(i) Determine the currents for the electrical network shown in the following figure, using Gauss elimination: I 202 10v 20v 402 (ii) Find the volume of traffic along the arrows, using Gauss elimination: 18P 50 C. 200 100 165 200

(i) Determine the currents for the electrical network shown in the following figure, using Gauss elimination: I 202 10v 20v 402 (ii) Find the volume of traffic along the arrows, using Gauss elimination: 18P 50 C. 200 100 165 200

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter6: Power Flows

Section: Chapter Questions

Problem 6.2MCQ: For an NN square matrix A, in (N1) steps, the technique of Gauss elimination can transform into an...

See similar textbooks

Related questions

Q: The color code on a resistor in a circuit indicates a value of R = 156,000Ω.a. Express in Powers of…

A: COLOR CODING OF RESISTOR: To denote their value and purpose, components & wires are color-coded.…

Q: EXI find range that system is stable when P 70 integer R(S)- of (K) such n any Positive number. ? K…

Q: Q3: For the circuit of Fig. (2), find the current I by using Nodal analysis metho Es EMA

Q: The voltage v(t)- 24 cos(377t+75) A is connected to a 6 ohm resistor, the current through the…

A: Given, Voltage, vt=24 cos377t+75° V Connected to resistor, R=6 Ω

Q: can you please solve it in the other way like there's elimination of equations

Q: The frequency of the sinusoid V(t)=55 cos(100t+12) V is Hz 15.91 Hz 33.24 Hz 7.91 Hz 60

A: Given, Voltage signal, Vt=55 cos100t+12 V

Q: Compute the average value of the sinusoid shown in Figure 8.3, where V, denotes the peak (maxi- mum)…

A: Solution !!

Q: Sketch the root loci for the system shown in the figure below R(s) K s(s+1) (s+2)

Q: Find the unilateral Laplace transform of the following signal. (a) X(t) = e^-at ( b ) X( t ) =…

Q: R31=25 R23=75 (a) R12=50 2 R3 R1 (b) R2 De 2

Q: Evaluate VX A where A = p²z ap + p³a + 3pz² az az component ap component ao component

A: Given, A=ρ2zaρ+ρ3a∅+3ρz2az To find: Evaluate ∇×A

Q: 5. Approximately how many milliamperes of current flow through a circuit with a 40 V source and 6.8…

A: Given data, Voltage source V = 40 V, Resistance, R=6.8 kΩ = 6800 Ω

Q: For a periodic signal v(t) = 30 sin100t + 10 cos300t + 6 sin(500t + π/4), the fundamental frequency…

A: Given- V(t)=30sin100t+10cos300t+6sin(500t+π/4)To Find-The fundamental frequency in rad/s.

Q: Example 16.51. A 230V, 50Hz single phase energy meter has a constant of 1200 rev./kWh. Determine the…

A: Given: Voltage, V = 230 V Current, I = 10 A Power factor, cosϕ=0.8 lagging Meter constant, k = 1200…

Q: A 300V DC motor is running at 1600rpm taking a current of 40A. The armature reisistance is 0.5Ω. Due…

A: Given data: Supply voltage V=300 V Sheet of motor N=1600 rpm Armature current Ia=40 A Armature…

Q: Q3:-Using superposition, determine the current through the (6 2) resistor for network of Fig.2. 82…

A: Given:

Q: Load on a small power station is as under. Draw the load curve and calculate 1. Maximum demand sve…

A: We have been given an load on a power station we have been asked to Draw load curve of this power…

Q: given >=0.3j, z=0·2j, z = 0.15. Find: All Voltages and current for single - Line to ground A11 fault…

Q: b) What are the major differences between MOS and BJT transistors?

A: MOS and BJT: MOS and BJT both are semiconducting device. Both of them are also a type of transistor.…

Q: A resistance of 10 ohm, an inductor of 300 mH and a capacitor of 50 uF are connected in series. If…

Q: Fig. 37.17 shows 2-stage amplifier. What is the overall voltage gain in db? (1) 40 db (iii) 90 db…

A: Given a 2-stage amplifier,

Q: A six pole three phase induction motor runs with a synchronous speed of 1500 rpm. What is its…

A: Given, A three phase induction motor has, Number of poles, P=6. Synchronous speed, Ns=1500 rpm.

Q: To what extent does electrical grids represent both a natural monopoly and an essential facility?

A: A natural monopoly might arise from a severe need for economies of scale coupled with high fixed…

Q: A star-connected load to a 440 V, three-phase supply takes a lagging power multiplier of 20 A and…

Q: For the circuit, find RT, 1₁, 12, and 13. R₁ 6.67 0 150 V R₂ 292 R₂ m 102 R₂ w 30 1²

A: The given circuit diagram is shown below,

Q: * (switching network F F(A,B,C,D,E)=(0,3,6,7,8,12,19,20)+(2,4,11,30 None of them 10= A'D'+A'B'D…

A: Given, F(A,B,C,D,E) = ∑(3,6,7,8,12,19,20) +∑d(2,4,11,30) Design switching network using data input…

Q: Implement the following four Boolean expressions with three half adders: D=A⊕B⊕C E=A′BC+AB′C…

A: It is given that: D=A⊕B⊕CE=A'BC+AB'CF=ABC'+A'+B'CG=ABC

Q: Q3: a) Consider the modulated signal s(t) indicated below where the modulating signal is…

A: Giving a wave or signal the amplitude or frequency of another wave or signal is known as modulation.…

Q: In a certain band-pass filter, the central frequency is 14 kHz. If the bandwidth is 4 kHz, the lower…

A: Given,In a band-pass filter,Central frequency, fc = 14 kHz.andBandwidth, BW=4 kHz.

Q: An industrial electric motor has a load of 900 kW at 0.75 power factor lag. It is used for 500 hours…

Q: An 8 pole, 50 Hz, 3 phase induction motor is running at 4% slip when delivering full load torque. It…

A: We have an 3-phaes induction motor with, Pole (P) = 8 frequency (f) = 50 Hz Slip (s) = 4% = 0.04…

Q: Consider a logic function with three inputs, A, B, and C, and three outputs, D, E, and F. The…

A: It is given that: The function is defined as follows: D is true if at least one input…

Q: Q1) Consider a two point charges Q1=1 nc at (1,2,3), and Q2= 2nc at (2, 30, 90) in free space. Find:…

A: It is given that: Q1=1nC at 1,2,3Q2=2nC at 2,30°,90°

Q: Find the Laplace Transform using the Laplace Transform Pairs and the Laplace of derivatives: 1.…

Q: The maximum demand of a consumer is 25 A at 220 V and his total energy consumption is 8340 kWh. If…

A: We have been given an maximum demand of consumer and his total energy consumption we have been asked…

Q: H.W.2% For the circuit shown, determine the feedback topology & determine Ave, Rif. Rof 1.2k 6-M ·3K…

Q: A certain amplifier has r.m.s. output voltage of 10 V. What is the r.m.s. output voltage for gain…

Q: Find the laplace transform

Q: f transistor Q1 is a 2N2222, design the circuit to amplify 15 times a signal of ±50 mV amplitude,…

A: for the Given Fixed bias Amplifier: Given : Input Impedance = Zi = 10 Kohm = 10000 ohm = RB…

Q: Is option B the correct choice? 10. The output of a feed back control system is a function of a)…

A: Yes, option B is the correct choice. The explanation is provided below.

Q: 5.29 A magnetic field propagating in free space is given by H(z, t) = 20.sin(π × 108t+Bz) ax A/m…

A: It is given that: Hz,t=20.sinπ×108t+βzax Am

Q: 89. If the ripple voltage in a full-wave rectifier is 25 V at a load current of 60 mA, its value at…

A: Given, For a full wave rectifier, Ripple voltage, V1=25 V Load current, IL1=60 mA For load current,…

Q: a) A source vs = 2 V with internal source resistance Rs =10 kΩ applies a signal to a 5 gain…

Q: Example 16.31. The change of inductance for a moving iron ammeter is 2 µH/degree. The control spring…

A: Given a moving iron ammeter with, Change of inductance, dLdθ=2 μHdegree Control spring constant,…

Q: The voltage across R₁ resistor in the circuit shown below is? 春 V1 10 *R1 50 R2 50

A: Given, The circuit is,

Q: If resistances of 10ohm, 20ohm, 30ohm are connected in parallel and supplied with 240 volts,…

Q: find the complex Fourier expansion of the periodic function shown below - < x < ² 2 2 COS X Cn =…

Q: Magnetic Field Intensity vs Distance Where specifically do you find the strongest field intensity?

Q: Compute the input resistance Rin of the inverting op amp amplifier shown in Figure 4.47 in terms of…

A: Given : Input resistance R1 Feedback resistance RF Input voltage Vs Output voltage Vo Find…

Q: 8. The transfer function given below has; s+1 (s + 4) (s² + 3s + 2) P(s) =

A: Given: Ps=s+1s+4s2+3s+2 Required: Poles and Zeroes of the given transfer function.

Question

(i) Determine the currents for the electrical network shown in the following
figure, using Gauss elimination:
I
202
10v
20v
402
(ii) Find the volume of traffic along the arrows, using Gauss elimination:
18P
50
C.
200
100
165
200

Expert Solution

Step 1

We are authorized to answer one question at a time, since you have not mentioned which question you are looking for, so we are answering the first one, please repost your question separately for the remaining question.

Step 2

It is given that:

Letting P=7

Step by step

Solved in 4 steps with 1 images

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

By using Gauss-Siedal method, the voltage of the bus 2 after two iteration is Your answer By using Gauss-Siedal method the voltage of the bus 3 after two iteration is Your answer For a system consist from 3 buses and bus 1 is the slack bus. The data of the system are:- 0.25 -0.2 -0.05 Ybus j -0.2 0.225 -0.025 p.u. -0.05 -0.025 0.075 V₁=1+j0 p.u., P₂+jQ2-0.6+j0.25 p.u., P3+jQ=0.8+j0.5 p.u.
7. In the circuit below write the loop equations and set up (not solve) the matrix equation for the load current. Wiso 150 75 28 100
please solve for nodal stress method. (if it is possible to apply supernodes)
The convergence characteristics of Gauss-Seidel method is cubic super linear quadratic linear
answer by Quine-McCluskey Method
[Q3] Analyze the following electrical circuit by finding the currents (I1, 12 and 13) using Gauss-elimination method
Solve for the currents I1, I2 and I3. Use KVL and KCL to derive the equations and use Gauss-Jordan Elimination to solve for the unknowns. (Answer should be in this format: I1=____, I2=_____, I3=_____). Answers should be at least 2 decimal places. * Please give the COMPLETE solution and nessecary Figure. Thank you!
The mathematical relationship between the voltage and current in a J-FET is a ___. a.quadratic function b.All of the above c.sinusoidal d.exponential e.linear function
problem
Schering Bridge is used to find ____________. a. capacitance b. pressure c. inductance d. frequency
Can ripple factors be grater then unity . Justify?
Instructions: • Write the GIVEN with their respective symbols and units. • Do not skip the SOLUTIONS, do it step-by-step with their respective symbols and units Problem: At 8:00AM a lighthouse is north of a ship. Thirty minutes later the lighthouse bears N 40°45' E from the same ship. If the ship is sailing westward at a speed of 15 km/hr, find the distance of the ship from the lighthouse after thirty minutes. wwww. a. 11.49 km b. 15.67 km c. 23.89 km d. 31.09 km