The power customer has four circuits of220-volt three phase. The circuits have the maximum demand as follows: Circuit no 1 = 35 Amperes Circuit no 3 = 72 Amperes Circuit no 2 = 46 Amperes Circuit no 4 = 57 Amperes The diversity factor is 1.5, the load factor is 50% and the power factor is 80%. Determine the maximum KVA demand of the customer? A. 46 B. 80 C. 26.5 D. 53

The power customer has four circuits of220-volt three phase. The circuits have the maximum demand as follows: Circuit no 1 = 35 Amperes Circuit no 3 = 72 Amperes Circuit no 2 = 46 Amperes Circuit no 4 = 57 Amperes The diversity factor is 1.5, the load factor is 50% and the power factor is 80%. Determine the maximum KVA demand of the customer? A. 46 B. 80 C. 26.5 D. 53

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter2: Fundamentals

Section: Chapter Questions

Problem 2.16P: A single-phase, 120V(rms),60Hz source supplies power to a series R-L circuit consisting of R=10 and...

See similar textbooks

Similar questions

Does an open- operation, the kVA rating compared to that of the original thr-phase bank is (a) 2/3 (b) 58 (c) 1
5-A Load of particular kVA is drawing a current which lags behind the voltage at an angle of 75.43 degrees. The operating power factor is __________ . a. 0.5958 b. 0.2515 c. 0.6122 d. 0.6511
A utility company plans to connect a total of 20uF of capacitance to a 7200 volt line. To make this connection four capacitors will be connected in series. What is the capacitance of each capacitor? Answer is 80uF. What is the minimum AC voltage rating of each capacitor? Answer is 1200 volts. What is the current flow through the circuit? And what is the minimum kVAR rating of each capacitor?
Two 300-VA parallel-connected transformers can supply a maximum load of a. 150 VA b. 300 VA c. 450 VA d. 600 VA
The circuit shows an unbalanced electrical installation powered by a positive sequence symmetrical three-phase network of 380 V compound voltage. The loads are single phase. Load 1 absorbs an active power of 950 W with f.d.p. 0.5 inductive. Load 2 absorbs an active power of 1,140 W with f.d.p. Unit. Load 3 absorbs from the network an active power of 760 W with f.d.p. 0.5 capacitive. Taking the network voltage URN as the phase reference, calculate: a) complex expressions of the line currents IR. Is. and IT
The circuit shows an unbalanced electrical installation powered by a positive sequence symmetrical three- phase network of 380 V compound voltage. The loads are single phase. Load 1 absorbs an active power of 950 W with f.d.p. 0.5 inductive. Load 2 absorbs an active power of 1,140 W with f.d.p. Unit. Load 3 absorbs from the network an active power of 760 W with f.d.p. 0.5 capacitive. Taking the network voltage URN as the phase reference, calculate: a) complex expressions of the line currents IR. Is. and IT RO- SO- To- : IR Is IT UL-380 V CARGA 1 P₁ = 950 W cos p1=0,5 ind. CARGA 2 P₂=1.140 W cos p₂=1 CARGA 3 P3=760 W cos p3=0,5 cap.
2) 9.2Three - 25 KVA single-phase transformers are connected in delta – delta. One of the transformers has been defected. What is the maximum real power that the transformer bank can deliver at a power factor of 0.8?
An 11 KV generating station has four identical 3-phase alternators A,B,C and D and each of 10 MVA and 12% reactance. There are two sections of bus-bar, P and O linked by a reactor rated at connected to bus-bar section MVA with 24% reactance. Alternators A and B are and alternators C and D to bus-bar section Q. From each section, load is taken through a number of 6 MVA, 11/66KV step-up transformers, each having a reactance of 3%. Calculate the current fed into a fault if a short-circuit occurs on all phases near the high-voltage terminals of one of the transformers at the bus-bar section Q. 10 MVA 10 MVA 12% 11 11 KV 10 MVA 24% -000000 10 MVA 12% o Q 10 MVA 12% 0 11 KV 6 MVA WWW 3% /www
Two impedances consist of resistance of (15 ohms and series connectedinductance of 0.04 henry) and (resistance of 10 ohms, inductance of 0.1 henryand a capacitance of 100 microfarad, all in series) are connected in series andare connected to 230 volts, 50 – Hz AC source. Find: (a) current drawn, (b) voltageacross each impedance, (c) individual and total power factor. Draw the phasordiagram.
Three single phase 11000/220 V transformers are connected to form 3-phase transformer bank. High voltage side is connected is star, and low voltage side is in delta. What are the voltage ratings and turn ratio of 3-phase transformer? 19052 a) V, 50 220 11000 381 c) V, 50 √3 b) d) 19052 220 V, 50√3 11000 220 7.50
A three phase star connected alternator has a resistance of 0.5 ohms per phase and a synchronous reactance of 5 ohms per phase. It is exited to give 6600 V (line) on open circuit. Determine the terminal voltage and voltage regulation on full load current of 130 A when the load pf is (i) 0.8 lagging (ii) 0.6 leading pf
Khalid Abdulrahman Abdullah Alqasmi KA 05 Symm... 9 Search 8 Share O Comments Transitions Animations Slide Show Review View Help 1. A 3- phase, 30 MVA, 33 KV alternator has internal reactance of 4% and negligible resistance. Find the external reactance per phase to be connected in series with the alternator so that steady current on short circuit does not exceed 10 times the full load. Also find Find the full load current. d notes