Answered: The efficiency of three-phase…

Science

Physics

The efficiency of three-phase transmission line is less compared to single-phase transmission line

University Physics Volume 2

18th Edition

ISBN:9781938168161

Author:OpenStax

Publisher:OpenStax

Chapter15: Alternating-current Circuits

Section: Chapter Questions

Problem 9CQ: Why do transmission lines operate at very hig1 voltages while household circuits operate at fairly...

See similar textbooks

Related questions

Q: Choose the graph that represents the current and voltage phasors at t 15ms.

Q: How does a night light can be implemented using a light-dependent resistor?

A: Given: LDR is nothing but a photosensitive device used mostly on outdoor lights or street light to…

Q: What is difference between absorptive power and spectral absorptive power?

A: Absorptive Power: Absorptive Power for a surface or body can be defined as ratio of energy absorbed…

Q: The is a circuit parameter which opposes a change in the current causing a potential drop of L. di O…

A: Current : it is the rate of charge flow across a surface or into a voloume I = dq/dt Capacitance :…

Q: 5. Calculate the expected resonant frequency using equation (1) for each circuit (all capacitances)…

A: Given The values of Inductance and capacitance To find out resonant frequency & % difference…

Q: Is it possible to convert vacuum tube devices into integrated circuits?

A: ELECTRONICS

Q: Difference between OPEN LOOP and CLOSE LOOP?

Q: An electricity-generating station needs to deliver energy at a rate of 20 MW to a city 1.0 km away.…

Q: A carrier wave of peak voltage 12 V is used to transmit a message signal. Calculate the peak voltage…

A: The relation for the modulating index is given by μ = AmAc where, Am is the peak voltage if the…

Q: Explain, why high frequency carrier waves are needed for effective transmission of signals. A…

A: High-frequency carrier waves almost travel at the speed of light. These waves are not affected by…

Q: Note: By Ohm's law V = IR 1 = V/R = 0.9 MA Assuming the direction of the current Add the…

A: The data given in the question is: R1=3 kΩR2=10 kΩR3=5 kΩVs=9 V From the way battery is connected in…

Q: The voltage across the terminals of a gen- erator varies very little when we modify the circuit to…

A: The resistance is the measure opposition provided by the component against the current flow. When a…

Q: QUESTION 3: State the transmission power record if the incident power is assumed the total power…

A: The incident power is assumed to be total power received.

Q: A light bulb is rated at 100W for a 220 V supply. Find (a) the resistance of the bulb; (b) the peak…

Q: The figure below shows separate series and parallel circuits. 1 A Ω AVseries 1Ω Ω AVparallel

A: We know in series combination current remains an in parallel combination voltage.

Q: Verify the current and voltage results of the simulation by using Kirchhoff's Rules.

Q: A low voltage transformer manufacturing line has a purchase order of 1700 piece. If the…

A: We will only answer the first question since the exact question to be answered was not specified.…

Q: What does the oscilloscope display if it operates on internal mode? Select one: a. current and…

A: First of all, I would like to tell you about oscilloscopes, an oscilloscope is a device that allows…

Q: A choke coil in series with a lamp is connected to a dc line. The lamp is seen to shine brightly.…

A: Given: A choke coil

Q: The circuit in the Figure could be considered a crude dimmer. In the Figure, the switch S is open.…

A: Given: also Rab)open=3 Rab)close

Q: 6 mins each day using 1000 W microwave. How much does thiS cost over 30days if u are charged…

Q: KVL law in loop ABCD is

A: Given : Circuit with resistors and voltage supply. Required : Kirchhoff's voltage law for the…

Q: Calculate the resistance total in the complex circuit....

A: Given-

Q: The figure shows variation of the current through the heating element with time in an iron when it…

Q: If you had a 1 kHz signal to display, you should set the horizontal to __________.

Q: 10 Ω 10 mH 25 μF w = 100sin(2000t)

Q: A small metal ring is placed in a larger metal ring. Current flows in the clockwise direction in the…

Q: You want to use two light bulbs to light a room but only have one battery to power them. The…

Q: Cables of resistance of 2 ohms supply 2KW of power. Calculate the power loss in the cable if power…

Q: An ideal neon sign transformer provides 9 250 V at 30.0 mAwith an input voltage of 115 V. Calculate…

A: (a) For an ideal transformer, the power input equals the power output. The input power of the…

Q: The limb on which the electrodes are applied has a resistance of 1 kOmh and a capacitance of 0.2 µF.…

A: Given: f = 50 HzC = 0.2μF=0.2×10-6 FR = 1 kΩ = 1×103 Ω

Q: For the given circuit and input waveform, the peak value of the output is 20 time Vi R Vo -20 a) 10…

A: From circuit, V = 10 V From input waveform, Vi = 20 V

Q: What is the difference between AC power supply and DC power supply?

A: AC stands for alternating current whereas DC stands for direct current.

Q: series RLC circuit v

Q: Explain the AC operation of electrodynamic instrument in detail.

A: An electrodynamic type instrument comprises of Two Fixed Coil, a Moving Coil, Control Spring,…

Q: The inductance of a tuning circuit of an AM radio is 4 mH. Find the capacitance of the circuit…

A: STEP 1: The tunning circuit’s frequency can be represented as, Here, L and C represent the…

Q: The maximum voltage in AC circuit is 120 V. What is the effective voltage in circuit

A: Given data: The maximum voltage is V0=120 V

Q: 3000V 2000V 1000V 9V 6V 3V (Measured) Question: Why does the Q decrease as the voltage applied is…

A: Voltage represent the potential difference between two plates. Potential difference is due to the…

Q: Difference between statistically and dynamically induced emf. (In tabular form)

Q: re are a number of transmission motion potentiometers with resistors ranging from 100 oh k ohms in…

A: A potentiometer is a three-terminal resistor having either sliding or rotating contact that forms an…

Question

The efficiency of three-phase transmission line is less
compared to single-phase transmission line
Select one:
O True
O False
Next page
Previous page

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, physics and related others by exploring similar questions and additional content below.

Similar questions

Check Your Understanding If a European ac voltage source is considered, what is the time difference between the zero crossings on an ac voltage-versus-time graph?
(Indicates a review question, which means it requires only a basic understanding of the material to answer. Questions without this designation typically require integrating or extending the concepts presented thus far.) . If AC in a circuit can be thought of as a wave, which kind is it, longitudinal or transverse?
A radio receiver uses an RLC circuit to pick out particular frequencies to listen to in your house or car without hearing other unwanted frequencies. How would someone design such a circuit?
Check Your Understanding In an RLC circuit, L = 5.0 mH, C=60F , and R=200 . (a) Is the circuit under damped, critically damped, or overdamped? (b) If the circuit starts oscillating with a charge of 3.0103C on the capacitor, how much energy has been dissipated in the resistor by the time the oscillations cease?
Check Your Understanding Show that the tins voltages across a resistor, a capacitor, and an inductor in an ac circuit where the tins current is Irmsare given by IrmsR,IrmsXC , and IrmsXL, respectively. Determine these values for the components of the RLC circuit of Equation 15.12. Pave=12t0v0cos (15.12)
Does the time required for the current in an RL circuit to reach any fraction of its steady-state value depend on the emf of the battery?
parn working near the secondary of a transforme shown in the figure below. The primary voltage is 120 V (ms) at 60.0 Ha. The capacitance Cwhich is the stra capactance between the hed and the secondary windiny. is 15.0 pf. Asuming the person has a body resistance to ground R 5SO , detarmine the ms voltage acros the body Hint adraw the ceut with the secondary af the transfarmer aa smple AC source Transformer 5000 V 0000000000
When the switch just closod, the current through the circuit is: AV Oa zero if it is the only capacitor, but maximum if there is another capacitor in series with it. Obzero. Ocat its maximum value Od equal to the current in a resistive circuit in parallel with the capacitor circuit Oe greater than the current in a resistor that is farther from the battery than the capacitor. AMoving to another question will save this response.
. Show that the power loss in transmission lines PL, is givenby PL where is the power transmitted tothe user, V is the delivered voltage, and is the resistanceof the power lines.
In a purely capacitive circuit, voltage and current are in phase Select one: OTrue False Assignment, Sem-3 ements Jump to..
If the root mean square (r.m.s.) value of an alternating voltage is 250 V, what is its. peak value?
What is the peak current through a 1200 W microwave oven operating at 120-V AC?