The standard addition method is used to analyze a sample of a river water for mercury. Solution A is made by pipetting 5.00 mL of undiluted sample in to a 10 ml volumetric flask and filling to the mark with DI water. Solution B is made by pipetting 5.00 mL of undiluted sample and 3.00 mL of 15.0 ppb of Hg standard into same 10.0 mL volumetric flask and filling to the mark with DI. Solution A and B are analyzed using atomic absorption spectroscopy and give a percent transmittance values of 56 % and 33 % respectively (not blank corrected). A blank has a transmittance of 96%. Which of the following technique can be used to determine the amount of mercury in the undiluted sample of river water? O A. IR spectroscopy O B. Cold vapor atomic absorption OC. Hydride generation atomic absorption O D. Electrothermal atomic absorption

The standard addition method is used to analyze a sample of a river water for mercury. Solution A is made by pipetting 5.00 mL of undiluted sample in to a 10 ml volumetric flask and filling to the mark with DI water. Solution B is made by pipetting 5.00 mL of undiluted sample and 3.00 mL of 15.0 ppb of Hg standard into same 10.0 mL volumetric flask and filling to the mark with DI. Solution A and B are analyzed using atomic absorption spectroscopy and give a percent transmittance values of 56 % and 33 % respectively (not blank corrected). A blank has a transmittance of 96%. Which of the following technique can be used to determine the amount of mercury in the undiluted sample of river water? O A. IR spectroscopy O B. Cold vapor atomic absorption OC. Hydride generation atomic absorption O D. Electrothermal atomic absorption

Chemistry

10th Edition

ISBN:9781305957404

Author:Steven S. Zumdahl, Susan A. Zumdahl, Donald J. DeCoste

Publisher:Steven S. Zumdahl, Susan A. Zumdahl, Donald J. DeCoste

Chapter4: Types Of Chemical Reactions And Solution Stoichiometry

Section: Chapter Questions

Problem 47E

See similar textbooks

Similar questions

Calcium carbonate, CaCO3, can be obtained in a very pure state. Standard solutions of calcium ion are usually prepared by dissolving calcium carbonate in acid. What mass of CaCO3 should be taken to prepare 500. mL of 0.0200 M calcium ion solution?
Distinguish between the terms slightly soluble and weak. electrolyte.
95. Many metal ions form insoluble sulfide compounds when a solution of the metal ion is treated with hydrogen sulfide gas. For example, nickel(II) precipitates nearly quantitatively as NiS when H2S gas is bubbled through a nickel ion solution. How many milliliters of gaseous H2S at STP are needed to precipitate all (he nickel ion present in 10. mL of 0.050 M NiCl2 solution?
An artificial fruit beverage contains 12.0 g of tartaric acid, H2C4H4O6, to achieve tartness. It is titrated with a basic solution that has a density of 1.045 g/cm3 and contains 5.00 mass percent KOH. What volume of the basic solution is required? (One mole of tartaric acid reacts with two moles of hydroxide ion.)
Nickel(II) formate [Ni(HCO2)2] is widely used as a catalyst precursor and to make metallic nickel. It can be prepared in the general chemistry laboratory by treating nickel(II) acetate with formic acid (HCO2H). Ni(CH3CO2)2(aq) + 2 HCO2H(aq) Ni(HCO2)2(aq) + 2 CH3CO2H(aq) Green crystalline Ni(HCO2)2 is precipitated after adding ethanol to the solution. (a) What is the theoretical yield of nickel(II) formate from 0.500 g of nickel(II) acetate and excess formic acid? (b) Is nickel(II) formate paramagnetic or diamagnetic? If it is paramagnetic, how many unpaired electrons would you expect? (c) If nickel(II) formate is heated to 300 C in the absence of air for 30 minutes, the salt decomposes to form pure nickel powder. What mass of nickel powder should be produced by heating 253 mg of nickel(II) formate? Are nickel atoms paramagnetic?
A 1.787 g sample containing some Fe2+ ion requires 31.50 ml of a 0.02188 M KMnO4solution to reach a pink endpoint. What is the percent by mass of Fe2+ in the sample?
o/index.html?deploymentld%=55750828934189288909969212&eiSBN=9781305657571&snapshotld%32199898&id%3... ☆ IDTAP Q Search this cou Use the References to access important values if needed for this question. The concentration of H3ASO3 in a solution is determined by titration with a 0.1945 M Ce+ solution. The balanced net ionic equation for the reaction is: 2Ce*(aq) + H3ASO3(aq) + 5H2O(1) 2Ce*(aq) + H3ASO4(aq) + 2H3O*(aq) (a) If 19.83 mL of the 0.1945 M Ce** solution are needed to react completely with 30.00 mL of the H3ASO3 solution, what is the concentration of the H3ASO3 solution? M (b) Which of the two solutions was in the buret during the titration? (c) Suppose at the end of the titration, the solution containing the Ce³* ion is transferred to a volumetric flask and diluted to 300. mL. What is the concentration of Ce3+In the diluted solution? Submit Answer 5 question attempts remaining
A mixture containing KCl and NaBr was analyzed by Mohr's method. A mass of 0.31011 g of the mixture was dissolved in 50 mL of water, the Na2CrO4 indicator was added, and it was titrated with a 0.11011 mol/L AgNO3 solution. The endpoint was 36.011 mL. What are the % m/m concentrations of KCl and NaBr in the mixture?
TITRIMETRIC DATA SAMPLE: CANE VINEGAR % acidity in label: 4.5% %purity of KHP: 99.80% FORMULA WEIGHT of KHP: 204.22 g/mol Average Molarity of NaOH: 0.09934 M ANALYSIS OF CARBONIC ACID IN A SODA SAMPLE TRIAL 1 TRIAL 2 TRIAL 3 Volume of soda, mL 20.0 20.0 20.0 Initial volume of NaOH, mL 20.20 22.05 23.93 Final volume of NaOH, mL 22.03 23.89 25.8 Molarity of carbonic acid Average molarity of carbonic acid
3:59 PM Wed Mar 15 ... ap here or pull up for additional resources Question 74 of 75 A 25.0 mL solution of HNO3 is neutralized with 16.5 mL of 0.250 M Ba(OH)2. What is the concentration of the original HNO3 solution? 1 4 7 +/- 1 M 2 3 5 6 8 9 O LTE 32% Submit XC с x 100
A sample containing BTEX What is the appropriate quantitative and qualitative analysis method for it in the laboratory?
pH vs titrant volume 12 10 8 4 10 15 20 25 30 titrant volume (mL) pH (units)