In Tony Hawk's Pro Skater video game, a ramp at the extreme park is frictionless. Figure 1 shows a skater sliding down his skateboarding on the smooth ramp, and comes down through a height, h. h 1. Discuss the change of energy involves in this situation. 2. Estimate the necessary distance, d to stop the skateboard on the flat track withoutfalling. The coefficient of friction is u.

In Tony Hawk's Pro Skater video game, a ramp at the extreme park is frictionless. Figure 1 shows a skater sliding down his skateboarding on the smooth ramp, and comes down through a height, h. h 1. Discuss the change of energy involves in this situation. 2. Estimate the necessary distance, d to stop the skateboard on the flat track withoutfalling. The coefficient of friction is u.

International Edition---engineering Mechanics: Statics, 4th Edition

4th Edition

ISBN:9781305501607

Author:Andrew Pytel And Jaan Kiusalaas

Publisher:Andrew Pytel And Jaan Kiusalaas

Chapter7: Dry Friction

Section: Chapter Questions

Problem 7.50P: The block of weight W is pulled by the force P inclined at the angle to the horizontal. Find the...

See similar textbooks

Similar questions

The block of weight W is pulled by the force P inclined at the angle to the horizontal. Find the smallest force P and the corresponding angle that would cause impending sliding of the block. The angle of static friction between the block and the ground is s.
6.8. A driver sees a horse on the road and applies the brakes so hard that they lock and the car skids to a stop in 24 m. The road is level, and the coefficient of kinetic friction between tires and road is 0.7. How fast was the car going when the brakes were applied?
A block is pulled along a rough level surface at constant speed by the force P. The figure shows the free-body diagram for the block. FN represents the normal force on the block; and / represents the frictional force. If the coefficient of kinetic friction, HR , between the block and the surface is 0.30 and the magnitude of the frictional force is 80.0 N, what is the magnitude of the normal force FN? mg OA 410 N OB 160 N OC 1.6 N OD.4.0 NA OE 270 N
1. A force of 69N is needed to start an 6.9kg box moving across a horizontal surface. Calculate the coefficient of static friction. If the box continues to move with an acceleration of 1.69 m/s2. What is the coefficient of kinetic friction? 2. A box of 450N is lying in an inclined plane with angle of 35 degrees. If the applied load to move the box is 269N. Determine the net Ff and the acceleration of the box if the coefficient of static friction is 0.35 and the coefficient of kinetic friction is 0.28.
In a Porter governor, the mass of the central load is 18 kg and the mass of each ball is 2 kg. The top arms are 250 mm while the bottom arms are each 300 mm long. The friction of the sleeve is 14 N. If the top arms make 45° with the axis of rotation in the equilibrium position, find the range of speed of the governor in that position. 503.2
3. A block slides up a smooth (nearly frictionless) surface inclined at 12 above the horizontal. At t-0, we notice the speed is 4.1m/s. 12° a. Compute the acceleration of the block, making your force analysis clear in the picture. b. Compute the distance the block will slide up the ramp before turning around (relative to the position at t-0).
pls send me answer of this question all the parts pls and i will rate you sure, pls solve a,b,c and d and also a and b A 200-kg dragster (racing car) exerts a constant force of 4000 N during a race. The coefficient of kinetic friction between the tires and the pavement is .15. If the drag strip is 1000 m long, determine:a. The net force on the dragster. b. The acceleration of the dragster. c. The time it takes for the dragster to finish the race.d. The dragster's velocity at the end of the race.The dragster now needs to slow down, so it opens a parachute. The force of air drag is 3500 N. The driver also locks the brakes of the dragster, and the coefficient of kinetic friction becomes .75. Determine:a. How long it will take to stop the dragster.b. The distance the dragster travels while stopping.
An aeroplane required for take off speed of 80 km/h, the run onthe ground being 100m. The mass of the aeroplane is 10000 kgand coefficient of friction between the plane and ground is 0.2.Assume that the plane accelerates uniformly during the take off.What is the maximum force required by the engine of the plane fortake off.
The 300N block rests upon a level plane for which the fk is 0.20. A force P = 100N, directed at 30° from the horizontal pulls the block and moves 80m starting from rest. If the 100N force is then removed, how much further will it travel? a. none b. 48.803m c. 40.078m d. 47.800m 3. 40.780m
1. A 20 kg block is resting on a 40 degree incline. If the coefficient of static and kinetic friction are O. 20 and O. 15 respectively, what minimum force inclined 50 degrees from the horizontal is required to prevent movement? Without said preventive force, what is the velocity of the block after 5 seconds?
Q1) Yousif pushes toward the right on an 11.0 N force on the box in the opposite direction. The magnitude of the kinetic friction force between the box and the very smooth floor is 4.50 N as the box slides toward the right. Also, the magnitude of the normal force is 98 N. For the above information, find the following? a box with a force of magnitude 31.0 N. Sarah applies 6. The free-body diagram 7. The mass of the box 8. The box's acceleration in the x-direction 9. The box's acceleration in the y-direction 10. coefficient of dynamic friction Q 2) A rope pulls the block up the ramp, as shown in the figure. Find the following: 7. Draw a free body diagram for the block. 8. Write the equation that sums the forces on the block that are parallel to the ramp. 9. Write the equation that sums the forces on the block that are perpendicular to the ramp. 10. What is the acceleration of the block perpendicular to the ramp? 11. What is the friction force? a = 4.3 m/s? T = N A = 0.45 6.0 kg 0= 30°…
The two blocks started at rest. The surface of the inclined plane is frictionless. (note: neglect mass and friction of the pulley) Given: Weight of A=230 lb. Weight of B=300 Ib. Calculate: a) acceleration of A (ft/s"), 30° with the horizontal b) Acceleration of B (ft/s"), downward c) the tension in the cable (Ib.) B 30°