If you place 1.6 L of ethanol (C₂H5OH) in a small laboratory that is 3.0 m long, 2.5 m wide, and 2.0 m high, will all the alcohol evaporate? If some liquid remains, how much will there be? The vapor pressure of ethyl alcohol at 25 °C is 59 mm Hg, and the density of the liquid at this temperature is 0.785 g/cm³. All the alcohol will evaporate. L Volume remaining =

If you place 1.6 L of ethanol (C₂H5OH) in a small laboratory that is 3.0 m long, 2.5 m wide, and 2.0 m high, will all the alcohol evaporate? If some liquid remains, how much will there be? The vapor pressure of ethyl alcohol at 25 °C is 59 mm Hg, and the density of the liquid at this temperature is 0.785 g/cm³. All the alcohol will evaporate. L Volume remaining =

Chemistry for Engineering Students

4th Edition

ISBN:9781337398909

Author:Lawrence S. Brown, Tom Holme

Publisher:Lawrence S. Brown, Tom Holme

Chapter8: Molecules And Materials

Section: Chapter Questions

Problem 8.91PAE

See similar textbooks

Similar questions

Maple syrup sap is 3% sugar (sucrose) and 97% water bymass. Maple syrup is produced by heating the sap toevaporate a certain amount of the water. (a) Describe what happens to the composition and boilingpoint of the solution as evaporation takes place. (b) A rule of thumb among maple syrup producers is thatthe finished syrup should boil about 4 C higher than theoriginal sap being boiled. Explain the chemistry behindthis guideline. (c) If the finished product boils 4 C higher than the originalsap, calculate the concentration of sugar in the finalproduct. Assume that sugar is the only solute and theoperation is done at 1 atm pressure.
Are changes in state physical or chemical changes? Explain. What type of forces must be overcome to melt or vaporize a substance (are these forces intramolecular or intermolecular)? Define the molar heat of fusion and molar heat of vaporization. Why is the molar heat of vaporization of water so much larger than its molar heat of fusion? Why does the boiling point of a liquid vary with altitude?
What is the mole fraction of H 2 S O 4 in a solution containingthe percentage of sulfuric acid and water shownin Figure 14.25?
Heat is released when some solutions form; heat is absorbed when other solutions form. Provide a molecular explanation for the difference between these two types of spontaneous processes.
What possible uses exist for the natural gas liquids that are removed from natural gas during its processing?
If you place 1.4 L of ethanol ( C2 H; OH) in a small laboratory that is 3.0 m long, 2.0 m wide, and 2.0 m high, will all the alcohol evaporate? If some liquid remains, how much will there be? The vapor pressure of ethyl alcohol at 25 °C is 59 mm Hg, and the density of the liquid at this temperature is 0.785 g/cm³. the alcohol will evaporate. Volume remaining %D
8. (a) Use the Clausius-Clapeyron equation and calculate the vapor pressure (mm Hg) of fluoroethane at -80 °C, given that the vapor pressure is 400. mm Hg at a temperature of -46 °C. The enthalpy of vaporization of fluoroethane is 23.0 kJ/mol. (b) Calculate the enthalpy of vaporization for a compound if its vapor pressure is 70 mm Hg at -50 °C and 323 mm Hg at -28 °C.
Calcium citrate; MM=498.46 g/mol, a common preservative, has a Ksp of 1.12 x 10^-15 at 25°C.
Which of the following substances will have the greatest vapor pressure at 0°C? CH4 MgO ammonia NaCl water
2. Density of AgBr is 6.47 x 10 kg/m. AgBr has fcc lattice and molecular weight of AgCl is 187.77 g/mol. Calculate lattice constant (a) for AgBr.
9). What is the boiling point of the automobile radiator fluid prepared by mixing 1.04 L of ethylene glycol (HOCH2CH2OH, density = 1.114 g/mL) with 1.08 L of water (density = 1.000 g/mL)? The Kb of water is 0.520°C/m.