In Part IV of this lab, the identity of an unknown liquid will be determined by observing some of its physical properties. In lab, a student experimentally obtained the following data recorded below: Solubility in water: soluble Density: 0.785 g/mL Boiling point: 80.9 °C Using Table 1 in the lab manual, determine the identity of the student's unknown liquid. Note: Make sure to read the information box above the table! O ethyl alcohol O cyclohexane isopropyl alcohol There is not enough information to determine the identity.

In Part IV of this lab, the identity of an unknown liquid will be determined by observing some of its physical properties. In lab, a student experimentally obtained the following data recorded below: Solubility in water: soluble Density: 0.785 g/mL Boiling point: 80.9 °C Using Table 1 in the lab manual, determine the identity of the student's unknown liquid. Note: Make sure to read the information box above the table! O ethyl alcohol O cyclohexane isopropyl alcohol There is not enough information to determine the identity.

Principles of Modern Chemistry

8th Edition

ISBN:9781305079113

Author:David W. Oxtoby, H. Pat Gillis, Laurie J. Butler

Publisher:David W. Oxtoby, H. Pat Gillis, Laurie J. Butler

Chapter11: Solutions

Section: Chapter Questions

Problem 9P

See similar textbooks

Similar questions

Submit Previous Answers A solid mixture consists of 25.5 g of KNO (potassium nitrate) and 4.5 g of K2SO4 (potassium sulfate). The mixture is added to 130. g of water v Correct Use this solubility curve (Eigure 1) to answer the questions. Crystallization Crystallization is the opposite of dissolution. Since solids tend to dissolve better at higher temperatures, we can cause them to crystallize (i.e., undissolve) from a solution by lowering the temperature. Part B If the solution described in the introduction is cooled to 0 °C, what mass of KNO, should crystallize? Enter your answer numerically in grams. • View Available Hint(s) Figure < 1 of 1 29.65 KNO, / NH,CI Previous Answers Submit 50- Nac X Incorrect; Try Again; 6 attempts remaining 40 30 LiSO, Part C Complete previous part(s) 20 - K,SO, 10- Part D KCIO, 10 20 30 40 50 60 For which salt, K2SO,, LişSO,. KCIO,, or NH,C1, will increasing the temperature of the water have the greatest change in solubility per 100 g solvent?…
Note: The explanation of this work would be we did a work on the process of preparing diverse solution sets and regarding that these are the following sets of questions. PART: 2 What happens to the solution's concentration when you add more solute to the same volume of solvent? How to raise the concentration of an aqueous solution? When is the ppm concentration applied? What do you conclude from this lab? Was your hypothesis confirmed or not? Explain your answer.
Learning Task No. 4: Use the sample problem as a guide to help you solve the % concentration of your prepared solution. Dissolve 10.0g of a substance in 100.0g of water., the concentration by mass will be: Divide the mass of the solute by the total mass of the solution. c%=10.0g10.0g+100.0g* 100%=9.09 Solutions to make: 1. 450 g flour and 1 L water 2. 500 ml alcohol and 1 L water 3. 300 g rice grains and 540 ml water 4. 450 g sugar and 360 ml coconut milk 5. 50 ml liquid detergent and 250 ml water
Hi! I need answers for numbers 2 and 3. My professor said that The unit of solubility is in grams per 100mL, while the solvent used is only 50mL, so a yield of close to 2.0g is impossible. Recalculate using this information. Thanks!
1. ASSERTION: The solubility of gases in water follows the order O2 < N2 < SO2 < CO2 < NH3. REASON: For appreciable solubility, the solute-solvent interactions should outweigh the solute-solute and solvent-solvent interactions. a. Assertion and reason both are correct statements and reason is the correct explanation for assertion. b. Assertion and reason both are correct statements but reason is not the correct explanation for assertion. c. Assertion is a correct statement but reason is a wrong statement. d. Assertion is a wrong statement but reason is a correct statement. 2. ASSERTION: The solubility of all gases in water decreases with the rise in temperature. REASON: The dissolution of gases in water is an endothermic process. a. Assertion and reason both are correct statements and reason is the correct explanation for assertion. b. Assertion and reason both are correct statements but reason is not the correct explanation for assertion. c. Assertion is a correct…
What is the mass of propanol present in a 3.50 molal aqueous solution of propanol, C3H7OH? The molar mass of propanol is 60.094 g/mol. Mass Solute = [?] g C3H₂OH Mass Solute (g) Copyright © 2003-2022 International Academy of Science. All Rights Reserved. DELL Enter Just Short Answer q Jefferson, Thomas
LAB VI. MOLAR MASS BY FREEZING POINT DEPRESSION • Colligative properties of a solution are properties that depend on the number of solute particles dissolved. • Colligative properties of a solution include: o Vapor pressure lowering, o Boiling point elevation, o Freezing point depression, and o Osmotic pressure. • The molar mass of a solute may be determined by measuring a colligative property of a solution. • In this experiment the freezing point of a solvent would have been determined from a cooling curve. Practice problems: • Calculate the freezing point of a solution of 800 g of ethylene glycole (MW = 62.02 g/mole) in 3,000 g of water given that the K(H2O) = 1.86 °C/m. • How many moles of ethanol are dissolved in t-butanol if the change in the freezing point is 10 °C, and t-butanol's Kr is 8.37 °C/m? How many grams of ethanol are dissolved in this solution? Calculate the freezing point of a solution of 200 g of glucose (MW = 180.096 g/mole) in 2,500 g of acetic acid, given that…