Question 4 Figure Q4 shows a message signal m(t) to be angle modulated. If mp = 20v, T = 5 sec, kp = rad 2π, k = 2 x 10¹ rad/s/v, then compute appropriate values of instantaneous frequency to roughly sketch both FM and PM modulated signals. Show your sketches on a rough scale. V T 2T Figure Q4: A typical message signal to be modulated. 3T t

Question 4 Figure Q4 shows a message signal m(t) to be angle modulated. If mp = 20v, T = 5 sec, kp = rad 2π, k = 2 x 10¹ rad/s/v, then compute appropriate values of instantaneous frequency to roughly sketch both FM and PM modulated signals. Show your sketches on a rough scale. V T 2T Figure Q4: A typical message signal to be modulated. 3T t

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

As an engineer, you are required to generate an FM signal using a single tone sinusoidal signal of frequency, fm with the modulation index of 1.5. Sketch the frequency spectrum of the FM signal and determine the total power contained in the frequency range fc-2 fm to fc + 2 fm - given the carrier voltage is 12 V and the load resistor is 1202
Question: The maximum deviation allowed in an FM broadcast system is 75 kHz, If the modulating signal is a single-tone sinusoid of 8 kHz, determine the bandwidth of FM signal. What will be the bandwidth when modulating signal amplitude is doubled?
FM modulator is used to transmit a cosine message signal with 4V amplitude and 20Hz frequency. The carrier is a cosine signal with an amplitude of 10V and a frequency of 2000Hz. What is the power of the FM modulated signal?
FM modulator is used to transmit a cosine message signal with 4V amplitude and 20Hz frequency. The carrier is a cosine signal with an amplitude of 10V and a frequency of 2000Hz. What is the strength of the FM modulated signal?
Please explain the waveforms, what are the reason why does the 3rd waveform is attenuated. 1st waveform: Carrier signal (2Vpk,20 kHz) 2nd waveform: Information signal (1Vpk,1kHz) 3rd waveform: Receiver signal
Design an Armstrong indirect FM modulation to generate an FM signal with carrier Q5: frequency 97.3 MHz and Af=10.24KHZ. A NBFM generator of fc1=20 KHz and Af-5 Hz is available. only frequency doublers can be used as multipliers. Additionally, a local oscillator with adjustable frequency 400 and 500 KHz is readily available for frequency mixing.
Design Armstrong indirect FM modulator to generate an FM signal with fc = 400 MHz and Af = 97.2KHz. A NBFM generator of fc1 = 100KHz and Af₁ 25Hz. Fifth frequency tipplers can be used as multipliers, any number of frequency doublers and a local oscillator with tuning range (400-1500) KHz is readily available for frequency mixing. =
Since a,b,c have already been answered. Just answer the remaining d, e, f. Thanks! A 75 MHz carrier having an amplitude of 50 V is modulated by a 3 kHz audio signal that has an amplitude of 20 V. a. Sketch the audio signal. b. Sketch the carrier. c. Construct the modulated wave. For a, b and c - label your diagram d. Determine the modulation factor. e. What frequencies would show up in a spectrum analysis of the modulated wave? f. Write trigonometric equations for the carrier and the modulating waves.
Q4- Drive a formula for NBEM by using Bessel function Q5- If an information signal X(t) cos(2n700t) + 10cos(2n5000t). Write the formula of the frequency modulation (FM) when Ac=20 , Fc=10® Hz, Kf= t2000 Q6-) If NBFM signal passes through a frequency multiplier. With B< 0.5 and fc=200kHz. Let fm ranges from 5OHZ to 15kHz, and let the maximum frequency deviation Aƒat the output be 75kHz. Find the required frequency multiplication n and the maximum allowed frequency deviation at the input.
Design an Armstrong indirect FM modulator to generate an FM carrier with carrier frequency of 98.1MHZ and Af = 75KHZ. A narrowband FM generator is available at a carrier frequency of 100KHZ and a frequency deviation Af = 10Hz. The stock room also has an oscillator with an adjustable frequency in the range of 10 to 11 MHz There are also plenty of frequency doublers, triplers, and quintuplers-
Type your question here The figure below shows a satellite receiver uses two hytrodyne operations. It is used to receive transmissions at 136 ???. the first local oscillator operates below the incoming carrier frequency, while the second operates above the first IF frequency. Find all possible image frequencies.
5. Design (only the block diagram) an Armstrong indirect FM modulator to generate an FM carrier with a carrier frequency of 97.5 MHz and AS = 95 kHz A narrowband FM generator is available at a carrier frequency of 100 kHz and a frequency deviation Af 5 Hz. An oscillator with an adjustable frequency in the range of 10 to 11 MHz is also available.