Given: F = 20 m hr A = 20m? h Required: a. Unit of K so the flow rate is in m3 hr b. Get the unsteady state equation = F - F dt c. h, =?; if k = 1

Q: 8) The IUPAC name for the following compound is -- * `CH3 ОН 1-methyl-2-cyclohexenol 6-methyl-2-cycl...

A: On 6th Position, Methyl is attached. On 2nd Position, Alkene Group is there. on 1st Position, Alcoho...

Q: The simple dynamic method is used to measure kLa in a fermenter operated at 30 C and 1 atm pressure....

A: Given that thera are time and C(AL) data are given T=30 CP =1 atm 

Q: he density of a crude oil is 53.1 Ibm/ft3 at 68 F and its iscosity is 32.8 lbm/(ft-hr). What is the ...

A:

Q: A large tank filled with a mixture of gases A and B at 101 kPa and 298 K (25 °C) is connected to ano...

A:

Q: Hard magnetic materials have low coercivity, low remanence, low permeability high coercivity, high r...

A: Hard magnetic materials: Hard magnetic materials have high anisotropy field, high coercivity and lar...

Q: Q1)- For the reaction A -R, second-order kinetics and C= 1 mol/lliter, we get 50% conversion after 1...

A:

Q: Yennah needs saturated steam at 100C with a flowrate of 550 kg/h from an ice block using the steam ...

A:

Q: Exhaust gas from an automobile contains air and 10-4 mole fractions of CO in air at 25 degC and 1.2 ...

A: Asked convert given above concentration as a mass concentration (kg/m3)

Q: II. The adiabatic exothermic irreversible gas-phase reaction 2A + B→ 20 is to be carried out in a fl...

A:

Q: Feed stream containing 15% wt solids and 85% wt water is introduced in a certain process where the s...

A: Given, The feed stream contains 15% solids and 85% water by weight. Let F be the mass of feed stream...

Q: calculate the transmembrane fluxes in kmol/m2-s.

A:

Q: What is the absorbance of 0.1M copper sulfate at 780nm? Please provide re

A: Without any experiment we can say about absorbance of  .1 M copper sulfate at 780nm .But you can fel...

Q: An open test tube at 293 K is filled at the bottom with 12.1 cm of Hg, and 5.6 cm of water is placed...

A: Given that, The height of the mercury hm = 12.1 cm The height of water hw = 5.6 cm Atmospheric press...

Q: Create an illustrated step-by-step schematic diagram of the following Qualitative test for Lipids: •...

A:

Q: Just answer D AND E PLEASE   The analysis of a flue gas from a fuel gas containing no nitrogen is 4....

A: The atomic balance on nitrogen gives moles of air. The atomic balance on carbon and hydrogen and oxy...

Q: Saturated propane gas at 305 K is pumped to a tank at 5m/s through a cast iron of 5 cm diameter and ...

A: Given data: The temperature of the saturated propane gas flowing through the pipe is T1 = 305 K The ...

Q: Determine the diffusivity of methane in air using (a) the Hirschfelder equation and (b) the Wilke eq...

A: The diffusivity gives the rate of diffusion. The rate can be of particles, concentration, heat, or f...

Q: 2. The two graphs shown below represent the distillation results for two different distillations. Di...

A: Distillation separates the components in a mixture on basis of their difference in boiling points. T...

Q: A 2.25-g sample of magnesium nitrate, Mg(NO3)2, contains mol of this compound A 38.4 (В) 65.8 148.3 ...

A: Given: m = 2.25 g (magnesium nitrate)

Q: Over what range of conversions would the CSTR and PER reactor volumes be identical?

A: Plotting the Levenspiel plot, we get the following:   

Q: Consider that a gas is behaving ideally in a closed system. Its initial conditions are shown below: ...

A: (a) Given, The initial temperature of the gas, T1 = 303.15 K The initial pressure of the gas, P1 = 1...

Q: Fresh orange juice contains 10.0 wt% solids and the balance water, and concentrated orange juice con...

A: Given: Required to find: The amount of product (37.0% concentrate) produced per 100 kg fresh juice ...

Q: In a manufacturing plant, there is a pressurized water tank having an orifice at the bottom with dia...

A: Given data: Diameter of orifice = 0.1 m Height of tank = 5 m Air pressure above the water level = 36...

Q: You are about to sail a Great Circle from A (12°20’N, 25°22’ W) to Port B (55°19' S, 75°17'E). Find ...

A: A = (12°20' N, 25°22' W) B = (55°19' S, 75°17' E) LatA = 12°20' LatB = 55°19' D.LongAB = 360°- (25°2...

Q: For an industrial process where a large amount of heat is required, a large combustion chamber is us...

A: Dear User! The question does not state the relative composition of benzene and methyl alcohol in the...

Q: The cross-sectional area of a body is its total surface area. (A True B) False

A:

Q: Chlorine is absorbed from a chlorine mixture with air at 300 K and 1 atm. The individual film coeffi...

A:

Q: Determine the amount of theoretical oxygen and theoretical air needed to burn. ( a.) 60 kg of butane...

A:

Q: The exothermic elementary liquid-phase reaction (Rawlings and Ekerdt, E6.1) A +B → C r = KCĄCB is ca...

A: Given

Q: 2. Balance the REDOX reaction below in acidic solution. H202(aq) + Cl02(aq) cloz(aq) + 02(9)

A:

Q: H2 = 24%; CH4 = 30%; C2H6 = 11%; C2H4 = 4.5%; C4H8 = 2.5%; CO = 6%; CO2 = 8%; O2 = 2%; and N2 = 12% ...

A: (a) The air to fuel ratio is to be calculated.

Q: A 50.0 g iron ball (sp ht = 0.473 J/goC) is heated to 35oC and is placed in a calorimeter holding 10...

A:

Q: Q2) How many grams of NazC03 are required to prepare: 1) 120 ml of 0.25 M 2) 250 ml of 0.1 N Molar m...

A:

Q: A plating plant has a waste stream containing zinc and nickel in quantities in excess of that allowe...

A: Basis: 1 L/hr and all concentrations are g/L Given:   Stream Concentration (g/L) Zn Ni F 100...

Q: A mixeture of Oetane (C8H18) and heptane(c7H16) ( Ycotie O.80), reacts 200 þercent theoretical air. ...

A: (i) Basis 100 moles of feed Hence, octane = 0.8 x 100 = 80 moles heptane = 0.2 x 100 = 20 moles We k...

Q: Carbon disulfide is a common solvent that is produced by reacting sulfur vapor with methane. It is p...

A: By using Gaussian elimination method,we can determine the number of independent reactions. Step-1: C...

Q: An aqueous solution of sodium sulfate is saturated at 32°C. The temperature to which the solution mu...

A:

Q: The exothermic reaction of stillbene (A) to form the economically important trospophene (B) and meth...

A:

Q: A completely amorphous and nonporous polymer will be: transparent ferromagnetic opaque O translucent

A: Amorphous polymers are associated with random chain arrangement. As such, they allow light to go thr...

Q: A particular power plant operates with a heat reservoir at 350C and a heat sink reservoir at 30C. It...

A: Given that, The temperature of heat reservoir T1 = 350oC = 350 + 273 = 623 K The temperature of heat...

Q: An unknown metal Y has a density of 655.2 lb per cu. ft. The edge of the FCC unit cell of the said m...

A: Given data: Density of unknown metal = 655.2 lb/ft3 Edge length = 4.09 A0

Q: 1. Consider yourself as an owner of a factory using fossil fuel as energy source. Now as an environm...

A: The alter in the natural environment due to contaminants is pollution. The contaminants can be solid...

Q: A gas contains 30% HCl and 70% air by volume. The gas enters an absorption tower at 120°F and 743 mm...

A: Given that, The volume of entering gas Vin = 100 ft3 The volume of HCl in the entering gas VHCl,in =...

Q: 2. Calculate the molar volume of saturated liquid (use SRK equation) and the molar volume of saturat...

A: (2) Assume The temperature of the n-butane, T = 298 K The vapor pressure of the n-butane, P = 1 atm ...

Q: 7-4. Temperature-Dependent Viscosity Suppose that the liquid film in Fig. 7-4 has temperature variat...

A:

Q: 1.) If 1.0 g of each of the following gases is taken at STP, which one would occupy the greatest vol...

A: 1 mole of any ideal gases occupied the same volume (22.4 L) at STP.   Here, 1 gm of each substance i...

Q: Consider the diffusion of water vapor through a polypropylene (PP) sheet 2 mm thick. The pressures o...

A: Given Details: Thickness of film ,∆x=2mm=0.2 cm Pressure of Water at point 1, P1= 2 kPa Pressure of ...

Q: How many amperes of current needs to be passed through molten Sodium chloride (NaCl) to produce 2.4 ...

A: Given  Time, t=20minMass deposited of Na, in grams= 2.4g

Q: How many grams of SO2 are produced when 152 g of CS2 react with 48.0 g of O2 according o the followi...

A: This question is based on material balance and chemical reactions. Data given :  Mass of CS2 = 152 g...

Q: Synthetic Natural Gas (SNG) has a molar composition of 96.59% CH4, 1.9% CO2, 1.29% H2, and 0.22% CO....

A: Note: We are authorized to answer three subparts at a time, since you have not mentioned which part ...