question. A sample of argon gas collected at a pressure of 1.16 atm and a temperature of 29.0 °C is found to occupy a volume of 20.7 liters. How many moles of Ar gas are in the sample? mol

Q: 13.36 Identify each of the following as the a or ß isomer: а. CH₂OH b. CH₂OH Н HO Н ОН ОН Н Н ОН Н…

A: Anomers are two sugar that differ in the configuration only at the carbon that was carbonyl carbon…

Q: 7. What is the wavenumber of an infrared photon whose wavelength is 100 μm? a) 1 cm ¹ b) 10 cm-1 c)…

A:

Q: ) What is the pH of water in equilibrium with 0.040 ppm SO2 gas? The total air pressure is 1.02 atm.…

A: #3: (a): Given the concentration of sulfur dioxide, SO2 in air = 0.040 ppm 1 ppm = 106 parts =>…

Q: Starting materials: 1.80g metals/magnesium 5.65mL Bromopropane 3.04mL 4-methoxybenzaldehyde…

A: mass of product=  3.40g volume of 4-methoxybenzaldehyde = 3.04mL

Q: The following diagram shows a membrane-enclosed area with a high concentration of chloride and…

A: Symporter transportation:- the process of transportation of two different molecules by a same…

Q: 13.42 For each of the following, give the monosaccharide units produced by hydrolysis, the type of…

A:

Q: Balance the following redox reaction in acidic conditions using half equations. MnO4– (aq) + H2C2O4…

A: Since, In redox reaction, Oxidation and reduction reaction both takes place simultaneously.

Q: What is the physical origin of the specific selection rule ΔJ= ±1

A: Selection rule in physics and chemistry specify the likelihood of a transition between two…

Q: An unknown substance has the following properties: 1) does not conduct electricity in its solid…

A: Ionic compounds have the following properties:  Consists a cation and anion. Example:  salt ( formed…

Q: A 135.1 g piece of copper (specific heat 0.380 J/g･ °C) is heated and then placed into 400.0 g of…

A:

Q: This is an isomer of C4H10O, and it’s not an alcohol. What could the structure be, and what are the…

A: Given that, the molecular formula of an unknown compound is C4H10O. It is not an alcohol. We have to…

Q: The average grain diameter for some metal alloy was measured as function of time at 650°C, which is…

A: Given  n = 2

Q: Describe the basis for the important names for for molecule Chloroacetophenone

A: To describe the basis for the important names for for molecule Chloroacetophenone. The  structure of…

Q: Given that K, for water is 2.4 x 10-14 at 37 °C, calculate the pH of a neutral aqueous solution at…

A: Using Kw we will find Pkw and from pkw we can find the pH of the solution.  Comparing the pH of the…

Q: Calculate the Ksp for Li3PO4 if at equilibrium the concentration of PO43- ion is 3.30 x 10-3 M

A: We have to calculate the Ksp for Lithium phosphate

Q: A chemist prepares a solution of silver(II) oxide AgO by measuring out 0.00677μmol of silver(II)…

A: Molarity is defined as the no.of moles of solute present in one litre of solution.

Q: For the following reaction: C3H8(g) + 3CO2(g) + 4H₂O(1) 50₂(g) The change in gaseous moles, An = +…

A: Le Chatelier's principle states that any change in the concentration, temperature, volume or…

Q: A given molecule has 2 degenerate states that are 700 cm³¹ (wavenumbers, 1/2) above the lowest…

A: (a) It is given that a molecule has 2 degenerate state that are 700 cm-1 above the lowest energy…

Q: If the ?b of a weak base is 7.4×10−6, what is the pH of a 0.16 M solution of this base?

A: The value of Kb for the given weak base is = 7.4x10-6 The concentration of the base solution is =…

Q: 19. What type of polymer is the following, and what monomers are [५] (K=4,A=1) used for making it?

A:

Q: HCIO is a weak acid (K₁ = 4.0 × 10-8) and so the salt NaCIO acts as a weak base. What is the pH of a…

A:

Q: how do you find the oxidizing agent and reducing agent for the following chemical equations?

A:

Q: Solvent-Free Claisen Condensation a. Draw the curly arrow mechanism for the formation of this…

A: The Claisen condensation reaction is an organic coupling reaction that results in the formation of a…

Q: 2. A sample consists of a mixture of Fe(NO3)2 (s) and Fe(NO3)3 (s) in unknown proportion. A total of…

A: 2. Sample mixture : FeNO32 + FeNO33Total 3.65 g of mixture was dissolved in phosphoric acid…

Q: Enthalpy change of reaction for hydrogen iodide and aqueous sodium hydroxide, when mixed in the…

A: Heat = mass of solution × specific heat × temperature changeSpecific heat of solution = specific…

Q: Rank the elements or compounds in the table below in decreasing order of their boiling points. That…

A:

Q: Why is Tyndall effect shown by colloidal particles? State four instances of observing the Tyndall…

A: •Tyndall effect:- Tyndall effect is the phenomenon in which light is scattered by colloidal…

Q: What kind of intermolecular forces act between a sodium cation and a formaldehyde molecule

A: Intermolecular fores are of various type: 1) dipole-dipole interaction Intermolecular force that…

Q: A voltaic electrochemical cell is constructed in which the following cell reaction occurs. The…

A: A redox reaction where oxidation amd reduction takes place. Oxidation is loss of electron and…

Q: Most sugars can act as reducing agents.  Could the dichromate reaction shown in equation (1) be used…

A: Given: Equation 1: 2 K2Cr2O7 + 8 H2SO4 + 3 CH3CH2OH  →  2 Cr2(SO4)3 + 2 K2SO4 + 3 CH3COOH + 11 H2O.…

Q: What is the chemical formula for nitrous oxide?

A: The chemical formula of compound or molecule represents actual number of atoms present in it.

Q: Problem 6.10. A water molecule can vibrate in various ways, but the easiest type of vibration to…

A:

Q: compound A = 0.02 g compound B = 0.012 g If 20 ml of solvent is used, which is the best solvent to…

A: Given:  mass of compound A = 0.02 g = 0.02 g × 1000 mg/g = 20 mg Mass of compound B = 0.012 g =…

Q: TIT Part 3: Mass to moles. Convert mole quantities to masses. Use the periodic table for atomic…

A:

Q: 13. Given a solution of 0.23 M oxalic acid (H₂C2O4). Determine the equilibrium values of: (a)…

A: #13: Oxalic acid, H2C2O4(aq) is a diprotic acid with the below acid dissociation constant values:…

Q: Is this an Endothermic Sn1 diagram?

A:

Q: Using the following data at 528 K: (Points are equally distributed) (1) A(s) + B(g) ×10² (2) 4 C(g)…

A: Value of equallibirium constant can be given as:

Q: 0.02852 g sample of gas occupies 10.0 mL at 291.5 K and 1.10 atm. Upon further analysis, the…

A:

Q: When glucose is metabolized in the body, the reaction it undergoes is represented by the following…

A:

Q: 5.8 Use the Gibbs energies of formation in the Resource sec- tion to decide which of the following…

A: Hi there! as there are multiple sub-parts posted. we are solving first three subparts.  If you need…

Q: 2 3 2 2 Na(s) + Na(s) + 10 Mg(s) + Mg(s) + H₂O2(aq) → 10 Cl2(g) O2(g) ->> - O2(g) ->> HCl(aq) ->>…

A:

Q: 1. What is the purpose of rinsing the buret and pipette prior to their use? What kind of errors…

A: Hi there! as there are multiple questions posted. we are solving first question.  If you need…

Q: Workshop 10: Stoichiometry and Limiting Reagent In chemistry we represent chemical reactions using…

A: The reactant which is present in lesser amount in the chemical reaction and which guides the amount…

Q: C/III F I Br Is this molecule polar, and if so, then what is the direction of the polarity vector?…

A:

Q: Calculate the volume in liters of a 0.045 mmol/L. potassium dichromate solution that contains 500…

A:

Q: A student drew this VSEPR diagram: Full F F 90° 90° F F F What is the error with this diagram, if…

A: The molecule given is SF6.

Q: Be sure to answer all parts. The active agent in many hair bleaches is hydrogen peroxide. The amount…

A: Here we are required to find the Moles of hydrogen peroxide present in the sample of bleach.

Q: what is the electron pair geometry for H2O

A: Electron geometry of H2O According to the valence shell electron pair repulsion (VSEPR) theory of…

Q: Re-order each list in the table below, if necessary, so that the atoms or ions in it are listed in…

A: Size of anion is always greater than its own neutral atom.

Q: The reactant molecule is re-drawn in the drawing area below. Highlight in red any groups in this…

A: In a redox reaction: Oxidation reaction: Removal of the electron or increase in oxidation state is…

Kinetic-Theory of Gases

Kinetic theory of gases is the model or method which was developed in the 19th century by Maxwell and Boltzmann. This is possible as the interatomic force which is of short-range forces that are important for solids and liquids can be neglected for gases. This theory or gas law gives a molecular interpretation of the pressure and temperature of a gas and is consistent with gas laws and Avogadro’s hypothesis. This theory is very helpful to correctly explain the specific heat capacities of many gases, kinetic energy and it also explains the transport qualities such as viscosity, thermal conductivity, and diffusion with molecular parameters. As stated in the kinetic-molecular theory, the temperature of a substance or gas particle is related to the average kinetic energy of the particles of that substance. When a substance is heated, some of the absorbed energy is stored within the particles, while some of the energy increases the motion of the particles, called average kinetic energy.