high-voltage power line is made of aluminum conductor steel reinforced (ASCR) material. Suppose a power line has a radius of 2.00 mm and assuming the resistivity of the ACSR is 23.50 x 10^-9 resistor x m, how long is this powerline if it dissipates (on average) 350 MW with a maximum voltage across the powerline of 345,000 Volts (DC)?

high-voltage power line is made of aluminum conductor steel reinforced (ASCR) material. Suppose a power line has a radius of 2.00 mm and assuming the resistivity of the ACSR is 23.50 x 10^-9 resistor x m, how long is this powerline if it dissipates (on average) 350 MW with a maximum voltage across the powerline of 345,000 Volts (DC)?

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter4: Transmission Line Parameters

Section: Chapter Questions

Problem 4.2MCQ: Overhead transmission-line conductors are bare with no insulating cover. (a) True (b) False

See similar textbooks

Similar questions

INSULATORS A string of suspension consists of four (4) units. The Voltage between each pin and earth is 0.14 of the Self-Capacitance of the unit. The Voltage between the Line Conductor and earth is 135 KV. Find the Voltage distribution across each unit. Draw the diagram.
For same power transfer, same material and same length and same power loss. If the voltage is increased by 4 times. What will happen to the area of cross section of conductor?
a) High Voltages are preferred for Transmission of Electricity. Why? b) Why Generation Voltage Levels are low in the range of 11 kV/ 33 kV etc? c) Why ACSR Conductors are preferred over Copper Conductors? d) Overhead Transmission Lines are preferred for Transmission of Power for Long Distances, why?
The cost of a single phase overhead feeder is OMR 7 a per km ( a is area of cross section in sq mm) and the interest and depreciation charges on feeder are 10%. Determine the most economical current density to use for distribution requiring full load current of 75% of the year. The cost of generating electrical energy is 12 baisa per unit. Assume resistance of 1 m length and 1 mm2 section of conductor as 1/62 ohm. Current density A/mm2
These are laminated steel core containing current-carrying copper wires; and in general if it is the stationary part, it is called as
An overhead line has span of 260m. The tension in the line is 1200kg while the conductor weighs 650 kg per 100 meters. Calculate the maximum SAG in the conductor. If the height of the tower is 13 meters, estimate the clearance of conductor to the ground. Draw a figure and mark values of sag, clearance, span, height of conductor etc.
PROBLEM SOLVING NO. 2: A string of suspension consists of four (4) units. The Voltage between each pin and earth is 0.08 of the Self-Capacitance of the unit. The Voltage between the Line Conductor and earth is 110 KV. Find the Voltage distribution across each unit. Draw the diagram.
A two-wire DC splitter of 1Km length and resistance of each conductor (m/00030.0) and feeds the loads as shown in the augmented form: 1. Minimum voltage point on the conductor 2. The voltage at each load point 400V 200m 300m 400m 100m 80A 60A 10A SOA
The RMS voltage between conductor and ground is called Choose correct answer : A) Line to Line voltage B) Phase voltage C) Line voltage D) Neutral voltage
The cost of a single phase overhead feeder is OMR 17 a per km (a is area of cross section in sq mm) and the interest and depreciation charges on feeder are 7%. Determine the most economical current density to use for distribution requiring full load current of 70% of the year. The cost of generating electrical energy is 12 baisa per unit. Assume resistance of 1 m length and 1 mm section of conductor as 1/62 ohm. Current density =- A/mm?
What is the maximum current-carrying capacity of a wire or cable?A. OvercurrentB. EnergyC. AmpacityD. Surge CurrentExplain why
One advantages of load balancing is that each phase conductor carries the ? current value