power management module comprises two regulators with the following specifications. Both regulators operate from a common supply voltage of 3.3 V. Regulator 1: Linear, VO = 2 V, ILOAD = 200 mA Regulator 2: Switching, VO = 2.8 V, ILOAD = 2 A, η = 93% Fill in the blank with a numerical answer: The total efficiency of the above power management module is ηη = ____ % (up to 1 decimal places)

power management module comprises two regulators with the following specifications. Both regulators operate from a common supply voltage of 3.3 V. Regulator 1: Linear, VO = 2 V, ILOAD = 200 mA Regulator 2: Switching, VO = 2.8 V, ILOAD = 2 A, η = 93% Fill in the blank with a numerical answer: The total efficiency of the above power management module is ηη = ____ % (up to 1 decimal places)

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter3: Power Transformers

Section: Chapter Questions

Problem 3.7MCQ: Consider Figure 3.5. Match the following, those on the left to those on the right. (i) Im (a)...

See similar textbooks

Similar questions

b) A certain winding made up of copper has a resistance of 100 Q at room temperature. If resistance temperature coefficient of copper at 0 C° is 0.00428/C°, calculate the winding resistance if temperature is increased to 45 C°. Assume room temperature as 25 C°.
Determine the DC currents (IB, Ic and lĘ) and dc junction voltages (VBE, VCE and VCB) Ig=Blank 1 mA, Ic=Blank 2 mA, IĘ=Blank 3 mA, VBE= Blank 4 V, VCE = Blank 5 V and VCB = Blank 6 V Use 2 decimal places. Use the following values: VBB = 2V RB = 7 kQ Rc = 248 Q Vcc = 19 V BDc = 56 Blank 1 Add your answer Blank 2 Add your answer Blank 3 Add your answer Blank 4 Add your answer Blank 5 Add your answer Blank 6 Add your answer
An AC ammeter is connected in series with the primary winding of T1. What is the expected current reading? An AC ammeter is connected in series with the secondary winding of T1. What is the expected current reading? An AC ammeter is connected in series with R1. What is the expected current reading? NOTE: Idc for HW rectifier = 0.318 * Ipeak = 0.45 * Irms Describe/Explain briefly the purpose/use of the array (series-parallel) connection of the rectifier diodes in the given circuit.
10. Determine the peak-to-peak ripple and de output voltages in Figure 5. The transformer has a 36 V rms secondary voltage rating, and the line voltage has a frequency of 60 Hz. 120 Vrms 00000 ellee Rectifier B Figure 5. Rsurge www 10 (2 100 μF www R₁ 3.3 ΚΩ
56. A single phase thyristor adjust line spacing converter with a resistive load is shown below: V₂ = V₂ sinet SCR ER V₂ If the supply voltage is 230V (rms) at 50 Hz, calculate ripple factor for firing angle a -45° and R = 100 Q. (A) I (C) 1.21 (B) 1.11 (D) 1.44
multirange ammeter was designed using direct method to give three scales with Rsh1= 0.001285989 0, Rsh2=0.000562552 0, and Rsh3=0.000100001 Q. The d'Arsonval meter has Rm=6 Q and full scale current of 1.5 mA. Find the ranges.? 8 (Ctrl) -
56. A single phase thyristor adjust line spacing converter with a resistive load is shown below: V₂ = V sinest SCR ER R V₂ (B) 1.11 (D) 1.44 If the supply voltage is 230V (rms) at 50 Hz, calculate ripple factor for firing angle a-45" and R - 100 9. (A) I (C) 1.21
0.5) A full-wave rectifier with L-C filter is shown in figure 3. If the resistance of the load is 2002, detemine the ripple factor. 100mH 52 Vs 470 µF RL Vs = v2 5 Sin 314t %3D
A certain winding made of copper has a resistance of 100 ohms at room temperature. If resistance temperature coefficient of copper at 0 0C is 0.00428, calculate the winding resistance if temperature is increased to 50 0C. Assume room temperature as 25 0C.
6. Identify the electronic symbol pointed by the line in the given schematic diagram F A TIP2066 with Heat Sink MA 01 Ohm E Sw TIP2055 wih Heat Sink B 10 Amp 50 PN Bridge Rectiter 0.1 Ohm SW LMTar2 we Heat Sink FUSE A FUSE 10A 230 Voit AC 12V Out o Gnd in 0.1 Ohm Sw 470uF 230112V 10A Transformer 47000UF Sov Output 10 uf 12V10A D A В C D F M CnolIL Choclk
One type of linear reglator of power supply is known as A.strict regulator B.cheap regulator C.shunt regulator D.open regulator
The generator convert from PV to PQ if the active power of the generator exceed the * maxinum and minimum limits between the maximum and mimium limit equal to the load power O Non of them