer used for street lighting(high-pressure sodium discharge lamps) converts 6…

A: (a) The given single-phase transformer is step down transformer as the output voltage at the…

Q: Q3) A (480/4800) V, 10 kVA transformer has a series equivalent impedance in per-unit as (0.0087+1…

Q: A 500 MVA synchronous machine has H, = 5.6 MJ/MVA and a 1200 MVA machine has H₂ = 2.0 MJ/MVA. The…

Q: QUESTION 4 A real transformer has 1500 turns on the primary and 2000 turns on the secondary. Rp =…

Q: The figure below shows the equivalent circuit of a 15 kVA 2300 / 236 V transformer referred to the…

Q: A distribution transformer has 10 residential customers connected to it. Connected load is 10 kW per…

A: Given : connected load = 10 kw /house Demand factor = 0.7

Q: A factory is fed from a transformer rated 450KVA, the peak demand power is 350KW and the power…

Q: 7.5Kva distribution transformer operates as follows: full load and unity pf for 1.5hrs; half loaf…

A: The solution is given below

Q: 6 A transformer has 689 primary turns connected to a 1668 V supply. Choose the number of secondary…

Q: Answer by true or false True False Power transformers are designed to have maximum efficiency nearly…

A: “Since you have asked multiple questions, we will solve the first question for you. If you want any…

Q: The O.C of a 5 kVA 200/400 V transformer. In the test, 72 W of power was used, supplying 200 V to…

Q: b) A lk resistance is connected across the secondary winding of a 200V/400V transformer with the…

Q: You are to design a simple power supply made up of recycled electrical parts to drive a motor. To…

A: Parts of a Power supplyA typical Power supply unit consists of the following.…

Q: What is the average reactive power for total monthly consumed reactive power 120,583Kvarh Select…

A: you have given two questions, i will try to answer two questions. no.of hours in a month = 30* 24…

Q: 2.Fringing effect is a phenomena occurs in. (a)Transformers. (bElectrical field. (e)Air gap (d)All…

A: As per the guidelines of Bartley we supposed to answer first three questions for MCQ type questions.

Q: 9. To transformers A and B are connected in parallel to supply a load having an impedance of (2 +…

Q: A 16 Q resistance is connected across the secondary winding of a single-phase power transformer…

Q: 1. Vertical wind turbines have the highest Betz coefficient T F 2. Wind power is attractive because…

A: 1. Berts coeficient is defined as the ratio of the enerfy which is usefull and the energy which is…

Q: The load power obtained in a chopper circuit having a supply power of 2788 W and efficiency of 65 %…

A: Given that Supply power Ps = 2788w Efficiency = 65% Load power or out put power PL =

Q: A 5KVA ideal transformer supplied with 120V RMS and connected to a 1kQ load draws 2A RMS of current…

Question

A 6 pole DC wave wound generator has 26 armature conductors with flux per pole is 21 mWb and the e.m.f generated is
63 V, then the speed of the machine is
O 6.55 rps
O 0.66 rps
O 38.46 rps
O 115.38 rps
The Auto transformers are used to provide a variable voltage output
Select one:
O True
O MEEZ11ON-Electrical
O False

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

A three-winding transformer is connected to an AC voltage source as shown in the figure. The number of turns is as follows: N₁ = 100, N₂ = 50, N3 = 50. If the magnetizing current is neglected, and the currents in two windings on secondary side are 2230° and 22150°, then what is the value of the primary current in Ampere? I 0000000000- N₁ № ₂ Z 00000 00000 Z N3 H I₁₂ I₁₂₁ ¹3
A 4 pole dc generator with duplex wave winding has 48 slots and four elements per slot. The flux perpole is 2.5 x 10 Maxwells and the speed of the prime mover is 30 rpm. What is the average generatedarmature voltage? Neglecting brush drop.
A 6 pole DC wave wound generator has 21 armature conductors with flux per pole is 29 mWb and the e.m.f generated is 73 V, then the speed of the machine is O 3.31 rps O 119.87 rps O 0.33 rps O 39.96 rps
A 6 pole DC lap wound generator has 38 armature conductors with flux per pole is 42 mWb and the e.m.f generated is 78 V, then the speed of the machine is 48.87 rps O 3.87 rps O 0.39 rps O 48.87 rps When the load on a series generator is decreased, then the flux produced will be increased. Select one: O True O False
A 6 pole DC lap wound generator has 41 armature conductors with flux per pole is 23 mWb and the e.m.f generated is 80 V, then the speed of the machine is O 0.74 rps O 84.84 rps O 7.43 rps 84.84 rps
AC Machinery Fundamentals A three-phase delta-connected six-pole winding is installed in 36 slots on a stator. There are 150 turns of wire in each slot of the windings. All coils in each phase are connected in series. The flux per pole in the machine is 0.060 Wb, and the speed of rotation of the magnetic field is 1000 r/min. What are the resulting phase and terminal voltages?
An ideal dc generator has regulation of 40% 20% O 30% Zero
A DC generator with 8 pole, duplex lap winding excited with a flux of 3mWb/ pole. The number of parallel path in the winding is A 12 B 8 C 16 D 4
The net cross section of a transformer is 20 square inches. The maximum fluxdensity is 11 kilogausses. The frequency is 60 Hz. If there are 1,000 turns in theprimary, determine the primary induced emf.
Q- In a DC generator, what will be change in emf induced if flux is reduced by 20% and the speed is increased by 20%.
A single phase 60 Hz transformer has its core volume of 1.5x10-3 cu m. The maximum flux density is 1.0 tesla and the hysteresis constant of the core is 6000. find the hysteresis loss.
A 4-pole DC generator runs at 650 rpm and generates an EMF of 200 V. The armature is wave wound and has 750 conductors. If the total flux from each pole is 0.015 wb, then what is the leakage coefficient ?