Q/ Using Kirchhoff's law, find the voltages ? 150 T 5V 300

Q: A memory IC that can hold up to 1024 bits and has a 8 address lines can be organized into…

A: Answer: 256x4   a). It is not a valid option. 1024x1 requires 10 address lines. 210 = 1024.   b) a).…

Q: For the function f(a,b,c,d)=Em(0,1,3,5,6,7,8,10,14,15), find all minimum sum-of-products solution,…

A: According to the question, for the given function fa, b, c, d=∑m0, 1, 3, 5, 6, 7, 8, 10, 14, 15 We…

Q: 2- Use superposition to obtain vx in the circuit of Figu Answer: 0.75 A. -0-8 90 V

A: The solution is given below

Q: Calculate the capacitance of a capacitor tha Answer : C = = pF

A:

Q: A coaxial conductor has radii a = 0.05 cm and b = 0.1cm and polystyrene dielectric for which ϵR=…

A: Given,a=0.05 cmb=0.1 cmP=3ρaρ μC/m2εR=1.56andε0=8.854×10-12 F/m

Q: 5. R,=_Q R, = 5 kn R3 =200 R2 = 50 0 R4 = 100 2 %3D

A:

Q: total energy stored in capacitor

A:

Q: A six pole, three-phase SCRIM is connected to 60 Hz supply. At full load the rotors induced emf…

A: In an induction motor slip = rotor frequency /stator frequency. Frequency is the no. Of cycles per…

Q: 2. I, =_ Ra=50 Ω ET = 100 V R2 =50 Ω R4350 Ω R= 100Ω

A:

Q: 1- Express the Boolean function F(A,B,C,D) = A' + BD' in (SOP) 2- Express the Boolean function…

A: We are authorized to answer three subparts at a time, since you have not mentioned which part you…

Q: putside shell is aluminum. The resistance of the cable is is Ps and Pa 5 respectively 0 447 ohm C0…

A: Given, L = 1mile = 1609 mdsteel core = 0.50 inch =0.50×0.0254 m= 0.0127 mdaluminium(outside shell)…

Q: Using a uniform illuminated parabolic reflector, calculate the half power beamwidth for an antenna…

A: The solution is given below

Q: Calculate the values of V1, V2, A1, A2, and A3. Show complete solution.

A:

Q: A certain amplifier has an open-loop midrange gain of 150,000 and an open- loop 3 dB bandwidth of…

A: In this question certain amplifier given with open loop gain and bandwidth...We have to find out…

Q: A. Simplify the Circuit 1. B. Implement the simplified circuit of number 1.

A:

Q: 2- For the below circuits A, B, and C are the inputs while Y is the output. For each circuit: I)…

A:

Q: Refer to the given circuit. R2 = 5 2 R1 = 6 0 R3 = 4 N R4 = 4 1 R5 = 8 N DURACELL VT = 10 V

A: Current: It is the time rate of change of the charges and its unit is Ampere.

Q: 4.0 Ω 5.0 Ω. 18 V 3.0 Ω 6.0 Ω

A:

Q: Three resistors A,B and C are connected in parallel. The resistance of A is 12 ohms , and that of B…

A: Combine resistor A and B as a single resistance

Q: deriv ds in Cylnderical deriv dv iin Cylnderical

A:

Q: : Negative feedback (a) increases the input and output impedances (b) increases the input impedance…

A: Due to negative feedback, gain of the amplifier will reduce. Since for any system , Gain * Bandwidth…

Q: Vee +12 V R 22 kN out | 2N3904 R. 6.8 kfn 560 N

A: We need to find out emitter capacitance for given circuit

Q: Determine the force attraction between charge Q1 and Q3. Determine the electric field intensity…

A:

Q: Part A Consider the circuit in (Figure 1). Suppose that R= 1.0 kN. Use the principle of…

A: We need to find current for given circuit

Q: TLO 6 2 Use mesh-current analysis to find the branch currents indicated in the network shown below.…

A:

Q: Calculate the Earth’s curvature between two microwave antennas with a path distance of 10 miles.…

A: Given information: The path distance between two microwave antenna is d=10 miles. Earth's radius…

Q: A 15 hp, 4 pole 60 Hz, wye connected, 208 volts induction motor draw 12 kW from the line have losses…

A:

Q: The Fourier Saries

A:

Q: Figure Q1(a) and Figure Q1(b) (refer to each student's attachment) illustrate the signal x(t) and…

A:

Q: Find I in the network using Norton's Theorem.

A:

Q: Given a combinational logic circuit whose input is a four-bit number and whose output is the 2's…

A: Consider the given combinational circuit, Let the 4-bit inputs are A,B,C, and D, with A as MSB and…

Q: Draw the output voltages of each rectifier for the indicated input voltages, as shown in Figure…

A: Please refer the attached images for the complete answer..

Q: Using the Circuit below, determine the following: 1. Determine the current passing through the 7K…

A:

Q: Determine the bias current, IBIAS, given that the input currents to an op-amp are 7.9 µA and 8.3 µA…

A:

Q: Determine the charge in capacitor C5. 6F 3F 6F C, 12 F 6F 12 volt

A: In this question we will find charge in capacitor C5....

Q: 2. As frequency decreases, how does the reactance of a coil vary? 3. What is skin effect, and how…

A:

Q: of 0,0242 per phase and standstill etermine the speed at which maximum torque is developed. Ans[1440…

A:

Q: Q3. A three-phase, 50 Hz, completely transposed 345 kV, 200 km line has two conductors per bundle…

A: Three Phase System: The three-phase system is a cost-effective means to transmit large amounts of…

Q: A coaxial conductor has radii a = 0.05 cm and b = 0.1 cm and polystyrene dielectric for which ϵr=…

A: Given,a=0.05 cmb=0.1 cmP=3ρaρ μC/m2εR=2.56andε0=8.854×10-12 F/m

Q: For the mechanical translation system below, find the force-voltage and force-current analogy. Use…

A: Given thata=0b=7c=5K=1fv1=1fv2=3+b=10fv3=1.5fv4=1+c=6M1=4+a=4M2=5 The mechanical model is given as

Q: 2) A 2 µC point charge is located at A(4, 3, 5) in free space. Find the components E, , Es , and E,…

A:

Q: pole in the electric motor (electromagnet) if it loses its magnetic field How to recharge the

A: A magnet is used to create the magnetic field. it may be an electromagnet or a permanent magnet,…

Q: In installing a telephone system in a building, PABX is used up to the riser (conduit is used) and…

A: It is mentioned that in installing a telephone system in a building, PABX is used up to the riser…

Q: Use mesh-current analysis to find the branch currents indicated in the network shown below. I1 40°v…

A:

Q: given h(t) = e−3tu(t), where u(t) is the unit-step function, calculate the convolution y(t) = x(t)…

A:

Q: A piece of resistance wire, 15.6 m long and of cross-sectional area 12 mm² at a temperature of 0°C,…

A: It is given that: Length of wire=L=15.6 mCross-sectional area=A=12 mm2=12×10-6 m2Initial…

Q: A balanced ∆-connected load, with Z∆ = 30 30° Ω, is connected to a three-phase, three- wire, 250-V…

A: It is given that: Z∆=30∠30° ΩZC=0.4+j0.3 ΩVph=250 V

Q: Question 3: According to the following circuit answer the following A- Find the Maxterm for this…

A: We need to find out min and Max term for given circuit

Q: 10 j12 2Ix -j127 220°A 10 10 10 5°v Ix ll

A:

Q: Problem solving 1. A building has 21 housing units. Each housing unit has the following circuit…

A: Electrical demand factor can be explained as the Maximum demand of system divided by total connected…

Compensation Techniques

The compensation techniques are the methods that are employed in the electrical control systems to enhance the performance of the system. The performance are generally affected by the factors like lag in the compensating devices, slow response of the system of the components like sensors used in the control system. The basic compensation technique involves lag compensation, lead compensation or the combination of the both.