The diagram below represents a monoprotic acid, HA. If a 0.0200 M KOH solution were slowly added to a 0.0100 M solution of the above acid, which graph best represents the data collected? II. I. IV. III. 7 mL of titrant 7 mL of titrant mL of titrant 7 mL of titrant

The diagram below represents a monoprotic acid, HA. If a 0.0200 M KOH solution were slowly added to a 0.0100 M solution of the above acid, which graph best represents the data collected? II. I. IV. III. 7 mL of titrant 7 mL of titrant mL of titrant 7 mL of titrant

Introductory Chemistry: A Foundation

9th Edition

ISBN:9781337399425

Author:Steven S. Zumdahl, Donald J. DeCoste

Publisher:Steven S. Zumdahl, Donald J. DeCoste

Chapter15: Solutions

Section: Chapter Questions

Problem 121AP: Calcium carbonate, CaCO3, can be obtained in a very pure state. Standard solutions of calcium ion...

See similar textbooks

Similar questions

Consider the following two acids: In two separate experiments the pH was measured during the titration of 5.00 mmol of each acid with 0.200 M NaOH. Each experiment showed only one stoichiometric point when the data were plotted. In one experiment the stoichiometric point was at 25.00 mL added NaOH, and in the other experiment the stoichiometric point was at 50.00 mL NaOH. Explain these results. (See Exercise 113.)
Consider the nanoscale-level representations for Question 111 of the titration of the aqueous strong acid HA with aqueous NaOH, the titrant. Water molecules and Na+ ions are omitted for clarity. Which diagram corresponds to the situation: (a) After a very small volume of titrant has been added to the initial HA solution? (b) Halfway to the equivalence point? (c) When enough titrant has been added to take the solution just past the equivalence point? (d) At the equivalence point? Nanoscale representations for Question 111.
An acid is titrated with NaOH. The following beakers are illustrations of the contents of the beaker at various times during the titration. These are presented out of order. Note: Counter-ions and water molecules have been omitted from the illustrations for clarity. (a) (b) (c) (d) (e) a. Is the acid a weak or strong acid? How can you tell? b. Arrange the beakers in order of what the contents would look like as the titration progresses. c. For which beaker would pH = pKa? Explain your answer. d. Which beaker represents the equivalence point of the titration? Explain your answer. e. For which beaker would the Ka value for the acid not be necessary to determine the pH? Explain your answer.
Three acid samples are prepared for titration by 0.01 M NaOH: 1 Sample 1 is prepared by dissolving 0.01 mol of HCl in 50 mL of water. 2 Sample 2 is prepared by dissolving 0.01 mol of HCl in 60 mL of water. 3 Sample 3 is prepared by dissolving 0.01 mol of HCl in 70 mL of water. a Without performing a formal calculation, compare the concentrations of the three acid samples (rank them from highest to lowest). b When the titration is performed, which sample, if any, will require the largest volume of the 0.01 M NaOH for neutralization?
A student is given 0.930 g of an unknown acid, which can be either oxalic acid, H2C2O4, or citric acid, H3C6H5O7. To determine which acid she has, she titrates the unknown acid with 0.615 M NaOH. The equivalence point is reached when 33.6 mL are added. What is the unknown acid?
What acid-base indicators, shown in Figure 18.24 would be suitable for the neutralization reaction whose titration curve is shown in Figure 18.30?Why?
Consider the nanoscale-level representations for Question 110 of the titration of the aqueous weak acid HX with aqueous NaOH, the titrant. Water molecules and Na+ ions are omitted for clarity. Which diagram corresponds to the situation: After a very small volume of titrant has been added to the initial HX solution? When enough titrant has been added to take the solution just past the equivalence point? Halfway to the equivalence point? At the equivalence point? Nanoscale representations for Question 110.
Another way to treat data from a pH titration is to graph the absolute value of the change in pH per change in milliliters added versus milliliters added (pH/mL versus mL added). Make this graph using your results from Exercise 61. What advantage might this method have over the traditional method for treating titration data?
One half liter (500. mL) of 2.50 M HCl is mixed with 250. mL of 3.75 M HCl. Assuming the total solution volume after mixing is 750. mL, what is the concentration of hydrochloric acid in the resulting solution? What is its pH?
Three students titrate different samples of the same solution of HCI to obtain its molarity. Below are their data. Student A: 20.00mLHCl+20.00mLH2O 0.100 M NaOH used to titrate to the equivalence point Student B: 20.00mLHCl+40.00mLH2O 0.100 M NaOH used to titrate to the equivalence point Student C: 20.00mLHCl+20.00mLH2O 0.100 M Ba(OH)2 used to titrate to the equivalence point. All the students calculated the molarities correctly. Which (if any) of the following statements are true? (a) The molarity calculated by A is half that calculated by B. (b) The molarity calculated by A is equal to that calculated by C. (c) The molarity calculated by B is twice that calculated by C. (d) The molarity calculated by A is twice that calculated by B. (e) The molarity calculated by A is equal to that calculated by B.
Describe how the amount of sodium hydroxide in a mixture can be determined by titration with hydrochloric acid of known molarity.
Follow the directions of Question 64. Consider two beakers: Beaker A has a weak acid(K a=1105). Beaker B has HCI. The volume and molarity of each acid in the beakers are the same. Both acids are to be titrated with a 0.1 M solution of NaOH. (a) Before titration starts (at zero time), the pH of the solution in Beaker A is the pH of the solution in Beaker B. (b) At half-neutralization (halfway to the equivalence point), the pH of the solution in Beaker A the pH of the solution in Beaker B. (c) When each solution has reached its equivalence point, the pH of the solution in Beaker A the pH of the solution in Beaker B. (d) At the equivalence point, the volume of NaOH used to titrate HCI in Beaker B the volume of NaOH used to titrate the weak acid in Beaker A.

SEE MORE QUESTIONS

Recommended textbooks for you

Introductory Chemistry: A Foundation

Chemistry

ISBN:

9781337399425

Author:

Steven S. Zumdahl, Donald J. DeCoste

Publisher:

Cengage Learning

Introductory Chemistry For Today

Chemistry

ISBN:

9781285644561

Author:

Seager

Publisher:

Cengage

Chemistry

ISBN:

9781305957404

Author:

Steven S. Zumdahl, Susan A. Zumdahl, Donald J. DeCoste

Publisher:

Cengage Learning

Chemistry

ISBN:

9781133611097

Author:

Steven S. Zumdahl

Publisher:

Cengage Learning

Chemistry: An Atoms First Approach

Chemistry

ISBN:

9781305079243

Author:

Steven S. Zumdahl, Susan A. Zumdahl

Publisher:

Cengage Learning

General Chemistry - Standalone book (MindTap Cour…

Chemistry

ISBN:

9781305580343

Author:

Steven D. Gammon, Ebbing, Darrell Ebbing, Steven D., Darrell; Gammon, Darrell Ebbing; Steven D. Gammon, Darrell D.; Gammon, Ebbing; Steven D. Gammon; Darrell

Publisher:

Cengage Learning

Introductory Chemistry: A Foundation

Chemistry

ISBN:

9781337399425

Author:

Steven S. Zumdahl, Donald J. DeCoste

Publisher:

Cengage Learning

Introductory Chemistry For Today

Chemistry

ISBN:

9781285644561

Author:

Seager

Publisher:

Cengage

Chemistry

ISBN:

9781305957404

Author:

Steven S. Zumdahl, Susan A. Zumdahl, Donald J. DeCoste

Publisher:

Cengage Learning

Chemistry

ISBN:

9781133611097

Author:

Steven S. Zumdahl

Publisher:

Cengage Learning

Chemistry: An Atoms First Approach

Chemistry

ISBN:

9781305079243

Author:

Steven S. Zumdahl, Susan A. Zumdahl

Publisher:

Cengage Learning

General Chemistry - Standalone book (MindTap Cour…

Chemistry

ISBN:

9781305580343

Author:

Steven D. Gammon, Ebbing, Darrell Ebbing, Steven D., Darrell; Gammon, Darrell Ebbing; Steven D. Gammon, Darrell D.; Gammon, Ebbing; Steven D. Gammon; Darrell

Publisher:

Cengage Learning

SEE MORE TEXTBOOKS