The maximum instantaneous voltage and

Q: Determine the resistance and conductance of 20m of copper wire 2mm in diameter. S=8^-10*1.72=…

A: Given : Length of wire=20m , diameter=2mm or radius =1mm or 1x10^-3 m resistivity=1.72 x 10^-8 ohm…

Q: HW: (a) Design a CMOS logic circuit that implements the logic function. f(A,B,C) = A + BC

A: Since you have posted multiple questions, we will solve the first question for you. If you require…

Q: A four-pole, DC generator with lap winding has 48 slots and 4 elements per slot. How many coils does…

A: Given data, The number of poles=4 The number of slots =48 The elements per slot =4

Q: Q1. For the system shown in Figure (1) E. R(a) C( K₁ 2+1 D(a) Figure (1) Design the values of K, and…

A: A block diagram of closed-loop control system is given in the question. The steady state error due…

Q: 5.5 V 6.0 Ω 8.5 Ω Ω 12 V 13 Ω

A: Given circuit: Assuming, we have to find current through the circuit

Q: The minimum sum-of- products for the following function isF(A,B,C,D,E)=[m(0,1,15,16,17 )…

A: The quine-McCluskey tabular technique is a tabular approach based on the prime implicants notion. A…

Q: Determine current in 5 ohm resistor by any one method

A:

Q: The charge of an electron is -1.60 x 10-19 C. A current of 3.5 A flows in a wire carried by…

A: Given that I= 3.5A Charge of electron = 1.60*10-19c T= 1sec

Q: ✔ Find il and i 2

A: The required parameters can be calculated by using the mesh analysis. The mesh equation can be…

Q: write true or false in the following sentences :. 1-Two quadrant operation of de motor can be…

A: Step down chopper: Chopper is used to convert the DC input to the DC output. In the step-down…

Q: 2.51 Determine and sketch the impulse response of the following systems for n = 0, 1,...,9. अधि y(i)…

A: Given data, n=0,1,2,,3..........9

Q: The arms of the Maxwell's bridge are arranged for balanced condition as follows: R2-60092, R4-40022;…

A:

Q: For an air-cored transformer with Lp = 100 mH and Ls = 50 mH what is the mutual inductance (M = ?)…

A: Given, For an air-cored transformer with, Primary inductance, Lp=100 mH Secondary inductance, Ls=50…

Q: What is the importance of modulation and demodulation in FM? thanks

A:

Q: Good day! Question: How FM wave can be converted into PM wave? Thanks!

A:

Q: The synchronous generator will have its voltage and frequency depend on O Field current and speed. O…

A:

Q: A single-phase, 100-kVA, 2000-V/200-V, 50-Hz transformer has impedance drop of 10 % and resistance…

A: Transformer is the static device. It transfer the electric energy from one terminal to another…

Q: E₁ + 12 V 4 R₁ w 100 st R₂ w 100 * Find Vab in fig R₁ Ey w 5002 -6 V R₁ w 300

A: given here a electrical circuit and asked to find the volatge Vab .

Q: Calculate the resistance of wire Given data - Length = 150 m Cross sectional area = 0.2 mm²…

A: Given, Length, l = 150 m Cross sectional area, A = 0.2 mm2 Resistivity, ρ=50×10-8 Ω.m

Q: Find the values of R and Vs in fig

A:

Q: The drain current in a p-channel E-MOSFET with V GS(th) -3V at V=0 is GS Select one: a. maximum

A: Given a p-channel E-MOSFET with, VGSth=-3 V At, VGS=0 The drain current, ID=?

Q: Class C commutation technique is forced commutation technique O voltage commutation technique…

A:

Q: Q.9 Find the transfer function given below: G₁ X(s)- H G₂ Y(s) X(s) Y(s) of the system -Y(s)

A:

Q: Determine current in 5 ohm resistor by any one method lov AF 32 A 12V 4F 2012 202 13 MT 202 522 WN

A:

Q: 2s Let the Laplace transform of the signal x(t) is X(s) = 52+2 ,determine Laplace transform the…

A: We are authorized to answer three subparts at a time, since you have not mentioned which part you…

Q: 23. It is desired to operate a 100 W, 120 V lamp at its current rating from a 240 V, 50 Hz supply by…

A:

Q: Q4:- A) Series resonance Circuit, R = 156 02, L = 1.26 mH, C= 2.01 µF Calculate:- 1) fr, 2) Qr, 3)…

A:

Q: Capacitor of 30-nanofarad capacitance is in series with a coil across an 8,000 cycle supply. What…

A:

Q: The output of int(5.5) is: 05.0 06.0 05 05.5

A: In this question,  We need to choose the correct options Int function give the output integer value.…

Q: 9- To remove small protrusions and thin connection from the image as below, you can use : a- Opening…

A: According to the question, we need to discuss the technique to remove small protrusions and thin…

Q: A d.c. generator running at 25 rev/s, generates an e.m.f. of 150 V. Determine the percent- age…

A: Given data, Speed,  N1=25 rev/s = 25×60=1500 RPMN2=20 rev/s=20×60 = 1200 RPM EMF of generator E1=150…

Q: A cylindrical reservoir of diameter 4ft and height 6ft is half-full of water weighing 10 lb/fe. Find…

A: Given:  Diameter = 4 ft Radius = r = 2 ft Height = h = 3 ft Displacement = d = 6 ft Density = ρ = 10…

Q: Q3// Drive fault current for single line to ground fault- asymmetrical faults.

A:

Q: use the superposition theorem to find the R3 R E₂ -lov current in R₂- E₁ 422 I 62 R₂ 352 M 432

A: Given circuit :

Q: L Determine the resistance and conductance of 20m of copper wire 2mm in diameter. ४ = 1-72 x10. M.

A:

Q: weighted-resistors type DAC.

A:

Q: Find the work done by pumping out molasses from a hemispherical tank with a radius of 4 feet when…

A: Given figure is shown below. The cross-sections are circles. we will be able to determine the cross…

Q: Q4:- A) Series resonance Circuit, R = 156 02, L = 1.26 mH, C= 2.01 µF Calculate:- 1) fr, 2) Qr, 3)…

A: In this question we will find resonating frequency , bandwidth ,quality factor for given circuit....

Q: electric circuit admittance locus has approximately the...........engineering shape of the current…

A: 1.  The admittance locus is shown below. The current locus as shown below. Hence Admittance locus…

Q: Voltage Output (Vo)

A: The diode is conducts when it is forward bias mode. In the reverse bias mode the diode  doesn't…

Q: At start the slip of an induction motor is equal to O 0.75 00 O 0.5

A: At starting the rotor speed of induction motor is zero. Nr=0 Let a induction motor with synchronous…

Q: A 15kVA, 2400/240, 60 Hz transformer has a primary winding resistance of 4 ohms and a secondary…

A:

Q: Q1: (A) Define the following. Support your answer by sketches and equations if it is necessary.…

A: 1) Shannon's sampling theorem: In order to reconstruct a one-sided signal from a sample of samples,…

Q: Question: What is the importance of Modulator and Demodulator (functions) in FM.

A: In this question we will write function of modulator and demodulator in FM....

Q: 13.42 For the ideal transformer circuit of Fig. 13.106, find Vo. 10 Ω -j50 Ω 1:4 36 120/0° V ||…

A:

Q: problem: Find transadmittance of the circail figare below. I. 4₂2=1 H H(s) = 4 = 1 H Es oooo LI. 1.…

A:

Q: How much current flows in the given circuit? R₂ R₂ 27 kn 56 kn R₁ R₂ 20 kn 47 kn 21 V 9V O 누 80 A…

A:

Q: For the circuit shown below what Z, in rectangular form draws maximum power and what is this power…

A:

Q: * F.Find the values of R and Vs in fig R ww 332 TA In R=2.1 Vs 12v R=202 Vs 12v R=2.20 Vs=11v O…

A:

Q: What are the colors used to code a 470Ω resistor?

A:

Synchronous Generator

In comparison to an asynchronous generator, it is a machine where the rotor speed is equal to the rotating magnetic field produced by the stator, i.e., mechanical speed is equal to the electrical speed, thus called synchronous, and not asynchronous.

Salient Pole Rotor

Salient pole rotor includes a large number of exposed poles mounted on a magnetic wheel. The construction of a bright pole is as shown in the image on the left. The proposed poles are made of metal laminations. The rotor winding is provided on these poles and is supported by pole shoes.