If the ideal gas law (PV = kT) is used to find P when T and V are given, but there is an error of 0.3% in measuring T and an error of 0.8% in measuring V, find approximately the greastest percent error in P?

If the ideal gas law (PV = kT) is used to find P when T and V are given, but there is an error of 0.3% in measuring T and an error of 0.8% in measuring V, find approximately the greastest percent error in P?

University Physics Volume 1

18th Edition

ISBN:9781938168277

Author:William Moebs, Samuel J. Ling, Jeff Sanny

Publisher:William Moebs, Samuel J. Ling, Jeff Sanny

Chapter1: Units And Measurement

Section: Chapter Questions

Problem 75P: (a) A person’s blood pressure is measured to be 1202mmHg . What is its percent uncertainty? (b)...

See similar textbooks

Related questions

Q: Three 7.50-kgkg masses are at the corners of an equilateral triangle and located in space far from…

Q: etermine the value of force applied if work done is 202 J and value f displacement is 2.5 m

A: Given : Work "W "= 202 J displacement "d"= 2.5m Formula used : Work = force *displacement…

Q: Fa M 2) Fa = 500 N and Hk = .310. The velocity of the block is 20 m/s. What is M? a) 25 kg b) 1519…

Q: Dan Koko fell a distance of 312 feet into an airbag after jumping from the Vegas World Hotel and…

A: Given in question - Distance(D) = 312 feet Distance formula: d =…

Q: slits were 2.0 meters away from the probe. What is the distance between any two bright fringes, in…

A: Given data The slits were 2.0 meters away from the probe. The graph was made with helium-neon laser…

Q: An electric circuit has a battery with an EMF of 1.50 V. Its positive terminal is connected to its…

Q: Which of the following statements is false? (a) Gaps need to be left in lengths of railway lines…

A: (1)Gaps need to be left in lengths of railway lines to prevent buckling in hot weather It is a true…

Q: Two objects, A and B, initially at 200 K and 400 K, respectively, are brought into contact with each…

Q: proved that one characteristic of light is its ability to be polarized. A. Emil Lenz C. Etienne…

A: proved that one characteristic of light is its ability to be polarized. A. Emil Lenz C. Etienne…

Q: 1.Two bodies A and B traveling in opposite directions, pass a given point. Body A traveling eastward…

A: Given that:- After pass a given point body A moves eastward while body B moves westward.

Q: Short Essay Type. How does an RC circuit work?

A: Working of RC circuit : In an RC circuit, a combination of R (resistor) and C (capacitor) is…

Q: 10.59 . The Atwood's Machine. Figure P10.59 illustrates an Atwood's machine. Find the linear…

Q: Estimate the diameter of the bore (hole where patient enters) an MRI machine should be to have a…

A: Magnetic field inside the machine B=6.67*10-2T, number of loops of windings N=4255 and current…

Q: Based on the graphs, what happens to acceleration when the velocity is constant?

A: We have two graphs for velocities and accelerations of sprinter A and sprinter B as shown. For…

Q: Choose the correct statement regarding light traveling in air and glass mediums. Assume that the…

Q: Part I. Kirchhoff's Laws in 2 Loops. a. Find the necessary KVL/KCL equations to solve the problem.…

Q: 1.3 resistors 3002 ±5%, 5002 +10% and 1.5kN ±0.5% connected in series. Draw the circuit diagram and…

Q: 1. A Carnot engine works at high temperature 600 Kelvin with the efficiency of 40%. If the…

A: Given A Carnot engine works at high temperature 600 Kelvin efficiency = 40%. If the efficiency of…

Q: The metals are said to be the best conductors of electricity. a. Carbon b. Silicon c. Copper d. Gold…

A: Solution:- 1. Answer:- option (c) copper metals that allow electricity to flow through it easily…

Q: An ambulance moving at 35 m/s sounds its siren whose frequency is 480 Hz. A car is moving in the…

Q: 10.70 . CP A solid uniform Figure P10.70 ball rolls without slipping up a hill (Fig. P10.70). At the…

Q: Why is the sky blue

A: 1) The sky is blue due to a phenomenon called Raleigh scattering. 2)Sunlight reaches Earth's…

Q: The lens and mirror in the figure below are separated by 1.00 m and have focal lengths of +80.9 cm…

Q: An ideal gas with energy E = NKBT moves quasi-statically (i.e. reversibly) from state A to state C…

Q: A car is moving on a straight road 23 m/s. It is acceleration at 30 m/s2. What will be it's velocity…

A: Given that, Initial velocity of car, u = 23 m/s Acceleration of car, a = 30 m/s2 Time taken, t = 6…

Q: Reflection by thin layers. In the figure, light is incident perpendicularly on a thin layer of…

Q: If a bus travelling at 18 m/s is subjected to a steady deceleration of 3 m/s?, how long will it take…

Q: Determine the drag coefficient ca needed for a parachutist of mass m = 68.1 kg to have a velocity of…

Q: Two observers stand 20 m apart on a line that connects them and a spherical light source. If the…

A: Given, Distance=20m Intensity=59%

Q: An object with a mass of 640 kg falls down from a steep hill with a height of 30 meters. Calculate…

A: Given: The mass of the object is 640 kg. The height of the object from the ground is 30 m.

Q: In a phosphorus-doped silicon layer with impurity concentration of 107/cm3, hole and electron…

A: Given that The impurity concentration is = 1017/cm3 and the temperature…

Q: 11.49 • You open a restaurant and hope to entice customers by hanging out a sign (Fig. P11.49). The…

Q: In the circuit shown, the potential difference R, VA = V8 = 16.0 V and the resistance R = R2 = R3 =…

Q: Suppose a planet is discovered orbiting a distant star with 13 times the mass of the Earth and 1/13…

A: Given: Mass = 13 times mass of earth. Radius = 1/13 radius of earth.

Q: Blue light travels with a wavelength of 450 nm in air. What is its wavelength when traveling in…

Q: This time, your mass is 91.4 kg and the sled s mass is 19.1 kg. You re on the sled, initially moving…

A: Given that:- Mass of man=91.4kg Mass of sled=19.1kg

Q: 9. When a load of 10 kg is hung from the wire, then extension of 2 m is produced. Then work done by…

Q: 10-Ω resistive coil in a coffee maker generates heat energy at a rate of 1.0 kwatts. What is the…

A: Given that:- Resistance of the coil of coffee maker=10ohm

Q: A ball was thrown on a certain angle with a horizontal velocity of 20 m/s. It took 15 seconds for…

Q: 2. In a vacuum, light with a frequency of 5.0 x 1014 hertz has a wavelength of (1) 6.0 × 10-21 m (2)…

Q: Two waves of the same frequency have amplitudes 0.838 and 2.60. They interfere at a point where…

Q: f the gravitational force between objects of equal mass is 2.0 x 10 −6 N when the objects are 8.5 m…

Q: 2.3 resistors 3002 ±5%, 500 +10% and 1.5kN ±0.5% connected in parallel. Draw the circuit diagram and…

Q: A dinosaur treks at 1.9m/s. How long would it take to walk 2.5km.

Q: 5 Velocity of a particle changes from (3i + 4j) m/s to (6i + 5j) m/s is 2 s. Find magnitude and…

A: Average acceleration refers to the rate at which the velocity changes. Here, we calculate the given…

Q: 1. How many electrons are needed to form a charge of -2.00 nC?

A: Note: As per our guideline, I will solve the first question, Please post other questions separately.…

Q: 9. When a load of 10 kg is hung from the wire, then extension of 2 m is produced. Then work done by…

A: We have a load of mass m=10 kg which is hung from a wire casing an extension of h=2 m and…

Q: A beam of protons moves through a uniform magnetic field with a certain magnitude, directed along…

Q: Given.cloda Denwity 1500 k m Mass 52 kg %D Finol nelume

A: Given data : Mass = m Density = D To find : Volume

Q: A hypodermic syringe contains a medicinė with tne everywhere is 1.00 atm. A force F of magnitude…

A: area of syringe barrel = A1 = 2.82 x 10-5 m2 force = F = 1.72 N density of water = 1000 kg/m3

Question

Study of body parts and their functions. In this combined field of study, anatomy refers to studying the body structure of organisms, whereas physiology refers to their function.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step 3

VIEW

Step by step

Solved in 3 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, physics and related others by exploring similar questions and additional content below.

Similar questions

If the ideal gas law (PV = kT) is used to find P when T and V are given, but there is an error of 0.3% in measuring T and an error of 0.8% in measuring V, find approximately the greastest percent error in P? TOPIC:TOTAL DIFFERENTATION
(a) The probability that a molecule in the atmosphere is at a height between z and z + dz above the surface of the Earth is proportional to e-z/A dz (capital Greek lambda). Determine the constant of proportionality. Sketch this distribution. (b) What is the mean molecular height, i.e. the mean height of a molecule? (c) What is the variance in the molecular height? (d) What is the standard deviation in the molecular height?
a chemist is doing some measurements with a thermometer that is accurate to 1 degree k and a pressure gauge that is accurate to 2 bars. Using the equation for the ideal gas law, V=C T/P, where C is a constant and V is volume, T is temperature in Kelvin and P is pressure in bars, how far off on volume(Leave C in the problem and ignore it) can he be assuming max error on each measurement assuming he measure 13 bars and 340 degrees K?
An ideal gas, at pressure 4.9 atmospheres, in a volume 1.1 m3 and at a temperature of 308 K, is compressed into a lower volume 0.44 m3, at a pressure of 6.26 atmospheres. What is the new temperature, in K with two digits of precision?
A car engine moves a piston with a circular crosssection of 7.500 ± 0.002 cm in diameter a distance of 3.250 ± 0.001 cm to compress the gas in the cylinder. (a) By what amount is the gas decreased in volume in cubic centimeters? (b) Find the uncertainty in this volume.
A series of four measurements of g are made in the physics lab. The results of these measurements in ms2/ are: 9.63, 9.58, 9.71, 9.68. The average of these four measurements is the experimental value of g and the accepted value is 9.80 ms2/. What is the percent error of these measurements?
Your calculated density of aluminum is d = 2.7 g/cm³. The accepted value of the aluminum density is 2.70 g/cm³. The percent error (follow significant figures rules) is: Just put the number, no need for the % sign
A car engine moves a piston with a circular cross sectionof 7.500 ± 0.002 cm diameter a distance of3.250 ± 0.001 cm to compress the gas in the cylinder. (a)By what amount is the gas decreased in volume in cubiccentimeters? (b) Find the uncertainty in this volume
After carrying out repeated measurements for the pressure of a gas and making the calculations, the values 1.543780 Pa and 0.055000 Pa were obtained for the principal value and the uncertainty, respectively. The correct measurement result is: a) (1.5 ± 0.05) Pa b) (1.544 ± 0.055) Pa c) (1.54 ± 0.055) Pa d) (1.543780 ± 0.055) Pa
Evaluating the results for accuracy In an experiment, the temperature of a solution is measured by a student to be 79 degrees, but the true value of the temperature is 85 degrees. What is the percent error in this measurement? (see the appendix). Relative error: Comment on the accuracy:
1.1. Compute the density (in units of m) of an ideal gas under the following conditions: (a) At 0 °C and 760 Torr pressure (1 Torr=1 mmHg). This is called the Loschmidt number. (b) In a vacuum of 103 Torr at room temperature (20 °C). This number is a useful one for the experimentalist to know by heart (10 3 Torr 1 µ).
A pyramid has a square base of side x and height h. The volume V of the pyramid is given by the expression: V - x²h 3 If V is measured to 5% and h is measured to 3%, what is the percentage uncertainty of ? Remember to include the % symbol with your answer.