The properties of the given soil below are as follows:            Coefficient of Permeability:              k1 = 6.25 cm/hr , k2 = 5.75 cm/hr,  k3 = 4.5 cm/hr, k4 = 6.25 cm/hr, k5 = 8.15 cm/hr, k6 = 3.6 cm/hr             Thickness:   H=1.2m, H3= 0.3m, H4= 0.5m, H5=0.4m             Length:   L1=0.8m, L2= 0.7m, L3= 1.5m, L6=0.9m             Head, h= 1.8m a. Determine the total flow per meter. b. Determine the equivalent coefficient of permeability.

Q: Civil Engineering 20 FANE E(AN) 2M 6M 2M 4M 6M 2/2M 4/2M Max and min M1, T1, M2 T2 cross- sections…

A:

Q: Fill the blanks with correct answer for each of the following: 1- Select..... option under Member…

A: It has been asked to fill the blanks with appropriate answer. since as per our guideline all…

Q: Two masses each equal to m are lying on x-axis at (-a, 0) and (+a, 0) respectively, as shown in the…

A:

Q: Which among the formulas below can be used to compute the combined stress at the bottom fiber of a…

A: ASKED:  To compute the formula for combined stress at the bottom fiber of a beam subjected to axial…

Q: is there any FBD for this?

A: As expert has already solved this question and Student has asked to  draw a Free body diagram for…

Q: Determine the normal force, shear force, and bending moment at a section passing through point C .…

A:

Q: A double-row butt joint is used as a connection. It is made up of two 210mm by 12mm cover plates and…

A:

Q: A beam having a width of 350 mm and a depth of 600 mm carries a dead load of 21 kN/m (including its…

A: b=350 mmd=600-75= 525 mmwd=21 kN/mwl=30 kN/mfy=400 MPaf'c=21 MPaL=6 m

Q: Determine the linear error of closure.

A: Closing error: - If the starting and end point of traverse is not closed then the distance between…

Q: ith a PSD of 500

A: We Know Relationship between Length and Sight distance is L=AS22158  imperial unitsL>S

Q: From the the given table, determine the direct runoff if the effective rainfall during 1-hr is 5 mm…

A: solution  Given the unit hydrograph which has an effective rainfall of 1mm  and the direct runoff…

Q: Two fixed frictionless inclined planes making an angle 30° and 60° with the horizontal are shown in…

A: step 1-

Q: Problem 14-27 The conveyor belt delivers crate each of mass M to the ramp at A such that the crate's…

A: Given: M=12 kg va=2.5 m/s g=9.81 m/s2 a=3 m

Q: The influence line is for V40 = shear just left of 40'. A load of 0.6 kip/ft is placed from 10' to…

A:

Q: Q2. The compound beam shown in Fig.2. is pin supported at B and supported by rockers at Q1.…

A:

Q: Q-14: A soil has a void ratio of 0.70, degree of saturation 50% and G =2.7. Find the water content,…

A: Given:  Void ratio  Degree of saturation  Specific gravity  To find:  Water content  Porosity  Bulk…

Q: 80 k 60 k 2.4 klf B Fixed 30 ft 10 ft ' 10 ft 10 ft - 20 ft 40 ft 30 ft -

A:

Q: Identify which soil types or soil structures are important to your field of interest (civil…

A:

Q: Compute the critical effective area between staggered failure paths for the channel bar shown if the…

A:

Q: Compute the centroidal distance with respect to x- and y- axis of the figure below. I. 1.5 çm 3 cm 2…

A: Compute the centroidal distance with respect to x- and y- axis of the figure below.

Q: a. The in-situ effective vertical stress in the middle of the clay layer is psf. b. If a uniform…

A: The values and diagram given in the question are as follows: Initial groundwater depth=5 ft (below…

Q: Fluid flows past the two dimensional bar shown in figure. The pressures on the ends of the bar are…

A: Figure is as shown

Q: plot the u(t) functions for the five different loads given below under the hormonal loading effect…

A: k=4000 lb/ft = 58379.6 N/mm=4 lb-sec2/ft=4 (32.174) =128.696 lb =58.375 kgζ=0.05Fo=200…

Q: Two fixed frictionless inclined planes making an angle 30° and 60° with the horizontal are shown in…

A:

Q: 500ft vertical curve has PVI elevation 240.31ft. the initial and final grades are 2.1% and -3.3%…

A: solution Given g1=2.1% ;g2=-3.3%so total change N =g1-g2=2.1-3.3=5.4%Length L =500ftelevation of…

Q: A surveving transcript of a closed traverse is defined by the vertices ABCDEFGHIJKL. Enor Ace is…

A: Given -

Q: 2. The 2ft diameter log (Sg= 0.8) is 8 ft long perpendicular to the figure and dams water as shown.…

A:

Q: The 300-N block in the figure is at rest on the rough horizontal plane before the force P is applied…

A: Figure is as shown

Q: 6. Why is there no earthquake load in the y direction of staad 7. What does it mean if there is a…

A: 9) lateral force's is known as wind force's , seismic force's  are resisted by the shear walls   The…

Q: A point load of 700 kN is applied on the surface of thick layer of saturated clay. Using…

A:

Q: 2-14: A soil has a void ratio of 0.70, degree of saturation 50% and G =2.7. Find the water content,…

A:

Q: A viscous liquid (p = 1.2x10³kg/m³, µ = 0.0048 Pa.s) flows at a rate of 10ml/s through a horizontal,…

A: step 1-

Q: DE TERMINE THE MAXImum DEFLEC TION uSipe DoM BLE IPPZeRATION METHO. w= 8 KN/m B 2m 4m

A:

Q: I. Compute the centroidal distance with respect to x- and y- axis of the figures below. 3 in 4 in 6…

A:

Q: water surface at point 2.5 meters upstream from the weir is 140 mm vertically above the crest.

A:

Q: Two fixed frictionless inclined planes making an angle 30° and 60° with the horizontal are shown in…

A: The vertical angle of plane with body A =60°The vertical angle of plane with body B=30°

Q: The torques shown below are exerted on pulleys A, B, and C. Knowing that the allowable shear stress…

A:

Q: ACTIVITY 2: Determine the (internal Di, external De and total D) static indeterminacy of the…

A: Hi! Thank you for the question, As per the honor code, we are allowed to answer three sub-parts at a…

Q: 4. What is the minimum "B" for the base of a dam 30m high if upward pressure beneath the dam is…

A: Answer Let us draw all the forces acting on the dam as shown in below figure W = Weight of the dam…

Q: The compound shaft is composed of a solid circular steel (G = 12 000 ksi) shaft AB, a circular…

A: As per bartleby guidelines, only 1st 3 parts among multiple parts questions need to be solved.…

Q: don't understand, can you provide more detailed steps,

A:

Q: lown in Fig. I. The compound beam shown in Fig 2 is pin supported at B and supported by rockers at *…

A: To solve Q 2

Q: As a plant maintenance engineer, you are required to purchase a 3,000 L tank of liquid butane to…

A:

Q: A T-beam that traverses the center of a floor system for which bw = 300mm and d=550 mmm. The beams…

A:

Q: 4. What is the minimum "B" for the base of a dam 30m high if upward pressure beneath the dam is…

A: Given, H=30m       Let b be the required base width of the dam.

Q: the blade is 12 m/s in the direction of the velocity of the jet, determine the force of the water on…

A:

Q: ts, the ratio

A: solution of above problem is below:

Q: A CAST IRON COLUMN OF CIRCULAR SECTION HAS A PROJECTING BRACKET CARRYING A LOAD OF 200 KN AT A…

A: The outside diameter of iron column, Do=300mmThe inside diameter of iron column, Di=250mmThe load…

Q: .A cylindrical log having a diameter of 2m and 6m long is used as a gate to control the flow of…

A:

Q: 60 lb -15 lb/ft A В F30° |C 3 ft 1.5 ft-

A: Firstly identify reaction at each support by equilibrium equatiin. Then stand at the left of 60lb…

Field applications of hydraulic conductivity

Hydraulic conductivity is one of the hydraulic properties of soil defined as a measurement of the ability of a porous medium to permit water movement or fluid flow through it. It is denoted by the letter K. It is influenced by the density and viscosity of the fluid. It is also called permeability. Hydraulic conductivity is defined as the ratio of velocity to the hydraulic gradient. The different methods used to determine the hydraulic conductivity are laboratory methods (constant head permeability tests and falling head tests), in-situ field methods (pumping in and pumping out tests), small scale field tests (infiltration tests and slug tests), and indirect methods such as estimation from grain size, consolidation test data, and horizontal capillary test. The pedotransfer function (PTF) method is a specific empirical estimating approach employed in the soil sciences is also used to determine the hydraulic conductivity of the soil.