TOPIC: STABILITY   Subject to a step input, the voltage drop across the resistor took 696.3103us to reach 13% of its steady value from rest. Determine the time (ms) needed to reach 90% of its steady value from 10% Determine the time (ms) needed to reach 80% of its steady value from 20%

Q: 1. To minimize the effect of the feedback circuit loading in oscillation frequency we we..........…

A: Since there are 4 different questions, as per the guidelines, in the following section, the first…

Q: b. Choose the suitable choice for nine of the following sentences. 1. In order to tune a parallel…

A: Since you have posted a question with multiple sub-parts, we will solve the first three sub-parts…

Q: 1. A 3-phase, 115-volt induction motor has the following constants: R₂ = 0.07 ; R₂ = 0.08 №, X₁ =…

A: Induction motor:- It is also called asynchronous motor, because not operate in synchronous speed.…

Q: What does the MOSFET characteristic VGS(th) refer to? The maximum threshold for the O Gate/Source…

A: We need to select correct option for given statement.

Q: In a circuit that composed of a single diode that connects an AC source to a load. the diode acts as…

A: Diode only conducts in forward biase Direct. When Anode of diode is connected to postive terminal…

Q: The divergence of a vector D for rectangular coordinate is equal to [1/p a/ap (pDp)] + [1/p Dø/dø] +…

A: Ans :( false)  Rectangular co-ordinate system means Cartesian coordinate system .

Q: a. The output voltages Vo, V₁, and V₁. b. Sketch the input signal (V₁), and output signals (Vo, V2,…

A:

Q: Clipping Circuits is vertically shifted of the output signal when a positive DC component applied to…

A: We need to tell about whether the given statement are true or false

Q: Solve for the base current if collector current is 600 mA and the current gain is 20.

A: Given  Collector current is 600 mA Current gain is 20.

Q: The corrected instrument readings obtained from open and short-circuit test on 10- kVA, 450/120-v,…

A: The expression for efficiency is expressed as, Efiiciency, %η = outputoutput + losses   Thus, the…

Q: What is the ac current flowing in the circuit shown below? 12 v 1.5kHz 0.1 μF

A:

Q: A) Two 1-phase transformers with equal turn ratio have impedances of (0.5 + j3) and (0.6+j10) with…

A: The parallel configuration of transformer in s distribution system or load driving application helps…

Q: 30 V 3 Ω www 6Ω 8 Ω ww 20 252 4 Ω ww (16A 16 Α

A:

Q: A combinational circuit with three inputs (A, B and C) generates the 2’s complement of the input…

A: The required logic circuit can be designed by using the given condition and the reduced Boolean…

Q: Determine the Nyquist interval and Nyquist rate of: x (t) = sin² (100лt) + cos (300m) 12:26 PM

A:

Q: In this circuit and graph, there are three different load lines plotted, representing three…

A: We need select correct option for given circuit

Q: Calculate the inductance of L4 in the Owen bridge circuit shown below. Given that R2 = 20 92, R3 =…

A: As per our guidelines we are supposed to answer only one question at a time. Please repost the other…

Q: CMOS stands for A) Common Metal Oxide Semiconductor B) Common Mono Oxide Semiconductor C) Common…

A: Given CMOS

Q: Given the characteristic equation of the denominator below, what is the damped frequency (od) of the…

A: Given, Transfer function, Gs=25s2+3s+25

Q: 51. Four resistances each of value 42 are connected as shown in Fig. 2.36. The equivalent resistance…

A: Given circuit,

Q: The unbalanced A-load of Fig. 6 is supplied by balanced voltages of 200 V in the positive equence.…

A:

Q: For the source-follower of Fig. 5.22, IDSS = 16 mA, Vp = -4 V, RG = 1 MW, Rs = 2.2 kW, VDD = +9 V…

A:

Q: For the circuit below, what will be the output voltage if the input is V₁ = 0.2 V? 470 ΚΩ W RF 2.4…

A:

Q: ou are designing an FIR filter based on a window function. What is the purpose of the window…

A: By using an window method an FIR filter (finite impulse response) can be designed from a IIR…

Q: 2. The load on a 250-V supply system is: 12 A at 0.8 power factor lagging; 10 A at 0.5 power factor…

A:

Q: The dot product of two vectors has its maximum magnitude at angle = 0. O True O False

A: ans:(true) since dot product of two vectors = A *B *cos(θ) --------(1) where, A , B magnitude of two…

Q: The finite sheet 0<x< 1, 0<y<1 on the z = 0 plane has a charge density Ps= xy(x2 + y2 +25) 3/2…

A: Electric field: It is a region around a charged particle in this region a charged particle feels a…

Q: 3. Bandwidth efficiency is the ratio of the transmission bit rate to the minimum bandwidth required…

A:

Q: Problem: For the Scope square voltage waveform the 'time/div' (or time base control) switch is on…

A:

Q: Example: X1 X₂ A X3 Fine the transfer function for this system O - 0 1 O 2 10 ÅRHY 1 3 of y = [1 o

A:

Q: For the oscilloscope display of a pulse waveform shown the 'time/div' or H, switch is on 50 ms/div…

A:

Q: Develop a low pass RC filter to attenuate 600 kHz noise by 95%. Specify the critical frequency,…

A: A low pass filter allows only lower range signals to pass through and rejects the higher frequency…

Q: The resistance of a wire with length of 6.7 mile and diameter of 0.5 in and conductivity of 3.20 S/m…

A: Given data, Length of wire = 6.7 mile, But 1 mile = 1609 meters. Length of wire = 6.7*1609 meters.…

Q: A photovoltaic system is being considered for a building with a load of 8 kW. The PV system will be…

A: PV array refers to photovoltaic array it is large number of PV cells connected together. They…

Q: 1. For a system with FM modulation, the amplitude of the unmodulated carrier is 12Vp, if the…

A: Given, FM modulation signal has Amplitude of unmodulated carrier is  Ac = 12Vp Modulated index(β) =…

Q: Define Electrical engineering

A: Electrical engineering: This branch of engineering deals with the technology of electricity.…

Q: What does the MOSFET characteristic VGS(th) refer to? The maximum threshold for the O Gate/Source…

A: About MOSFET Characteristics

Q: ry to find transfer function C(s)/R(s) of the system shown below. R(S)

A: The above question is based on finding transfer function using block reduction technique. Transfer…

Q: In stepper motor, the number of digital pulses required to obtain one complete revolution with a…

A:

Q: Convert the given table into a logic diagram. Upload a photo of your output showing your solution.…

A: 2421 code is the Aiken code it is the complementary BCD code. In this Aiken code the four bits are…

Q: Design a buck converter such that the output voltage is 28V when the input is 48V. The load is…

A: A buck converter is a step down converter it is a DC-DC converter, it is used for stepping down…

Q: Given an LTI  system with the transfer function H(jΩ)= e-jΩ (2+2cosΩ), the input signal…

A:

Q: A charge QA= -20 µc is located at A (-6, 4, 7), and a charge QB= 50 µc is located at B (5, 8, -2) in…

A:

Q: The conductor has a large energy gap? O True O False

A: Given  The conductor has a large energy gap.

Q: A) Prove that the induced EMF in the primary and secondary windings of the transformer (E1 & E2) are…

A: “Since you have asked multiple questions, we will solve the first question for you. If you want any…

Q: f the USART asynchronous transmitter is enabled and it takes 0.5x10s to transmit one frame, then…

A: For transmitting one frame the time taken is 0.5 ms. The baud rate is,  Baud rate=1tt=0.5×10-3 sBaud…

Q: 12. The full-wave controlled bridge rectifier of Figure 3 has an AC input of 120 Vrms at 60 Hz and a…

A: Given circuit is shown below. given that 1φ full wave controlled bridge rectifier Vrms=120Vf=60Hz…

Q: The integral of the normal component of any vector field over a closed surface is equal to the…

A: Given  The integral of the normal component of any vector field over a closed surface is equal to…

Q: Clamping cut down the certain part of the input wave. True False Explain if True or False R…

A: For the above given statements we need to find their correctness whether they are true or false with…

Q: A new bizarre coffee machine has two LED lights, RED and GREEN which light up based on certain…

A: The simplified output expression can be obtained by using the truth table and k-map. The truth table…

Current Division Method

The generalized current divider formula is given by the following relation below,