Lesson= Second Order Transient Response A 24-V battery is connected in seires with a 1-Henry (inductor), 8-ohms resistor and a 1/17 Farad ( capacitor) with when the switch is turned “on” at t = 0. Then, what will be the value of the current at t = 0.001 sec.

Lesson= Second Order Transient Response A 24-V battery is connected in seires with a 1-Henry (inductor), 8-ohms resistor and a 1/17 Farad ( capacitor) with when the switch is turned “on” at t = 0. Then, what will be the value of the current at t = 0.001 sec.

Delmar's Standard Textbook Of Electricity

7th Edition

ISBN:9781337900348

Author:Stephen L. Herman

Publisher:Stephen L. Herman

Chapter21: Resistive-capacitive Series Circuits

Section: Chapter Questions

Problem 7RQ: An RC series circuit is connected to a 120-V, 60-Hz power source. The resistor is 25 and has a...

See similar textbooks

Related questions

Q: a) It is applied direct current to RC circuit. Which figure does belong to power supply, which…

A: a)we need to identify and explain which figure belongs to power supply and which one is for…

Q: Electrical Engineering --question 1-- Calculate the theoretical voltages across the resistor and…

Q: 2.) An uncharged capacitor in series with a 120-volt voltmeter of 12,000 ohms resistance is suddenly…

A: The solution is given below.

Q: R4 S2 S1 iT R5 R6 +HE + RIZ ic2 C3 VT C2: C1 V1 R2 SR3

Q: Q1) Design of lead copmpensator to obtain the required response of damping ratio=0.2 &Wn=5.1.

Q: A) Transient Response of Electric Circuits 1- For a series RL circuit supplied from a voltage…

A: Hello. Since you have posted multiple questions and not specified which question needs to be solved,…

Q: A coil of 20 ohms resistance has an inductance of 0.2 H and is connected in parallel with a 100…

A: Circuit will act as non inductive resistance at only resonant frequency.

Q: A current of 5 A is supplied to a 400W discharge lamp at upf. Find the inductance of the coil…

A: The given data is as follows:-

Q: Q.9: The initial charge on the capacitor is 100µCoulomb: 1. Write the transient curent equation. 2.…

A: Using kvl obtain the differential equation governing the system. Solve the differential equation to…

Q: An RL circuit has an emf given (in volts) by 4 cos t, a resistance of 100 ohms, an inductance of 4…

Q: 41. A fluorescent lamp (commonly known as tube light) employs a choke coil (an inductor) and a…

A: The voltage drop in an element is given by the current through it multiplied by the impedance. The…

Q: Consider the circuit shown in the Figure, if Is = 11 A, R1=5Q and R2 = 30, the energy stored in the…

A: Given circuit

Q: I In the circuit below, find the value of the voltage across the capacitor assuming that the value…

A: We need to determine the current through the inductor.

Q: A resistance of 20 Q and an inductance L are connected in series with a constant voltage of 100V.…

Q: A battery providing a constant voltage V = 10 V is connected to two resistors R = 10 Q and RL = 10 Q…

Q: v(t) = -3e-3t V and i(t) = 4 + 2e-3t A fort >0

A: Designing a circuit can be done in multiple way. It is depend on the designer and their knowledge.…

Q: 2. series RLC circuit has a resistance of 60 ohms, a capacitance of 10-2 Farads, an inductance of 5…

A: Series RLC circuit has the following parameters : R=60 ΩC=10-2 FL=5 Happlied voltage=20sin5t volts =…

Q: A series circuit consisting of an inductor, a resistor, and a capacitoris open. There is an initial…

A: Write the given values of the voltage drops across the elements. VR=4dqdtR=4 ΩVL=2didt=2d2qdt2L=2…

Q: Example (5): In a variable capacitance transducer the diaphragms are 20 mm in diameter and 4 mm…

Q: Determine v, i, and the energy stored in the capacitor and inductor in the circuit of circuit shown…

Q: Eudora is observing a certain circuit consists of an inductance of 0.05 henry having a resistance of…

Q: Find the energy (in microjoules) stored in the inductor at 5 ms. e.) Find the maximum energy 9in…

Q: The circuit shown in the figure consists of ideal batteries ɛ, =20V and E2 =20V, resistors R =6002,…

A: Given circuit, Now, E1+E2-qc+qc-iR=040-2q10mF-dqdt×600=0 By solving above equation, q=q01-e-tς…

Q: A coil has a time constant of 1s and an inductance of 10 H.Find (1) the value of current 0. 1s after…

A: Circuit shown is actually a simple RL circuit with source provided So it has steady state values...

Q: 1. Plot the waveform of VL, IL, and VR for the following circuit for both the storage phase and the…

A: In this question, We need to plot the waveform of the voltage across the inductor, resistance and…

Q: Consider a series RC circuit as in the figure below for which R = 3.00 MN, C = 4.00 µF, and E = 29.0…

A: For the above-given circuit Time constant is determined as shown below

Q: 2. Eudora is observing a certain circuit consists of an inductance of 0.05 henry having a resistance…

A: In this question, Find the current I and charge Q at steady state conditions. If R= 45 ohm L =…

Q: A capacitor is charged to a potential of 12.0 V and then connected to a voltmeter having an internal…

A: Given: Initial potential of capacitor V0=12 V Internal resistance of voltmeter R=3.4 MΩ At time t=4…

Q: Eudora is observing a certain circuit consists of an inductance of 0.05 henry having a resistance of…

A: GivenResistance R= 20 ohm Inductance L= 0.05H, Capacitance C= 100uF. Voltage V= 100cos(200t)…

Q: An inductor of 5H, a resistor of 20ohms, and a capacitor of 20mF are connected in series with a…

Q: For the circuit shown below, find an expression for the voltage drop across the inductor after the…

A: Find the current through the inductor for t < 0.

Q: A coil of 50 W resistance and 0.15 H inductance is connected in parallel with a capacitor of unknown…

Q: Capacitors are connected, one at a time, to the terminals of a 60-Hz, 12-V power source. Calculate…

A: From the Question Capacitors are connected, one at a time, to the terminals of a 60-Hz, 12-V power…

Q: Using a simple series circuit with an inductor with inductance L and a resistor, R connected across…

Q: Lesson= Second Order Transient Response A 24-V battery is connected in seires with a 1-Henry…

Q: Fill in the blanks add, capacitance, charge capacity, dielectric, dissipate, electrical circuits, ,…

A: The solution is as follows.

Q: Att<0, a 360-nF capacitance is charged to an unknown voltage Vị. The capacitance is in parallel with…

A: A parallel RC circuit Initial capacitance have Vi voltage. If voltage across the capacitance at…

Q: 1. Here you see a circuit with a battery, fully uncharged capacitor, C and a bulb. What would happen…

A: " Since you have asked multiple questions, we will solve the first question for you. If you want an…

Q: 1. A cardiac defibrillator is used to shock a heart that is beating erratically. The capacitor is…

Q: An uncharge capacitor in series with a 120-volt voltmeter os 10,000 ohms resistance is suddenly…

Q: A series circuit has a capacitor of 0.25 x 10-0 F, a resistor of 5x 10' 2, and an inductor of 1 H.…

Q: The circuit shown in the figure is in steady state, when the switch is closed at t= 0.Assuming that…

A: Given circuit is - Given that switch is closed at t = 0.

Q: What is a Linear Circuit? Simply we can say that the linear circuit is an electric circuit (Links…

A: Given & to find: Is it possible to apply the superposition theorem to the nonlinear circuit? If…

Q: 5. An RC (DC) circuit consists of a Resistor with a resistance of 25000 2 and Capacitor in series…

Q: btain the expression of the voltage across the capacitor from the Experiment when the circuit is…

A: Given Data: R = 10 k C = 10 uF Vs = 5 V

Q: An RC circuit has an emf of 100 volts, a resistance of 5 ohms, a capacitance of 0.02 farad, and an…

A: 1st we will find out voltage across the the capacitor then we will find out the charge on capacitor…

Q: 8.23 At t=0 s, a 100-V source is switched in series with a 1-k2 resistor and an uncharged 2-μF…

A: In this question we will find time required by capacitor to reach it's maximum value....

Q: A capacitor has a capacitance of 10 µF and a phase difference of 10°. It is inserted in series with…

A: Given,Capacitance (C)=10 μF=10×10-6 FPhase difference =10°Voltage =200 VFrequency = 50 HzR=100 Ω

Question

Lesson= Second Order Transient Response

A 24-V battery is connected in seires with a 1-Henry (inductor), 8-ohms resistor and a 1/17 Farad ( capacitor) with when the switch
is turned “on” at t = 0. Then, what will be the value of the current at t = 0.001 sec.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

An RC series circuit is connected to a 120-V, 60-Hz power source. The resistor is 25 and has a voltage drop of 65 volts. What is the capacitance of the capacitor?
A 15-F AC capacitor is connected in series with a 50 resistor. The capacitor has a voltage rating of 600 WVDC. The capacitor and resistor are connected to a 480-V, 60-Hz circuit. Is the voltage rating of the capacitor sufficient for this connection?
An inductance coil consumes 500W of power at 10A and 110V and 60HZ. Determine the resistance and the inductance of the coil
A five-Ohm resistor is in series with a 0.001-Henry inductor and is supplied from a 10-V DC source. Solve for the current 2 milliseconds after the switch was turned on. a. 2.0000 Amperes b.1.9999 Amperes c.1.0001 Amperes d. 2.0001 Amperes
For the network shown in figure (3), if the switch is closed for 2usec and then opened for Susec, find mathematical expressions for vi and in of both periods of time and then plot the waveforms of vL and i as a function of time.
Using superstition, find the value of i0 if voltage source at the left is 10, angle - 30 degrees V, and current source is 2, angle zero degrees. A total of three sources will be considered, separately. The 24 volt source is DC. When this source is acting alone, the capacitor will be open-circuited.
How temperature effect conductivity? Explain with the help of following equation. m e'n7'
C) A 25 A electrodynamic ammeter is controlled by a spring having a constant of 5.7295x 10-6 Nm/rad. The full scale deflection is 110°. Determine the inductance of the instrument while measuring a current of 20 A. The mutual inductance at 0° deflection is 4 u H and the change in mutual inductance is linear with the deflection.
1. A purely resistive circuit the current is leading by 90° with respect to voltage. 2. A purely inductive circuit the current is lag behind the voltage by 90°. 3. A purely capacitive circuit the current is lead by 90° with respect to the voltage. 4. A capacitor element stored magnetic energy. 5. An inductor element stored electrical energy. 6. Resistor elements consume power. 7. Angle between current and voltage is called power. 8. The power factor angle for a purely resistive is zero. 9. The power factor angle for a purely inductive load is -90°. 10. The power factor of a purely capacitive is leading.
A coil has a resistance of 18 when it mean temp is from 20o C to 50o C. Find its mean temp rise when its resistance is 21 and the surrounding temp is 15o C. A potential difference of 250 V is applied to a copper field coil at a temp of 15o C and the current is 5A. What will be the mean temp of the coil when the current has fallen to 3.91 A, the applied voltage being the same as before.
The magnitude of the voltage applied to the electrodes of a welding machine can be adjusted in the circuit below. In the range of minimum and maximum value that variable value resistor can take What is the time interval that the capacitor will charge from 0 to 8 V?
8 The figure is a graph of . Current Voltage the current across a voltage as a function of the potential difference through it the resistance as a function of the current across a component the current through a component as a function of the voltage across it O All three of the above (a), (b), and (c) are true O None of the above (a), (b), or (c) is true