In a similar experiment, the mass of 3 PB tablets was measured to be 3.1177 g. The tablets were crushed, and 2.9862 g of the powder was transferred to a beaker and reacted with HCI. After filtration, the filtrate was transferred to a 50-mL volumetric flask and diluted with water. 10.00 mL of this stock solution was combined with 0.2 M NagPO4. The resulting precipitate weighed 0.2694 g after drying. What is the mass of BSS per tablet in mg? Round your answer to 1 decimal place.

In a similar experiment, the mass of 3 PB tablets was measured to be 3.1177 g. The tablets were crushed, and 2.9862 g of the powder was transferred to a beaker and reacted with HCI. After filtration, the filtrate was transferred to a 50-mL volumetric flask and diluted with water. 10.00 mL of this stock solution was combined with 0.2 M NagPO4. The resulting precipitate weighed 0.2694 g after drying. What is the mass of BSS per tablet in mg? Round your answer to 1 decimal place.

Chemistry & Chemical Reactivity

9th Edition

ISBN:9781133949640

Author:John C. Kotz, Paul M. Treichel, John Townsend, David Treichel

Publisher:John C. Kotz, Paul M. Treichel, John Townsend, David Treichel

Chapter3: Chemical Reactions

Section3.4: Aqueous Solutions

Problem 3RC

See similar textbooks

Similar questions

In most of its ionic compounds, cobalt is either Co(II) or Co(III). One such compound, containing chloride ion and waters of hydration, was analyzed, and the following results were obtained. A 0.256-g sample of the compound was dissolved in water, and excess silver nitrate was added. The silver chloride was filtered, dried, and weighed, and it bad a mass of 0.308 g. A second sample of 0.416 g of the compound was dissolved in water, and an excess of sodium hydroxide was added. The hydroxide salt was filtered and heated in a flame, forming cobalt(III) oxide. The mass of cobalt(III) oxide formed was 0.145 g. a. What is the percent composition, by mass, of the compound? b. Assuming the compound contains one cobalt ion per formula unit, what is the formula? c. Write balanced equations for the three reactions described.
On Easter Sunday, April 3, 1983, nitric acid spilled from a tank car near downtown Denver, Colorado. The spill was neutralized with sodium carbonate: 2HNO3(aq)+Na2CO3(aq)2NaNO3(aq)+H2O(l)+CO2(g) a. Calculate H for this reaction. Approximately 2.0 104 gal nitric acid was spilled. Assume that the acid was an aqueous solution containing 70.0% HNO3 by mass with a density of 1.42 glcm3. What mass of sodium carbonate was required for complete neutralization of the spill, and what quantity of heat was evolved? (Hf for NaNO3(aq) = 467 kJ/mol) b. According to The Denver Post for April 4, 1983, authorities feared that dangerous air pollution might occur during the neutralization. Considering the magnitude of H, what was their major concern?
Lead poisoning has been a hazard for centuries. Some scholars believe that the decline of the Roman Empire can be traced, in part, to high levels of lead in water from containers and pipes, and from wine that was stored in leadglazed containers. If we presume that the typical Roman water supply was saturated with lead carbonate, PbCO3 (Ksp = 7.4 1014), how much lead will a Roman ingest in a year if he or she drinks 1 L/day from the container?
Acetic acid (HC2H3O2) can be prepared by the action of the acetobacter organism on dilute solutions of ethanol (C2H5OH). The equation for the reaction is C2H5OH(aq)+O2(g)HC2H3O2(aq)+H2OHow many milliliters of a 12.5% (by volume) solution of ethanol are required to produce 175 mL of 0.664 M acetic acid? (Densityofpureethanol=0.789g/mL.)