Place the path of light (using the numbers) in the microscope in the proper order as the light travels from its source until it hits the researcher’s eye: 1) condenser 2) light source 3) nose- piece lens 4) ocular lens 5) slide a) 1, 2, 5, 4, 3 b) 1, 3, 4, 2, 5 c) 2, 1, 5, 3, 4 d) 3, 2, 1, 4, 5 e) 1, 3, 4, 2, 5

Place the path of light (using the numbers) in the microscope in the proper order as the light travels from its source until it hits the researcher’s eye: 1) condenser 2) light source 3) nose- piece lens 4) ocular lens 5) slide a) 1, 2, 5, 4, 3 b) 1, 3, 4, 2, 5 c) 2, 1, 5, 3, 4 d) 3, 2, 1, 4, 5 e) 1, 3, 4, 2, 5

Basic Clinical Laboratory Techniques 6E

6th Edition

ISBN:9781133893943

Author:ESTRIDGE

Publisher:ESTRIDGE

Chapter1: The Clinical Laboratory

Section1.10: The Microscope

Problem 18RQ

See similar textbooks

Similar questions

How will the following affect resolution during microscopy? I) Closing or opening the diaphragm II) Raising or lowering the condenser III) Increasing or reducing the light intensity
2. The boy is wondering what to use to clean the microscope lenses. The lens tissue has been treated to prevent scratching. What should one use to clean? Why? 3. The girl is focusing a slide and she is moving the stage up toward the slide. a) What has happened to the slide? b) s this the proper way to focus? c) Should you focus by moving stage up or down? d) What happens to a microscope i place at the edge? e) What should you do to prevent this from happening. Fgute
The girl is focusing a slide and she is moving the stage up toward the slide. a) What has happened to the slide? b) Is this the proper way to focus? c) Should you focus by moving stage up or down? d) What happens to a microscope i' place at the edge? e) What should you do to prevent this from happening.
D) When performing fluorescence microscopy what are the stokes shift and why is it better to have fluorochromes with a large stokes shift? E) What is photobleaching and what is done when imaging histological samples to overcome it when performing fluorescence microscopy?
Label the parts of the microscope on the diagram below: arm, stage, base, ocular, revolving nosepiece, objective (4x, 10x, 40x), course focus, fine focus, condenser & iris diaphragm (these are marked by the same line)
Rowena was tasked to measure the actual magnification of her specimen mounted on a slide without drawing or taking a photomicrograph. Which type of microscope should she use? Why? How does it help her get the actual magnification?
It is desirable that the microscope objectives be parfocal because the specimen will be .................. a)blurry due to the changes in the refractive index of the medium b)stay in focus when the light is turned off c)have more contrast and enhanced details d)remain in focus if the magnification is changed e)none of the answer choices
If a microscope has a 40x objective lens in place and a 15x ocular lens, the total magnification of the microscope system under these conditions is _____. a) 600x b) 2.7x c) 55x d) 30x
If you were trying to visualize living organisms without staining, which type of microscopy would be best to utilize? O 1) brightfield O 2) TEM 3) fluorescent O 4) confocal O 5) phase contrast
What’s the aim of using a microscope for examining? What can the kohler illumination technique tell us? What are the sources of error that can impact the data ?
a) Briefly describe the concept of and instrument configuration for confocal microscopy. b) How do confocal and conventional microscopy compare? c) What other microscopy techniques can provide super-resolution?
Assume you are observing the diatom pictured in Figure 1 using the 10X lens in a compound light microscope. You move to the 40X lens and then again to the 100X lens by only rotating the turret (remember that the lenses are parfocal), without making any other adjustments to the microscope. c) After making your adjustments, you notice that the midline of the diatom is in focus while the remainder is blurry. Explain, based on microscopy principles, why this has occurred Provide a description of the procedure to prepare an acidic stain of bacteria using Nigrosin as it would appear in the Methods section.