Physics Please solve the following question and include a section showing the formulas that would be used also please include units in each part of the answer. Thank you for your help! A wire has an electric field of 6.2 V/m and carries a current density of 2.4 x 10^8 A/m2. Show that its resistivity is 2.6 x 10^-8 Ω*m without using this formula, ?=?/?!

Physics Please solve the following question and include a section showing the formulas that would be used also please include units in each part of the answer. Thank you for your help! A wire has an electric field of 6.2 V/m and carries a current density of 2.4 x 10^8 A/m2. Show that its resistivity is 2.6 x 10^-8 Ω*m without using this formula, ?=?/?!

University Physics Volume 1

18th Edition

ISBN:9781938168277

Author:William Moebs, Samuel J. Ling, Jeff Sanny

Publisher:William Moebs, Samuel J. Ling, Jeff Sanny

Chapter1: Units And Measurement

Section: Chapter Questions

Problem 15P: Use the orders of magnitude you found in the previous problem to answer the following questions to...

See similar textbooks

Similar questions

Make a VIRP table and complete it by measuring the voltage across each resistor and the power supply and measuring the current through each resistor and the total current and the total power coming out the power supply. Set your power supply to 12 V. Provide evidence that your table information is reasonable. Write down your reasoning and show your calculations. Figure A R1 = 100 Ω R2 = 90 Ω R3 = 105 Ω NOTE: only focus in writing the reasoning of the calculations. Put them into words. Thank you!
Directions: Solve the following problems below. Show your complete solution. Use the Rubric as your guide in answering. The rubric shall be used by the teacher in checking your answer. Use a separate sheet of paper for your answer 1. Compute the resistance of a hardened copper rod 2 meters long and 8 mm in diameter if the resistivity of the material is 1.756 x 10-8 ohm-meters. 2. A 0.500-meter length of wire with a cross-sectional area of 3.14 x 10-6 meters squared is found to have a resistance of 2.53 x 10-3 ohms. According to the resistivity chart, from what material is the wire made?
What to do: Answer the following problems. Write your solutions in a separate sheet of paper. 1. Compute the equivalent resistance of the network in the circuit shown below. Show the steps in reducing a combination of resistors to a single equivalent resistor. The source of emf has an negligible internal resistance. E = 18 V, r = 0
Directions: Solve for the given problems. Show your complete solutions. Express your final answers into 3 significant figures. The terminal voltage of the battery in figure 4 is 16.6 V. What is the resistance R of the external resistor? What is the internal resistance r of the 18.0-V battery? What should be the diameter of an aluminum wire for its resistance to be equal to that of a copper wire which diameter is 2.17 mm? The two wires are of the same length. ρ (Copper) = 1.68 x 10-8 Ωm ρ (Aluminum) = 2.65 x 10-8 Ωm
Solve the following problems below. Show complete solution. 1. A copper wire is 2.50 m long and has a diameter of 2.5 mm. How much current will itdraw when connected to 3.5 V source? 2. An electromotive force of a cell is 3.85 V and is connected to a load of 4.25 Ω, the voltagedrops to 2.0 V. Find the current and internal resistance of the cell.
Activity #3. Quantitative Problem Direction: Solve the problem as directed. Show your solution and write your answers on the box. (1) A silver wire 1.00 mm in diameter transfers a charge of 65.0 C in 1 hr. 15.0 min. Silver contains 5.0 x 1028 electrons per cubic meter. What is the current in the wire? What is the magnitude of the drift velocity of the electrons in the wire? CONCEPTS
Answers to the following question will be relevant for the in-labs. Please note your answers when going in for the main lab session. 3. Ohm's law can be sated as V = IR. a. Suppose in an experiment, data is collected of the variation of current with resistance R. Next a plot of R vs I'is made. How does one determine the value of V from that graph? (Explain your answer using an appropriate expression.) b. Instead of measuring resistance suppose that in (a) data of the variation of current with the length of wire is collected. Show how such data can be used to determine the resistivity of the wire.
Describe two different arrangements of resistors that would each have a total resistance of about 500Ω, as instructed below. Be specific about what resistance values you would use in each arrangement based on what is available in the course lab kit. a) Describe an arrangement using resistors connected to each other in series. b) Describe an arrangement of resistors connected in parallel with each other. Resources : 2k ohms resistor 1k ohms resistor 330 ohms resistor
Solve systematically and completely. Highlight final answers. A power supply has an output of 12 volts. A group of three resistors in series is connected to its terminals. Two of the resistors have resistances of 3Ω and 1Ω while the third is unknown. A voltmeter connected across the unknown resistance reads 6 volts. Determine a) The unknown resistance. b)The total current through the resistors. c)The voltage across the 3Ω resistor. d) The voltage across the 1Ω resistor.
In the schematic below two batteries are in series and drive current through the circuit as shown. The first resistor has a voltage drop AV1= 2 V, the middle resistor has a resistance of R = 69 Q, and the last resistor has a voltage drop AV2 = 1.1 V. Given these parameters, what is the magnitude of current flowing through the circuit in milli-amps (mA)? Giver your answer to 3 significant figures. 3.0 V 4.5 V AV.
Problem solving. Show your solutions every question. 1. A battery is connected across a light bulb with an internal resistance of 80 ohms. Using an ammeter, the current flowing in the circuit was measured to be 150 mA. What is the voltage of the battery? 2. A hair dryer pulls a current of 8000 mA from a 120 V power source. What is the internal resistance of the hair dryer? 3. What is the value of voltage in the picture?
The following three questions refer to the figure below. a) Calculate the current through R₂. Use the following values: &,-8.1 V, ₂-6 V, R=R₂=7.90 and R₂ =2R₂. Enter your answer accurate to two decimals figures. E₂ R₁ ww E1 O a. 0.51 O b. 0.26 O c.0.34 O d. 1.03 R₂ www R3 a bl