How to solve the floor area and total floor area?

Q: PROBLEM NO. 4 The system is released from rest in the position shown with the spring unstretched.…

A:

Q: A two-span, continuous wood girder (E = 2,000 ksi) supports a roof patio structure (part (a) of the…

A: Given data:- Width of beam, b=2 in Height of beam, h=8 in Uniform distributed load, q=17 lb/ft…

Q: 1) A truck and trailer combination having the axle loads as shown in the figure rolls across the…

A:

Q: Discussion on limitations and constraints on the use of bolts, studs, screws ( Minimum 05), and…

A: Bolt : A bolt is a type of threaded fastener having an exterior male thread that requires a…

Q: 12. What path does a projectile follow? B. parabola A. ellipse C. part of a circle D. hyperbola

A: The projectile follows a parabola path. If some object is thrown towards the sky then, due the…

Q: Q3: A hexagonal cross section bar as shown in Figure (2) below, is used as a simply supported beam.…

A:

Q: A 50 kg man is running until he hits a swing with a mass of 2 kg. If he was running at 2 m/s, find…

A: Applying conservation of momentum to solve for velocity and conservation of energy to solve for…

Q: An oil well has been drilled and completed. The production zone en encountered at depth 5220-5354…

A: Given datadepth =5220-5354 ft ϕ =21%Sw =24%A =93 acers h =5354 ft -5220 ft =134 ft   h=thickness of…

Q: How formation damange can be minimized in any producing well?

A: When wellbore fluids are utilised during drilling, completion, and workover operations, formation…

Q: If the allowable reverberation time for the room is not more than 2 seconds and the client would…

A: Solution: Reverberation time is defined as the time taken by the sound waves to reduce to 60dB. The…

Q: 4. The cross section of rod 1 and 2 is circular with diameter d=40mm. E-200GPa, [o] =120 MPa, λ=99,…

A: E = 200GPa  d = 40mm

Q: The table below represents the flow information for a river, follow the flood hydrograph of this…

A:

Q: Q2: A simply supported beam shown in Figure (1-A) below, has the cross section shown in Figure (1-B)…

A:

Q: A rectangular reinforced concrete beam with width of 250 mm and effective depth of 500 mm is…

A:

Q: Q.47 A lawn sprinkler as shown in figure has arm fitted with nozzle of diameter 1.0 cm and…

A: Given data in question  Velocity Distance  Diameter  To find out  Torque Speed

Q: PROBLEM NO. 3 The 25.35-N box is at rest on the horizontal surface when the constant force F= 6.25N…

A:

Q: The stresses acting on an element are o = 745 psi, ay = 615 psi, and Txy = 430 psi. (Consider only…

A:

Q: A 10 il load is uniformly cated by an aluminum alloy pipe with an outside diameter of 10 cm and…

A:

Q: Determine the horizontal and vertical components of reaction B of the three-hinged arch. Assume A,…

A: Draw FBD of AB and BC. Show the internal reaction at B as equal and opposite in two parts. Then…

Q: A timber beam AB of a span of 5 m, a width of 150 mm, and a height of 250 mm is to support three…

A:

Q: is zero, T e blade p

A: SOLUTION OF ABOVE PROBLEM IS BELOW:

Q: Liquid flowing at high speed in a wide, horizontal open channel under some conditions can undergo a…

A:

Q: (iii) The saturated unit weight of the soil in a permeability test (Figure 1 below) is 21 kN/m³.…

A:

Q: A 10 load is uniformly caried by an aluminum a QA OR Ocoffen 0035 damer om and inside ameter of 9.6…

A: Given : aluminium pipe axial load, P = 10 kg inside diameter, d1 = 9.6cm   outside diameter, d2 =…

Q: A large reservoir supplies water for a community. A portion of the water supply system is shown.…

A: a)Average velocity of water in the pipe Here discharge, Q = 1310 l/s = 1.31m3/s We know discharge in…

Q: locate the centroid of the beam section shown

A: To Determine Centroid of the T-beam section.

Q: Gate AB in Fig. is semicircular, hinged at B. What horizontal force P is required at A for…

A: Using formula

Q: A plate with a 1.5-cm diameter circular hole is exerted with the bending moment M = 40 N-m. The…

A: Given bending moment , M = 40 Nm Sy = 400 MPa width of plate, b =3-dia of hole =(3-1.5)cm depth, d =…

Q: Q.8. a) For the truss shown in Fig. Q. 8(a). Draw influence line for (i) Shear in-panel 4-5 (ii)…

A:

Q: View Policies Current Attempt in Progress A beam is subjected to equal bending moments of M₂ = 32…

A:

Q: The following force system is acing on the frame: a triangular distributed load and a 30lb force. A)…

A:

Q: Simpson's 3/8 Rule for integration is mainly based upon the idea of O Approximating f(x) by a 3rd…

A: Simpson 3/8th rule for integration is approximately appropriate for polynomial of degree 3 or less.…

Q: Determine the critical buckling stress and  critical buc

A: The section W14X109 is given with Lx=20' and Ly=12' Calculating the critical buckling stress and…

Q: PROBLEM NO. 3 The 25.35- N box is at rest on the horizontal surface when the constant force F =…

A: force on rest = 25.35N horizontal surface force (F) = 6.25N μk = 0.21 d = 2.26m

Q: The probability that the annual maximum flood discharge will exceed 25000 m³/s, at least once in…

A:

Q: In a rectangular channel 3.5 m wide laid at a slope of 0.0036, uniform flow occurs at a depth of 2…

A:

Q: Calculate the normal stress (a) in the bar.

A: The values and diagram given in the question are as follows: Force(F)=45 kN or 45000 N…

Q: Determine the magnitude of the resultant force. The magnitude of the Resultant force is nearly 40°…

A: The two forces are F1=500NF2 =200NThe angle between two forces, α =40°

Q: 5-A 10ft continuous flexible strip footing is subjected to a load of 500 psf. Find the change in…

A: Given data: Strip footing. q=500 psfB=10 ftz=3ft

Q: The coefficient of permeability of fine sand is 0.012 cm/sec at a voids ratio of 0.57. Estimate the…

A: Given data:k=0.012 cm/se=0.57

Q: Question 3: The 50 kg block shown below is initially at rest. Determine the friction force between…

A:

Q: A ship weights 127 MN. On filling the ship's boats on one side with water weighing 600 KN with the…

A: Given data- weight W=127 MNweight of water=600 kNmean distance=10 mangle of displacement=2o16'To…

Q: Q.1 A truss is loaded as shown in (a) Calculate the forces in all men (b) Calculate the horizontal…

A: In question Truss is given  which has 9 member and load applied 12 KN at F. It is symmetrical…

Q: 24 AN 24 KN 24 KN c+ -4 @ 0.73 m = 3 m- F 0.75 m 20 B

A:

Q: Q2: An open Im diameter tank contains water at a depth of 0.7m when at rest. As the tank is rotated…

A:

Q: @ The beam is loaded by its self-weight with intensity q. The length of the beam is 11.2 ft. Let E=…

A:

Q: For the bearn and loading shown, use discontinuity functions to compute (a) the slope of the bear at…

A:

Q: 3. A project to extend irrigation canals into an area that was recently cleared of mahogany trees…

A:

Q: Determine all reactions , draw shear force diagram and bending moment diagram (if you could show the…

A: Asked: To determine the support reactions and draw the shear and moment diagram.   The support…

Q: uate the position, velocity and acceleration when t = 3 seconds.

A:

Stair construction and layout

Stair is a type of vertical transportation in a building which consist of a series of steps in a flight of stairs that enable the vertical movement of people and materials from one floor to another. A staircase consists of steps that comprises of riser & tread, handrail, baluster, stair stringers, newel post and waist slab. The construction of staircase with all the components is termed as stair construction. A staircase is an enclosure that contains the entire stairway. The materials used for the construction of stairs are bricks, reinforced cement concrete, stone, lumber, steel and a combination of these materials.