Name the type of reaction and balance the equation: STATE TYPE OF REACTION 1. NH3+ (NH.),SO, 2. РЬ + H3PO4→ H2 + Pb3(PO4)2 3. C7H6O2 + CO2 + H2O KOH + Co.(ROJ. K.POut ColOH)

Q: How to get pKa and concentration ratio of protein in solution?

A: To determine pKa pH=−log[H+] pOH=−log[OH−] pKa=−log[Ka] pKa =pH+pOH The pKa is the negative logarith...

Q: 7-4. Temperature-Dependent Viscosity Suppose that the liquid film in Fig. 7-4 has temperature variat...

A:

Q: g. Li + ¿n → je + 소He + h. 1K 37 + je i. 235U + in _ồn + 31 + 39Y

A: Given that :there are 3 reaction given we have to complete the following reaction 

Q: How many grams of NaCl are present in 1263 ml of a 1.09 M solution?

A: Molarity is defined as the number of moles of solute present in a unit volume of solution. molarity ...

Q: A benzene toluene feed with 40 mole % benzene is at 40°C. The specific heat of the feed is 159.2 kJ/...

A: Given Details: Temperature of Feed, TF=400C=40+273=313 K Specific Heat of Feed, CP,L=159.2 kJ/kmol.K...

Q: The exothermic elementary liquid-phase reaction (Rawlings and Ekerdt, E6.1) A +B → C r = KCĄCB is ca...

A: Given

Q: 12) Which of following value is Cp, m of oxygen? (a) 6R (c) 7/2R (b) 6.5R (d) 7.5R

A:

Q: Estimate S° in mg BOD,/ 6.11 The rate of consumpti of cells when S =5 mg/l anc What are ĝ and K?

A: Here, S = concentration of rate limiting substrate Rate of substrate utilization,

Q: A feed stream containing 15% wt solids and 85% wt water is introduced in a certain process where the...

A: Here it is given that feed having 15 %wt solid and 85  % wt water residue has 13 water by mass

Q: The equilibrium constant of the reaction 2 X (g) = Y (g) + Z(g) is found to fit the expression Ink =...

A:

Q: In smokehouse processing of sausage meat, a final temperature of 155°F inside the sausage is often u...

A: Given that, Temperature = 155oF It is required to calculate this temperature in oC, K, and oR.

Q: 4. A buffer is prepared containing 1.00 M acetic acid and 1.00 M sodium acetate. What is its pH?

A: Given that for a buffer solution, Concentration of acetic acid [CH3COOH] =1.00 M Concentration of so...

Q: Natural Gas with an analysis as follows: CO2 = 0.4 %, , CH, = 97.3 % , N2 = 2.3 % is burned in a fur...

A:

Q: A mixeture of Oetane (C8H18) and heptane(c7H16) ( Ycotie O.80), reacts 200 þercent theoretical air. ...

A: (i) Basis 100 moles of feed Hence, octane = 0.8 x 100 = 80 moles heptane = 0.2 x 100 = 20 moles We k...

Q: A feed stream containing 15% wt solids and 85% wt water is introduced in a certain process where the...

A: mass of product=100g product has one-third of water by mass the ratio of solid and preservatives=4:5...

Q: Why understanding gas and vapors in a work setting is important and what we can do in our workplace ...

A: 1-Importance of understanding of gas and vapors in a work setting 2-To prevent from accidents with g...

Q: It is desired to cool 2000Kg/h of aniline from 95ºC to 60ºC in a double tube exchanger that has an a...

A:

Q: CA, T, F, Reagent Teo A. T, F Product refrigerator

A:

Q: 4. Experimental data shows the water-alcohol proportion at 60°C Mole fraction of 0.00 0.05 0.27 0.44...

A:

Q: Benzene is diffusing through a slab of air 1 cm thick at 25ºC and 2 atm. The partial pressure of ben...

A:

Q: 2. Calculate the molar volume of saturated liquid (use SRK equation) and the molar volume of saturat...

A: The SRK compressibility factor correlation is used for saturated liquid to obtain the compressibilit...

Q: A water from Agno River is pumped at 13.3 L/s using a submerged pump at an efficiency of 78% that is...

A:

Q: An unknown metal Y has a density of 655.2 lb per cu. ft. The edge of the FCC unit cell of the said m...

A: Given data: Density of unknown metal = 655.2 lb/ft3 Edge length = 4.09 A0

Q: P2C.4 From the following data, determine A,H® for diborane, B,H,(g), at 298 K: (1) B,H,(g) + 30,(g) ...

A: The enthalpy of formation of diborane is as follows  

Q: Consider the dissociation of Hydrogen Sulfide: 2 H2S (g) 2 H2(g) + S2 (g) (endothermic reaction) %D ...

A: Giventhe endothermic reaction 2H2S(g)⇔2H2(g)+S2(g)To answerwhat is the effect of removal of H2S from...

Q: Imagine that a stream of fluid in steady-state flow serves as a heat source for an infinite set of C...

A: The heat is obtained from heat capacity and difference in temperature . The entropy change is obtain...

Q: Give a brief explanation about sugar(glucose) from sugar cane, about its chemical process,background...

A: Process Flow Diagram for sugar from sugar cane:

Q: Water condenses on the surface of an industrial reactor. An endothermic process in the reactor absor...

A: Given data: Rate of energy absorbed by the reactor = 50 kW Temperature of condensate = 5 0C Temperat...

Q: Consider a closed vessel initially containing 1 mol of pure ethyl acetate at 70°C and 86 kPa. Imagin...

A: Pressure = 86 KPa Temperature 70 oC Ethyl acetate boiling point = 76 oC Ethanol boiling point =77 oC...

Q: A sunflower oil is reacted with sodium hydroxXide. The re overall system with a tubular bowl centrif...

A: Answer: Given data; A sunflower oil is reacted with sodium hydroxide. The reacted oil is then separa...

Q: B: Define the coordination number and its value for BCC unit cell.

A: Given data Define the coordination number and its value for BCC unit cell.

Q: Pyrite Fines containing 85% FeS2, and 15% gangue are charged to a burner. An analysis of the cinder ...

A: (1) Given, Pyrite fines has 85% FeS2 and 15% gangue.   Assume the mass of pyrite fines be 100 g mole...

Q: The cross-sectional area of a body is its total surface area. (A True B) False

A:

Q: n the gas phase reaction, 2A + B = 3C + 2D, it was found that when 0.8 mol A, 2.1 mol B and 0.9 mol ...

A: Given reaction is - 2A+B⇔ 3C + 2D Now, initial concentrations are- [A]=  0.8 mol [B]= 2.1 mol [D]= 0...

Q: Hard magnetic materials have low coercivity, low remanence, low permeability high coercivity, high r...

A: Hard magnetic materials: Hard magnetic materials have high anisotropy field, high coercivity and lar...

Q: Synthetic Natural Gas (SNG) has a molar composition of 96.59% CH4, 1.9% CO2, 1.29% H2, and 0.22% CO....

A: Note: We are authorized to answer three subparts at a time, since you have not mentioned which part ...

Q: Example 2.1 : Calculate the rate of heat loss Q, through a wall of red brick [k = 0.70 W/(m·K)] 5 m ...

A:

Q: A reaction with stoichiometric equation 1/2A + B = R + 1/2S has the following rate expression, − rA ...

A: The consumption rate of reactant in the reaction is the rate of reaction. We can also say the rate o...

Q: 9) The IUPAC name for the following compound is -- * CH-CH-CH-CHз CH2=CHCHC=CCH3 O 3-butyl-1-hexen-3...

A:

Q: A worker splash fills hexane (MW: 86.18; TLV-TWA: 50 ppm) into a 2642-gallon (i.e., 10 m³ volume) ve...

A: Given, Molecular weight of Hexane, M=86.18 Volume of vessel, VC=10 m3 Time required at a constant fi...

Q: Determine the simplest formulas of the following compounds. (a) the food enhancer monosodium glutama...

A:

Q: Liquid- and Vapor-like Roots What is the molar volume of saturated liquid 1-Butene at T = 300 K and...

A: The general form of the equation of state for liquid-like root and vapor-like root is considered. Th...

Q: Q8: Below is a unit cell for a hypothetical metal. (a) To which crystal system does this unit cell b...

A: a)Unit Cell:  A unit cell is the smallest part of a crystal lattice that displays the complete cryst...

Q: 1:58 Pn 0.00 Vo $4G KB/S LTE +91 70071 35631 Today, 12:18 pm Chap. 11 Problems 333 Then determine th...

A: For the given flow diagram, obtain the overall mass balance. Overall mass balance means the mass or ...

Q: Technologies available for different processes of nuts as agricultural products

A: Dear User ! Since this question has a wide scope , as there are various types of nuts agriculturally...

Q: For a fuel with the following composition, 0.142 C2H(2*2+2) + 0.071 C6H(2*6+2) + 0.212 C5H(2*5+1)OH ...

A: Given data: Composition of the fuel is as follows: C2H6= 0.142 C6H14 = 0.071 C5H11OH = 0.212 C8H18= ...

Q: When a-iron is subjected to an atmosphere of hydrogen gas, the concentration of hydrogen in the iron...

A: Given data: Exponential factor = 4.8×10–7 m2/s Activation energy = 15 kJ/mol Thickness of membrane =...

Q: 2. The two graphs shown below represent the distillation results for two different distillations. Di...

A: 2. The approximate boiling points of the components are to be mentioned.

Q: The moisture content of wood is reduced from 40% to 5% using a dryer. Calculate the amount of evapor...

A: Given: Moisture content initial=0.4 Moisture content final=0.05 weight of wood =1 kg Required to fin...

Q: One kg of steam with a quality of 35 percent is heated at a constant pressure of 1400 kPa until the ...

A: Given that :m =1kg x =0.35 P =1400 KPaT = 1100 C