Problem 1 • A sinusoidal current of 10Arms at a 60Hz fundamental frequency is contaminated with a ninth harmonic current. The current can be expressed as i(t) = 10v2 cos(2n60t) + 1,vZ cos(18760t) Amps Determine the value of the 9th harmonic RMS current l9, the power factor, and the distortion factor for each of the following cases of THD (a) 5% (b) 10% (c) 20%

Problem 1 • A sinusoidal current of 10Arms at a 60Hz fundamental frequency is contaminated with a ninth harmonic current. The current can be expressed as i(t) = 10v2 cos(2n60t) + 1,vZ cos(18760t) Amps Determine the value of the 9th harmonic RMS current l9, the power factor, and the distortion factor for each of the following cases of THD (a) 5% (b) 10% (c) 20%

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

For the following parts, identify the name of each circuit, plot the output waveform, and find the DC output average voltage. Part (a) V 1 cycle V₁ = V sin cor Part (b) PE Part (c) Vm Vi ele eeeeeeeeeeeeee D D₂ D₁ D₂ R Va + D₂ D₁
C1 L1 R1 V1 Vout V1 contains the fundamental and its harmonics (fo, 2fo, 3fo, ...). The amplitude of the harmonics is inversely proportional to the harmonic number. V(fo) = 10 mV V(2fo) = 10mv/2 = 5 mV V(3fo) = 10mv/3 = 3.33 mV V(4fo) = 10mv/4 = 2.55 mV a) What is the minimum value of Q for the circuit that will attenuate the third harmonic (3fo) in Vout to be less than 1% of the fundamental? b) What is the amplitude of the fifth harmonic (5fo) as a percentage of the fundamental?
H.W: A resistor of resistance R-1000 2 is maintained at 17 °C and it shunted by 100 uH inductor. Determine the rms noise voltage across the inductor over a frequency bandwidth of: i) 15.9 kHz Ans: 182 x109 volt ii) iii) Ans: 9.22 x10-8 volt Ans: 2.34 x10-6 volt 159 kHz 1590 kHz
can you please give me the comple solution for this question, thanks. A certain voltage function contains a constant term, a fundamental and third harmonic. The maximum value of the fundamental is 85 % of the constant term and the maximum value of the third harmonic is 55 % of the constant term. If the effective value of this function is 180.3V, find the magnitude of the two harmonics. A.IstHarmonic = 75 V , 3rd Harmonic = 120V B. Ist Harmonic = 80 V , 3rd Harmonic = 125V C. IstHarmonic = 120 , 3rd Harmonic = 75V D. Ist Harmonic = 125 V , 3rd Harmonic = 80V E. NOTA
3. For a sinusoidal input of 20 Vpe to the given circuit, what is the peak value of the output waveform? V-5V a) 20 V b) 25 V c) 0 V d) -25 V
For the circuit in the above figure, determine the complex impedances, Zeq1 and Zeq2 for a frequency of 1/2π Hz.
5. For a 1Vpp sinusoidal input, at a frequency of 1KHz, draw the output for each circuit.
The baudwith of amplitude modulated component is IOKAE, the aighest frequency is T05 K Hz. Find carrier frequency of AM sign9/·
A resistor of resistance R=1000 2 is maintained at 17 °C and it shunted by 100 µH inductor. Determine the rms noise voltage across the inductor over a frequency bandwidth of: i) 15.9 kHz Ans: 182 x10-⁹ volt Ans: 9.22 x10-8 volt 11) 159 kHz iii) 1590 kHz Ans: 2.34 x10-6 volt
Apply a sinusoidal input voltage with 2V p-p and vary the frequency according to the table below. Measure the voltage Vr and current I from the voltage across R and find the phase angle between the Vi and I.
what is the phase angle of iT in degrees when expressed as a cosine function?
Consider the circuit given below a) Identify the circuit with details b) Find the Q-point c) Find VG Vs VD, VDs and VGs d) Find the RMS output voltage and draw it In the same graph with input e) Comment on the output signal if the input increases to Vinp=20V Voo =18 V Toss- 10 mA Rp = 2.7 kn Vasiam 6 V Ca = 100 µF Gn = 0.1 uF %3D R= 22 kn Va = 300 mv R- 1.5 MO R O - 100 µF 220 1