synchronous generator threewThe phases are rated at 1000 kVA and operate at a voltage of 6.6 kV. The product resistance per phase is 0.38 ohms and the leakage reactance is 0.5 ohms per phase. The generat works to provide full load at a power factor of 0.85 delayed and at normal voltages. Find the value of the no-load voltage.

synchronous generator threewThe phases are rated at 1000 kVA and operate at a voltage of 6.6 kV. The product resistance per phase is 0.38 ohms and the leakage reactance is 0.5 ohms per phase. The generat works to provide full load at a power factor of 0.85 delayed and at normal voltages. Find the value of the no-load voltage.

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter3: Power Transformers

Section: Chapter Questions

Problem 3.56P: Three single-phase two-winding transformers, each rated 3kVA,220/110volts,60Hz, with a 0.10 per-unit...

See similar textbooks

Similar questions

The reactance of a generator is given as 0.25 per-unit based on the generator’s of 18 kV, 500 MVA. Find its per-unit reactance on a base of 20 kV, 100 MVA. a. 0.0505 b. 0.0605 c. 0.0405 d. 0.0606
2A. What is another term for "shunt"? a) in series b) in parallel c) compounded d) none of the above 2B. Which of the following is/are a basic type of DC generator connection? a) series b) shunt c) compound d) all of the above
A synchronous generator runs at 250 rpm and generates at 50-Hz. There are 216 slots, each containing 5 conductors arranged in a full-pitched winding for 3-phase star connection. All the conductors of each phase are in series and the flux per pole at no-load sinusoidally distributed over the pole pitch is 30 mWb. Find the emf induced in each phase winding and the terminal voltage.
What are the conditions in paralleling of these DC Generators:a. Shuntb. Seriesc. Compound
e = 0 Q1: What does happen if we change two currents? a. Q2: What does happen if we have a three-phase four poles machine? Q3: What does happen if we have a two-phase two poles machine? e = 0 Q4: What does happen if we apply a capacitance in phase b and then use same voltage for both phase. Dr. Ali Ki. pw --
What is phase angle of voltage induced in primary and secondary windings of transformers due to mutial flux?
A three phase star connected, 1500 kVA, 13 kV alternator has an armature resistance of 0.9 ohm and a synchronous reactance of 8.0 ohms. When carrying rated load voltage, calculate the generated voltage per phase at loads of a. Unity P.F. b. 0.8 lagging P.F. c. 0.8 leading P.F. d. Calculate the voltage regulation for each loads and determine best regulation.
Two identical three-phase Alternators A and B share equally a load of 10 MVA at 33 KV and 80% lagging power factor. The synchronous reactance of each generator is 4 ohms per phase and the armature resistance is negligible. Alternator A has its field excitation adjusted to carry a25 amperes at lagging power factor. What is the current delivered by Alternator B ?
In the system shown in Figure 1, the transformers are connected star-star with both star points grounded and the generators are connected in star with thier star points grounded. The system base is 15 MVA. The transformers all have reactances of 0.04 p.u. on this 15 MVA base. The reactances of all other elements are given in Table 1 (in 2) and the voltage levels are given in Table 2. p.u. G1 p.u. T1 jö Per-Unit Convert all values to p.u. on a 15 MVA base. Xa= p.u. Xc₂= XL = V BABE G1 2 X 9 T3 Figure 1: A section of the distribution system T1 L Table 1: Sequence reactances (2) 3 G1 L G2 0.3 0.59 0.01 4 L 9/10 10 Fault Voltage What is the voltage at bus 3 (in Volts) after the fault has occurred? Vp= V T2 5 T2 34 10/4 Table 2: Voltage bases (kV) G2 4 T3 10/9 | G2 Fault Current A three-phase fault with a fault reactance of 0.01 p.u. occurs at bus 3. Calculate the fault current flowing at the fault point in KA. Ip=-j KA So
2- Draw and explain the phasor diagram for two transformers in parallel.
(use 2-decimal digits for solutions) A synchronous generator runs at 250 rpm and generates at 50-Hz. There are 216slots, each containing 5 conductors arranged in a full-pitched winding for 3-phasestar connection. All the conductors of each phase are in series and the flux perpole at no-load sinusoidally distributed over the pole pitch is 30 mWb. Find the emfinduced in each phase winding and the terminal voltage.
What are the conditions for the parallel operation of 1-phase transformers?