Please i need it in 5 minutes For two parallel synchronous generators of thesame size and same droop in frequency-ActivePower characteristics, if the set points of thegovernors of the two generators are decreased,simultaneously, by the same amount, thenSelect one:a. the active power sharing between thetwo generators changes, and thesystem (operating) frequency changestoob. the active power sharing stays the same,but the system (operating) frequencydecreasesc. the active power sharing stays the same,but the system (operating) frequencyincreasesd. the active power sharing between the twogenerators changes, but thesystem (operating) frequency stays thesame

For two parallel synchronous generators of the same size and same droop in frequency-Active Power characteristics, if the set points of the governors of the two generators are decreased, simultaneously, by the same amount, then Select one:

For two parallel synchronous generators of the same size and same droop in frequency-Active Power characteristics, if the set points of the governors of the two generators are decreased, simultaneously, by the same amount, then Select one:

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

Which of the following is true in the phasor diagrams drawn according to the ohmic, inductive and capacitive operating states of the round pole synchronous generator a) Due to the voltage Efd, the excitation current is large in capacitive operation and small in ohmic operation b) Due to the voltage Efd, the excitation current is large in ohmic operation and small in inductive operation c) Due to the voltage Efd, the excitation current is small in capacitive operation and large in inductive operation. d) Due to the voltage Efd, the excitation current is large in capacitive operation and small in inductive operation.
The one-line diagram of a simple power system is shown in Figure below. The neutral of each generator is grounded through a current-limiting reactor of 0.25/3 per unit on a 100-MVA base. The system data expressed in per unit on a common 100-MVA base is tabulated below. The generators are running on no-load at their rated voltage and rated frequency with their emfs in phase. G Stark Item Base MVA Voltage Rating X' x² 20 kV 20 kV 20/220 kV 20/220 kV 100 0.05 0.15 0.15 0.10 0.10 220 kV 0.125 0.125 0.30 0.15 0.25 025 0.7125 0.15 100 100 0.15 0.05 0.10 0.10 0.10 100 0.10 100 100 Lu La 220 kV 0.15 220 kV 0.35 100 A balanced three-phase fault at bus 3 through a fault impedance Zf= jo.I per unit. The magnitude of the fault current in amperes in phase b for this fault is: Select one: A. 345.3 B. 820.1 C. 312500 3888888 产产

Two alternators rated 400 MW and 600 MW are operating in parallel. The droopcharacteristics of their governors are 3% and 4% respectively from no loadto full load. Assuming that the alternators are operating at 50 Hz at noload, how would a load of 1000 MW be shared between them? What will be thesystem frequency at this load?
two alternators A and B having 5% speed regulation are working in parallel at a station. Alternator A is rated at 15 MW while B is at 20 MW. When the total load to be shared is 12 MW, then how much of the load will be shared by the alternator B?
two synchronous generators are connected in parallel, feeding a load together. the frequency of the first generator in the no-load State is 52 Hz and the slope of the characteristic is 1 MW/Hz. the total power of the load fed by these two generators is 2.5 MW and the power coefficient is 0.6 inductive. by drawing the characteristic curve of the system;a) what is the frequency of the system when the load in question is fed, and how do the two generators share the load between themselvesb) if a load of 0.5 MW is added to the system, find the operating frequency of the new system and the powers given by each generatorc) if a second load of 0.5 MW is connected to the system, the idle operating frequency of the second generator is increased by 0.5 Hz, what happens to the operating frequency of the system and the power values given by the generators
Three identical steam-turbine generators G1, G2, and G3 are operating in parallel. Each generator is: 7.2 KV, 25.4 MVA, 60 Hz, 0.77 PF lagging, 4-poles, Y-connected, with synchronous reactance of 2 Q and an armature resistance of 0.05 Q. Each of generators G1 , and G2 has a characteristic power-frequency slope of 5.8 MW/Hz, and no-load frequency of 62.5 Hz. Generator G3 has a characteristic power-frequency slope of 6.0 MW/Hz. Find the no-load frequency of generator G3 for which all generators supply a load of 42.6 MW, at fsys = 60 Hz. Select one: O a. fevs = 62.95 Hz O b. fsys = 62.26 Hz O c. None O d. fsys = 62.5 Hz
b) Two synchronous generators, G2 and G2, are connected parallelly supplying a load. Generator G1 has a no-load frequency of 50.5 Hz and a slope of 300 MW/Hz. Generator G2 has a no-load frequency of 50.2 Hz and a slope of 500 MW/Hz. The load consumes 250 MW real power. (1) At what frequency does this system operate, and how much power is supplied by each of the two generators? (ii) An additional 100 MW load is added to this power system. What is the new system frequency, and how much power do G1 and G2 supply? (iii) The governor set point of G2 is changed to control system frequency back to 50 Hz. Determine the G2 governor set point.
Three identical steam-turbine generators G1, G2, and G3 are operating in parallel. Each generator is: 7.2 KV, 20 MVA, 50 Hz, 0.85 PF lagging, 4-poles, Y-connected, with a synchronous reactance of 2 Q and an armature resistance of 0.05 Q. Each of generators G1 and G2 has a characteristic power-frequency slope of 4.7 MW/Hz, while generator G3 has a slope of 5.0 MW/Hz. If all three generators are supplying a total load of 51.2 MW, and the no-load frequency of each generator is set to 52.4 Hz, what will the system frequency be? How much power is supplied by generator G3? Select one: O a. fsys = 48.84 Hz, PG3 = 17.8 MW O b. None O c. fsys = 49.05 Hz, PG3 = 16.75 MW O d. fsys = 48.95 Hz, PG3 = 17.25 MW Clear my choice
A synchronous generator is rated 645 MVA, 24 kV, 0.9 pf lagging. It has a synchronous reactance 1.2 . The generator is feeding full load at 0.9 pf lagging at rated voltage. Calculate: (a) Excitation emf (E,) and power angle & (b) Reictive power drawn by the load Carry out calculations in pu form and convert the result to actual values.
Three identical steam-turbine generators G1, G2, and G3 are operating in parallel. Each generator is: 7.2 KV, 20 MVA, 50 Hz, 0.85 PF lagging, 4-poles, Y-connected, with a synchronous reactance of 2 N and an armature resistance of 0.05 Q. Each of generators Gj and G2 has a characteristic power-frequency slope of 4.7 MW/Hz, while generator G3 has a slope of 5.0 MW/Hz. If all three generators are supplying a total load of 51.2 MW, and the no-load frequency of each generator is set to 52.4 Hz, what will the system frequency be? How much power is supplied by generator G3? Select one: O a. fsys = 48.84 Hz, PG3 =17.8 MW O b. fsys = 49.05 Hz, PG3 = 16.75 MW c. fsys = 48.95 Hz, PG3 = 17.25 MW d. None
Three identical steam-turbine generators G1, G2, and G3 are operating in parallel. Each generator is: 7.2 KV, 20 MVA, 50 Hz, 0.85 PF lagging, 4-poles, Y-connected, with a synchronous reactance of 2 Q and an armature resistance of 0.05 N. Each of generators G1 and G2 has a characteristic power-frequency slope of 4.7 MW/Hz, while generator G3 has a slope of 5.0 MW/Hz. If all three generators are supplying a total load of 51.2 MW, and the no-load frequency of each generator is set to 52.4 Hz, what will the system frequency be? How much power is supplied by generator G3? Select one: O a. fsys = 48.84 Hz, PG3 = 17.8 MW O b. fsys = 49.05 Hz, PG3 = 16.75 MW O c. fsys = 48.95 Hz, PG3 = 17.25 MW O d. None
Two similar 2,500 kW, 3 phase generators operate in parallel. The speed load characteristic of the first generator is such that is no-load frequency of 60.5 Hz drops uniformly to 58.5 Hz at full load, while for generator 2, its no-load frequency of 60.5 Hz drops uniformly to 59 Hz at full load. Determine the kW load of each generator if the combined load is 4,000 kW. a. 1,714.3, 2,285.7 b. 2,015.5, 1,984.5 c. 1,765.5, 2,234.5 d. 2,452, 1,548