MCB pectrophotometry Pre-lab Question: Calculations for Pro Standard Curve Please complete the table below and show ALL calculations in your notebook! Note that the stock solution of Lysozyme is 2.0mg/mL LYSOZYME STANDARDS Tube Volume Volume Final Final Amount of of (HL) Volume LysozymeLysozyme dH20 (HL) 2.0mg/mL | Concentration (ug/mL) (in μg) in 100 μし of (uL) Lysozyme stock 100 μしof | 100 μし | 2,000 μg/mL | 200 pg stock stock stock stock stock stock stock stock

Q: Put the steps in order to make 100 mL of 2.00×10-4M from 2.00×10-2 M solution of NaSCN. You have…

A: In order to prepare a 100 mL of 2.00×10-4 M, the given solution, 2.00 ×10-2 M is diluted. First the…

Q: I need help finding the therotical yield from this video. I tired it and i got 2.49 grams I do not…

A: The balanced chemical equation for the formation of Grignard reagent is: Bromobenzene(C6H5Br) +…

Q: already took

A: Dear student this question is related to Mathematical errors in chemistry.

Q: Two different laboratories within a company further studied the morantel recovery percentage in…

A: Given data:

Q: A. Standardization of Sodium Hydroxide (NaOH) Solution 3 Trial 1 126.2 125.7 512 264mL Trial 2 Trial…

A: #B: analysis of an unknown acid: We have to use the molarity of the standardized NaOH obtained in…

Q: Styles Editi Please calculate the final maltose concentrations for the tubes you created today.…

A: To Calculate the maltose concentration in diluted solution , we would use given equation.

Q: A Bottle roll test was conducted on 2 kg of a soil sample at 50% solids. 50 g of the tailings was…

A:

Q: 2. Some possible sources of experimental error are listed below. Tell whether the error would make…

A: 1.No effect  2.too high  3.too high  4.too low

Q: In the vapor deposition method, solids are usually converted into solutions using their solvents. *…

A: A question based on general chemistry that is to be accomplished.

Q: fn control option command MODULE Science 7 in your notebook. GIASU: mulov solution that is 2% boric…

A: Calculation of above questions is given below.

Q: Give other 5 examples of laboratory task stating its potential hazard and recommended PPE.

A: Five examples of laboratory hazards, 1. Fire/Explosions In a research facility, all synthetic…

Q: Formulate a ton mixture of complete feed containing fescue hay (50% TDN) and cracked shelled corn…

A: According to the problem, we have a ton mixture of complete feed containing hay and corn. 1 US ton…

Q: Matching Type Force a liquid (mobile phase) through the liquid chromatograph at a specific flow rate…

A: Forces a liquid (mobile phase) through the liquid chromatograph at a specific flow rate = Pump…

Q: Materials and detailed methods:  paragraph or two explain how the experiment was done  Raw Data:…

A: Diels -Alder reaction takes place in reactions between conjugated diene and an alkene. In this…

Q: The labware we used in Quant Lab is divided into “qualitative” or “quantitative” analytical purpose.…

A: “Since you have posted a question with multiple sub-parts, we will solve first Five subparts for…

Q: The melting point of various ratios of mixtures of urea and acetaminophen) were determined and the…

A: We will plot concentration (%) on y axis and melting point on x axis. Moreover, the melting point…

Q: Test Tube Volume Volume of Water Added Syringe Reading (mL) V w Total Air Volume Trial (mL) V t (mL)…

A: Boyel's law : It states that the temperature always remains constant when the volume of given mass…

Q: Vitamin C Analysis, a student accidentally puts 1.0 g of sodium bicarbonate (NaHCO3) solid into the…

A: The sodium bicarbonate (NaHCO3) solid is a base which neutralises the acid in the reaction. Hence it…

Q: 1. Samples that should not be stored should be prepared/analyzed as soon as possible, especially for…

A: 1. Answer - The correct option is (c) Conductivity According to the question -  Samples that should…

Q: ulate uie imolanty of 100 fmg oi Caco3 (Imol Wi. 100) in 10 mi of water. b. How many grams of CaCO3…

A:

Q: Compute for the initial dilution of tube #1 and final dilution of tube #5.

A: It contains 0.9 mL of saline and 0.1 mL of serum. Total volume = 1 mL So, we have 0.1 mL of serum in…

Q: Please answer the average and Standard Deviation of each asap. I really need this.thank you

A: Average value and standard deviation given below.

Q: The total amount excreted into urine as unchanged drug after an oral tablet (A) of 50 mg was 36.4…

A: The term bioavailability means the amount of concentration available in systemic circulation after…

Q: Two different laboratories within a company further studied the morantel recovery percentage in…

A:

Q: A cvg.cengagenow.com/ilrn/takeAssignment/takeCXPCompliantActivity.do?locator%3Dassignment-take…

A: The aluminum in a package containing 77 ft2 of kitchen foil weighs approximately 19 ounces.  Density…

Q: Standardization of Sodium Thiosulfate Solution Primary Standard used: Potassium Dichromate…

A: The formula of potassium dichromate is K2Cr2O7

Q: Active Dosage Form Raw Materials Actual Yield Formulation Packaging Ingredient 500 mg per 3 kgs.…

A: In a balanced chemical reaction number of all the atoms of various elements present in the reaction…

Q: Using C1V1=C2V2

A: The table given is,

Q: Please provide a detailed solution for the following question You have constructed a standard curve…

A:

Q: A chem acetone, tetrahydrofuran, glycerol, carbon tetrachloride, and diethylamine. rking as a safety…

A: Since density is defined as the mass of substance per unit of volume  Hence density = mass / volume…

Q: A bacterial culture was grown for 12 hours. At 4-hour interval, the culture was sampled to determine…

A: Dilution refers to decrease in concentration of solution. It is accomplished by taking a sample of…

Q: Value Number of sig figs 301.50 0.0500 2650 7.560 x 1023

A: To determine the number of significant digits .

Q: m doing lab report for thin layer chromatography right now, but I'm struggling with a question about…

A: TLC is used in organic synthesis to know whether the reaction is completed or not . And the no of…

Q: PLEASE ANSWER THE FF: - CLINICAL CHEMISTRY    1.The main programs of the quality assurance…

A: The solution is given below -

Q: Caffeine, benzoate, and aspartame content of mountain dew soda was determined using reverse phase…

A: Given: Concentration of standard Caffeine used = 0.70 mg/mL Concentration of standard Benzoate used…

Q: Environmental chemistry question. Please answer with steps/details both questions 1) The National…

A: Note: As it is a multiple independent questions ,the solution to only first question is provided.If…

Q: False A volumetric pipet should 'not be "blown out" to eject all liquid at the tip. Volumetric…

A: A volumetric pipet should not be "blown out" to eject all liquid at the tip. Volumetric pipets are…

Q: If the volume used to make 100 mL of std 1 is 2 uL what is the concentration in M used to make std…

A: Concentration of std 1 is 16 ppm.

Q: Two methods were used to measure the arsenic level (ppb) in drinking water. Quantity Mean arsenic…

A: First, we need to calculate the F value and T-value, and compare the standard deviations for the two…

Q: Question attached

A: Vivarin tablet contains caffeine. The percentage of caffeine isolated or recovered can be determined…

Q: The aspirin we made in lab gad 125-133 melting point and I attached the IR. Base on this…

A: The structure of aspirin is: It has the following major peaks in IR spectrum: vOH = 3100-3300 cm-1…

Q: Suppose Megan needs to transfer 5.00 mL of a liquid with high precision and accuracy. Which of the…

A:

Q: Determine the relationship between the observed/apparent value (EX) VERSUS that of the true value…

A: Determine the relationship between the observed/apparent value (EX) VERSUS that of the true value…

Q: Following the Kjeldahl procedure, calculate the % protein content of a flour sample by considering…

A: % N  = [(ml of standard HCl -ml of blank HCl)*N  of HCl* atomic weight of N / weight of sample in…

Q: Categorize each as a determinate or an indeterminate error and further classify determinate errors…

A: A question based on tools in analytical chemistry that is to be accomplished.

Q: Q5: Select the correct answer for the following multiple-choice questions: 1. Asphalt penetration…

A: The penetration test was first invented by Barber asphalt paving Company in 1888. The principle of…

Q: for 20 minutes. Then return, put it down, and weigh yourself immediately three times. Since…

A: Quantitative Analysis: It deals with the determination of how much of one or more component is…

Q: be administered at a rate of 75 gtts/min using a microdrip set that delivers 60 gtt/mL. How long in…

A: Given: Flow rate       = 75 gtts/min Drop factor   = 60 gtts/mL Total volume = 250 mL

Q: What is the precision of a 100-mL beaker? " 100ml APPROX 80 100ml 60 40 20 + 10 O + 20 What is the…

A: Precision is the degree of exactness with which the object is measured.  Generally, a smaller value…

Q: SERIAL DILUTION: PROBLEM SOLVING. Set up five (5) tubes on the test tube rack and label them 1-5.…

A: Let us consider the serum concentration to be a M

Environmental Pollution

Environmental pollution occurs due to some unwanted alteration in the surroundings which results in unfavorable effects on all organisms of that surrounding.