Answered: Three resistance 14. 5 Q, 25.5 Q and 60…

Three resistance 14. 5 Q, 25.5 Q and 60 Q are connected in series across 200 V. What will be the voltage drop across 14. 5 Q (a) 29 V (b) 13. 5 V (c) 14 V (d) 18 V

Electricity for Refrigeration, Heating, and Air Conditioning (MindTap Course List)

10th Edition

ISBN:9781337399128

Author:Russell E. Smith

Publisher:Russell E. Smith

Chapter5: Components, Symbols, And Circuitry Of Air-conditioning Wiring Diagrams

Section: Chapter Questions

Problem 27RQ: Change the following normally open elements from the de-energized position to the energized...

See similar textbooks

Related questions

Q: voltmeter

A: Resistance in parallel- 1Req=1R1+1R2+1R3+........... Resistance in series- Req=R1+R2+R3+...........

Q: In the circuit shown in figure, when the firing angle of thyristor T is 90 degree, what is the value…

A: in the given circuit the thyristor is connected in series with the voltage source and voltmeter.

Q: 100mH inductance is connected with a 200ohms resistor in series. If the voltage is 220volts, what is…

Q: Three non-inductive resistances, each of 100 Q are connected in star across 400 V supply. Calculate…

A: for star connection , Phase current =Line current and and phase voltage = Line voltage3 and For…

Q: es a current of 2 A and dissipates 200 W when c is 3 A and the power 270 W under the same co ed when…

Q: Five batteries are connected in parallel to supply a certain load. Each battery consist od 12 cells…

A: Resistance: The power dissipation in resistive material occurs in the form of heat.

Q: Find the current in and the potential difference across each eler n the following circuit. 5.0 N 2.5…

Q: Multiple Choice. Refers to a point in a circuit where three or more wires are connected. A.…

Q: When you connect a voltmeter to read a dc voltage a. polarity is not important b. connect the…

A: In this question, We need to choose the correct options When you connect a voltmeter to read a dc…

Q: A circuit consisting of resistors and capacitors is shown inFig.-1, below.E“120.0V,R1“4.00…

A: We are authorized to answer three subparts at a time since you have not mentioned which part you are…

Q: What is the current lo in the figure if Is = 70? Is 2 A

A: Given : Note : Please note that according to the units of the other currents we have assumed the…

Q: Q6. All ICs needs input power to work D. None of the above B. VCC (+5 volt) A. Ground (0 volt) C.…

A: ICs are electronic element

Q: Two non-specified wires are connected in parallel. Using a microhmeter specific resistance of the…

A: KIRCHHOFF’S LAW KCL: The algebraic sum of all currents at a node is zero. KCL is…

Q: 4. Bus bars are either flat tubes as these shapes allow heat to or dissipate more efficiently.

A: The size of bus bar determines the amount of current flows through it safely. The heat dissipation…

Q: A solar cell can produce a voltage of 0.5 V and has a current capacity of 0.1 A. What voltage and…

A: In one bank of cells, 12 cells are connected in series and each cell generates 0.5 V voltage and 0.1…

Q: microfarad is connected in series with a 12 V Battery. Find the charge (in Coulomb) 0.4 seconds…

Q: 3. State the number of significant figures in each of the following: (a) 542, (b) 0.65, (c) 27.25,…

A: Te more the number of significant figures, the greater the precision is.

Q: Please explain the waveform of the voltage across resistor R (= 2KΩ). You can explain it by drawing…

A: Given circuit consist of transformer connected to full bridge rectifier circuit. Transformer ration…

Q: The conductance of a 923Ω resistance is a) 1.08 * 10-3 mho b) 1.08 * 10-4 mho c) 1.02 * 10-3 mho d)…

A: Given Resistance of resistor, R = 923 ohm To find conductance, G

Q: current of 1 mA and a reverse bi Ans. Rp=9.3 k2; R.=6 kM

Q: 4A 4A R2 = 30 R3 = 40 R1 = 30 E R4 R5 = 2R4

Q: what the value of RL for the zener to draw maximum power.

Q: A lead wire and an iron wire are connected in parallel. Their respective specific resistances are in…

A: In this question we will find wire ratio of area with given length , current and specific resistance…

Q: equivalent current that flow in each Loop in resistor circuits.

A: In a closed loop of a circuit- Summation of all the voltage drops is equals to zero. In a node of a…

Q: 25 V 45 V 3 k2 4 kQ d. 5 k2 Figur 5

Q: 3. Voltage Divider Circuit 4. DC Bias Voltage Feedback

Q: Determine the proper resistance value using Secant Method that will dissipate the energy at a…

A: Solution; Cosine varies between -1 and 1. cos[√(1/LC-(R/2L)²)t]=1 when t=0 or when: 1/LC-(R/2L)²=0,…

Q: Two capacitors connected in series with zero initial voltage values were connected to a circuit and…

Q: Enumerate and explain each briefly the FIVE (5) Provisions/Relationships/Descriptions of Ohm’s Law

A: The explanation is as follows.

Q: Conductors A and B are connected in parallel. Their respective specific resistances are in the ratio…

A: We need to find out cross section area ratio for given conductor

Q: The neutral point N a) star connection b) delta connection c) in both connection d) none of these

Q: In the figure below, explain in what situation ammeter A reading will be nonzero.

A: Given : In the circuit they have mentioned transformer with both primary and secondary windings.…

Q: Q4 In given figure, What is the value of resistance R in Q? R -wW- 8A + 100V 10 Ohm wW- 10 Ohm

Q: O For the voltage -divider bias confguration in Figure I, determine: 016V a) Ise b) Ice 33.9k LICQ…

Q: A resistance of 10 ohms and C=0.1F is connected in series with a 12V battery. Find the charge at any…

A: Solution !!

Q: . Resistances of 10, 12, 15, and 20 Q are connected in parallel

A: Resistance in parallel- 1/Req=1/R1+1/R2+1/R3+........... Resistance in series-…

Q: a 12 volt source with an internal resistance of 1.2 ohm is connected across a wire wire wound…

Q: H.W-I:- A platinum Coil has a resistance of 3.146 at (40 c) and 3.7670 at

A: Temperature coefficient The temperature coefficient is the relative change in the physical property…

Q: 2. A loop contains three resistors and a battery, whose voltages are 3V, -4V, and 5V, respectively.…

Q: .6 C.T. and P.T. are used for (a) measuring low current and voltages. (b) measuring very low current…

A: We need to select correct option .

Q: Q3) A lead wire and an iron wire are connected in parallel. Their respective specific resistances…

A: In this question we have to make some assumptions so that we can solve the problem easily. It is…

Q: When the voltage source is turned off in a simple circuit consists of a resistor and an inductor,…

A: Given, When the voltage source is turned off in a simple resistor and inductor (RL) circuit, the…

Q: O The LEDS do not light up. There is a potential difference across R1 and R2, so current flows…

Q: A 15kO NTC thermistor has a B value of 3450 between the temperature range of 30°C and 110°C. Its…

Q: Write down the steps on how to Series Resistors Voltage Division

Q: Three resistance 5Neach are connected in sta Values of equivalent delta resistances are (a) 1.5 Q…

A: According to the question we have to find the delta resistance.

Q: The voltage with the following waveform is applied across a 5.00 micro Farad capacitor, what is the…

Q: 120 V source is applied across three equal resistances in series. How much is each IR drop?

Q: Discuss the different methods of measuring high d.c. voltages. What are the limitations in each…

A: Here different methods of measuring high dc voltage is discussed-

Q: Assume that switch SW2 has been in position 1 long enough to completely charge switch to position 2.…

A: In this question we will find voltage across inductor......

Question

Three resistance 14. 5 Q, 25. 5 Q and 60 Q are
connected in series across 200 V. What will be the
voltage drop across 14. 5 Q
(a) 29 V
(b) 13. 5 V
(c) 14 V
(d) 18 V

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step 3

VIEW

Step by step

Solved in 3 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

Change the following normally open elements from the de-energized position to the energized position.
Charging: A 0.2 F capacitor and a 80092 resistor are connected in series with a battery of voltage 10 volts as shown in the figure. E Answer questions 1-5 www R Tim Atte ON
Given the following Resistances and Capacitors in Series and Voltage Source: R1 - 7 ohms R2 = 4 ohms C1 = 0.157 Farad C2 = 0.01 Farad Vs = 10,382 Volts Frequency = 86 Hz What is the Amplitude of the voltage across C1?
Determine the loop currents Ia, I,, and Ic. 100 Ic 100 100 100 100 Ib 55V 100 V la
Plz complete solution with 100% accuracy Plz show complete work I vill give 5 upvotes
Q4. Find the value of C₁ in the figure below 5 V rms C₁ 4 mA C₂ 0.0022 μF C3 0.0015 με Xc₂ = 750 02
in an emf the internal resistance has a voltage equal to the voltage drop which is equal to the emf voltage less the terminal voltage.
A 50 hz. current of 2 A flows in a circuit consisting of an adjustable resistor and a 56.6 uF capacitor in series. Determine the value to which resistor should be adjusted for the voltage across the capacitor to be 0.75 the voltage across the circuit.
The peak-to-peak alternating potential difference across a 150 2 resistor is 339 V. The r.m.s. current in the resistor is?
Series circuit resistance
If a circuit has a resistance of 3002 and a series inductance of 5002, what is the relationship between the applied circuit voltage and the circuit current? The applied voltage lags the circuit current. The phase shift between the circuit voltage and current changes with time. The applied voltage is in phase with the circuit current. The applied voltage leads the circuit cur Previous Page Next Page Page 2 of 10
The potential difference is measured in .volt True O False O