Three sample, X (neutral), Y (basic), and Z (acidic), were mixed and dissolved together in dichloromethane. Propose a method to separate all given sample individually using the combination of liquid-liquid extraction, crystallization, distillation, and sublimation technique.

Three sample, X (neutral), Y (basic), and Z (acidic), were mixed and dissolved together in dichloromethane. Propose a method to separate all given sample individually using the combination of liquid-liquid extraction, crystallization, distillation, and sublimation technique.

Macroscale and Microscale Organic Experiments

7th Edition

ISBN:9781305577190

Author:Kenneth L. Williamson, Katherine M. Masters

Publisher:Kenneth L. Williamson, Katherine M. Masters

Chapter4: Recrystallization

Section: Chapter Questions

Problem 1Q

See similar textbooks

Related questions

Q: A thin-layer chromatography (TLC) experiment was run using three compounds: benzophenone,…

A: on doing A thin-layer chromatography (TLC) experiment was run using three compounds: benzophenone,…

Q: Why was gravity filtration used instead of evaporation to isolate the calcium carbonate?

A: Calcium Carbonate is white, odorless powder or colorless crystals. Practically insoluble in water.…

Q: After extracting NaOH two times from ether, does the amount of precipitate after adding HCl in both…

A: The acid impurity is removed from the ether (organic layer) using NaOH which converts the insoluble…

Q: Which of the following best describes the goal of an extraction procedure? a. the isolation of a…

A: We use various techniques to separate a compound or molecules from the mixture.

Q: A student was performing an acid-base extraction of a mixture of three compounds. The three…

A: The solution is as follows:

Q: Propose an experimental design on the separation of components of the mixture of o-nitrophenol and…

Q: Give the rationale behind major steps in the analysis such as blending, filtration, heating of the…

A: We need to give the rationale behind major steps in the analysis.

Q: You were given a mixture of two miscible solvent A and B that you are tasked to separate. You know…

A: The mixture consist of two miscible solvent A and B which has different boiling points. Hence, the…

Q: Which of these could not be used in an extraction with water? Explain why you chose these…

Q: Draw the synthesis setup for Ni(dppf)Cl2, make sure to include the round-bottom flask, reflux…

A: Since you have asked multiple question, we will solve the first question for you. If you want any…

Q: Prepare a written copy of the complete separation scheme for a solution that contains Ag+, Fe3+,…

A: At first Hcl is added,and Agcl precipitate formed and Ag+Separated. Then the cation solution treated…

Q: If 15 mL of dichloromethane was used at one time for extraction, will the amount of the substance…

Q: A flavor chemist attempted to isolate and identify the major flavor component of a recently…

A: Given information: Compound 1 has a smaller Rf value (0.2) than compound 2 with Rf value 0.6.

Q: Give a detailed procedure of how you will process 5 samples of palm oil adulterated with Sudan IV…

A: The adulteration of palm oil with many fat-soluble azo dyes that is difficult to separate from the…

Q: Write a flow diagram Prepare a written copy of the complete separation scheme for a solution that…

A: The complete separation scheme for a solution that contains Ag+, Fe3+, Cr3+, Ni2+, Zn2+and Ba2+ is…

Q: Given 60.00 g of the compound in 60.00 mL water. Calculate amount extracted using multiple (2 x…

A: Concept- In a multiple extraction procedure, a quantity of solvent is used to extract one layer…

Q: Propose a suitable process flow sheet in accordance with the required equipment (such as smelter,…

A: Solution: We know nylon 6 is prepared from caprolactam by ring opening reaction. Therefore, it is…

Q: Describe the basis of operation of the following separation methods. i. Precipitation ii.…

A: Precipitation, distillation, extraction all are methods to separate components from it's mixture.…

Q: Which of the following could DECREASE the amount of the recovered crystals in the purification by…

Q: Using the end-group analysis to find molecular weight, 6 mol of 1,4-butanediamine reacted with 6 mol…

A: The polymer formed from the given monomers: H2N-(CH2)4-NHOC-(CH2)4-COOH

Q: 0.56 g 1,4‐dimethoxybenzene, 0.9 mL 2‐chloro‐2‐methylpropane, 5 mL nitrobenzene and 0.52 g graphite…

A: The given problem is related to green chemistry. Given: Reactants- Mass of 1,4‐dimethoxybenzene-…

Q: With your knowledge on analytical separation and analyses, outline a suitable analytical separation…

Q: A mixture contain benzoic acid, salt, powdered silica (white sand) and contaminated with coloring.…

A: Benzoic acid is soluble in organic solvents like ethyl acetate. When the mixture is treated with…

Q: In what situation will the Standard-Addition method be an appropriate calibration approach?

Q: Many ink dyes can be separated by the technique of___________ chromatography

A: Thin Layer Chromatography is a method for separating non-volatile substances. The separation…

Q: Why is the mixture extracted with sodium bicarbonate? Give an equation and explain its relevance.

A: Extraction is a chemical technique used for the separation of a substance from a matrix. The three…

Q: Give 5 techniques that will ensure successful purification of an organic compound by…

A: The process of Recrystallisation is used to purify a compound by removing any impurities present in…

Q: Draw an extraction flow chart for the extraction of a mixture of organic acid and phenol.

A: In this question we have been provided with a mixture of Organic acid and phenol, now we need to…

Q: A flavor chemist attempted to isolate and identify the major flavor component of a recently…

A: Given information: The isolated compound was dissolved in ethyl acetate and first extracted with 0.1…

Q: What parameters should be considered when choosing between distillation methods? Are there any…

A: Distillation is refining method of refining by alternating evaporation and condensation to remove…

Q: 6.0 mL of cyclohexanol, 8 mL of 85% phosphoric acid, and 10 drops of sulfuric acid are added to a…

A: The percentage yield can be calculated by the formula = Actual yield x 100 /theoretical yield

Q: Nitroethylene, H,C-CHNO, is a sensitive compound that must be prepared with great care. Atempted…

Q: Why is distillation of cyclohexanol using acid catalyst phosphoric acid a better technique to purofy…

A: The reaction of cyclohexanol using acid catalyst phosphoric acid is directed in a distillation…

Q: Prepare a written copy of the complete separation scheme for a solution that contains Ag+, Fe3+,…

Q: A pure white crystalline compound was found to melt at 131.5-132.0°C when taken on a melting point…

A: A question based on introduction to chemistry that is to be accomplished.

Q: In a Grignard reaction, 1.4555 g phenyl bromide, 10. g carbon dioxide, 0.5734 g magnesium filings,…

A: Given- 1.4555 g = phenyl bromide 10. g = carbon dioxide 0.5734 g = magnesium filings 30.2 mL of 6M…

Q: If 80% of a desired compound is extracted into the organic phase in each step (leaving 20% in the…

A: Given : 80 % of the desired compound gets extracted in each extraction leaving 20 % in the aqueous…

Q: 105 100 75 0 1 2 3 4 5 67 89 10 11 12 13 14 15 16 17 18 19 20 Volume distillate collected (mL) 1.…

A: A question based on analytical separations that is to be accomplished.

Q: In order to carry out a highly accurate determination, usually of a valuable constituent in a…

A: The researchers or chemist always doing research on the basis of qualitative or quantitative…

Q: For each of the following statements, answer True or False and explain your answer briefly. It is…

A: Color test and micro-crystalline test are used to find the drug present in the system. Different…

Q: Arrange the following compounds in order of decreasing ease of elution from a column of silica gel

A: Silica gel acts as a stationary phase in silica gel chromatography column and it retains the polar…

Q: Under what conditions can a good separation be achieved with a simple distillation?

A: Simple distillation is a method of separating two compounds from a mixture on the basis of their…

Q: What process is required to purify the ethanol from the fermented broth? Extraction Distillation…

Q: involved Deasphalting, Visbreaking, Hydrocracking, Fluid Coking, Production of high-quality gasoline…

Q: Why is the reaction mixture extracted with sodium bicarbonate? Give an equation and explain its…

Q: Based on the resulting chromatograms after visualization with iodine vapor, which between the…

A: A question based on purification, which is to be accomplished.

Q: Explain the possible behaviour and extractability of these compounds using sample extraction…

A: "Since there are multiple sub-parts in this question and it is not mentioned that which one has to…

Question

Three sample, X (neutral), Y (basic), and Z (acidic), were mixed and dissolved
together in dichloromethane. Propose a method to separate all given sample
individually using the combination of liquid-liquid extraction, crystallization,
distillation, and sublimation technique.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 1 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, chemistry and related others by exploring similar questions and additional content below.

Similar questions

An organic chemistry laboratory Extraction; the extraction of crude naphtalene- benzoic acid mixture. Naphthalene is a suspect carcinogen and is toxic to aquatic life. Find an alternative pair of molecules that adhere better to the principles of green chemistry and can be separated by extraction using green' solvents. (kindly answer fully)
prepare a flow sheet for the preparation of benzoic acid from a) bromobenzene and magnesium and b) phenylmagnesium bromide and carbon dioxide. using your knowledge of the physical properties of the solvents, reactants, and products, show how the products can be purified, indicate which layer should contain the product in the liquid/liquid extraction steps.
Discuss the “green” implications of using dichloromethane (methylene chloride) as your primary extraction solvent. Consider its hazards and toxicities, process for manufacture, cost, efficiency of extraction, ease of recovery and reuse, and cost of waste disposal.
After a crude product is dissolved in 1.5 mL of hot solvent, the resulting solution is dark brown. Because the pure compound is reported in the literature to be colorless, it is necessary to perform a decolorizing procedure. Should you use pelletized Norit or powdered activated charcoal to decolorize the solution? Explain your answer.
Why is the reaction mixture extracted with sodium bicarbonate? Give an equation and explain its relevance.
8.For end-group analysis, 0.8632 g of a carboxyl terminated polybutadiene (CTPB) sample dissolved in 1:3 mixture of ethanol and toluene consumed 5.2 ml of 0.1240 N alcoholic potassium hydroxide solution in titration using phenolphthalein as the indicator. Calculate the molar mass of the polymer.
10. For each of the following mixtures, suggest a separation technique and explain a basis for your choice: (a) Acetone (a volatile liquid) and benzaldehyde (b) N-Ethylpentanamine, butanamide and phenol. Explain.
Compound 48 is a low-melting solid (melting point 55-57 °C), that is soluble in dilute aqueous base, but precipitates on acidification. The Mass, IR, and 'H NMR spectra, along with 13C NMR data, are given below. Elemental Analysis: C, 67.73; H, 6.5o; O, 25.78.
Explain and describe iodination of benzene using cupric chloride.
During recrystallization, an orange solution of a compound in hot alcohol was treated with activated carbon and then filtered through fluted paper. On cooling, the filtrate gave gray crystals, although the compound was reported to be colorless. Explain why the crystals were gray and describe steps that you would take to obtain a colorless product.
The purpose of this experiment is to use both extraction and crystallization techniques to separate a solid mixture of organic compounds. You will receive a packet with 1 g of a unknown (pH is basic) amide solid sample which will contain three components, one from each group: Group 1 (~50% wt): ethyl 4-aminobenzoate, ortho-toluic acid, or benzoic acid Group 2 (~40% wt): fluorene, 1,4-dibromobenzene, benzil, benzoin Group 3 (~10% wt): fluorene, 1,4-dibromobenzene, benzil, benzoin (but not the same as Group 2 compound) Create a lab procedure that will allow you to successfully isolate, purify, and identify the two major (Group 1 and Group 2) components of the unknown amide sample. reagents that can be used are 1M HCl, 6M HCl, 1M NaOH, 6M NaOH, diethyl ether, and methylene chloride
A student was performing an acid-base extraction of a mixture of three compounds. The three compounds in the mixture are shown below. The mixture was extracted wilth 6 M HCI three times. The combined extractions were put into a flask marked A, which was treated with 1 M NAOH till it turned basic. This was then evaporated to obtain a crystal, which we label A. The remaining mixture was extracted with 6 M NaOH three times. The combined extractions were put into a flask marked A, which was treated with 1 M HCI till it turned acidic. This was then evaporaled to obtain a crystal, which we label B. The remaining mixture was evaporated to obtain a crystal, which we label C. The identity of A is Select] The identity of B is (Select) The identity of Cis Select] OH NH2 3