For the following transfer function H(s), as the frequency w becomes very large, the magnitude of this transfer function drops at the rate of what value per decade? •H (0)= O -20 O -20 O -40 O -80 24+ 200 +3

For the following transfer function H(s), as the frequency w becomes very large, the magnitude of this transfer function drops at the rate of what value per decade? •H (0)= O -20 O -20 O -40 O -80 24+ 200 +3

Delmar's Standard Textbook Of Electricity

7th Edition

ISBN:9781337900348

Author:Stephen L. Herman

Publisher:Stephen L. Herman

Chapter23: Resistive-inductive-capacitive Series Circuits

Section: Chapter Questions

Problem 1PA: You are an electrician working in a plant. A series resonant circuit is to be used to produce a high...

See similar textbooks

Related questions

Q: For the circuit shown below: Rs=8kQ, RG = 1500 kQ, R₂ = 40 kQ, RD= 18 ko, gm= 2.75 mA/V a) Draw the…

A: The required parameter can be calculated by using the small signal equivalent circuit. The small…

Q: The Input impedance amplifier is______ follower amplifier Select one: of the common gate that of the…

A: Answer: b. Less than Explanation: a. It is not a valid option. The input impedance varies between…

Q: der the following signal x[n] as ibed below: = 28[n8] 3 d[n -6] + [n- 4]-38[n-2] +2.6 Use the DTFT…

Q: A 4.16 kV, 3-ph industrial plant bus is supplied from the utility mains. Connected to the 4.16 kV…

A: We are authorized to answer three subparts at a time. Since you have not mentioned which part you…

Q: The common drain amplifier has a voltage gain higher than that for the common source Select one:…

Q: If both input of a OR gate is short circuited than OR gate become AO 1. A BO 0.00 NOT gate DO None…

A: Given: Both input of an OR gate is shorted.

Q: The switch is said to be __________ when one side of it is connected to the ground and pressing it…

A: We have to tell that which switch is when one side of it is connected to the ground and pressing it…

Q: Question 2: (CLO 1 and 2) Consider a system h, shown in Figure, which is constructed from four LTI…

A: Given- h1=3δn h2=3δn-δn-1+δn-2h3=-δn+δn-1+δn-2 h4=0.8n+1un+1 x[n]= δn To find- y[n]=?

Q: T/2 T VIE V +sen wot + V1 + (-1) Σ N-2 (1-N²) cos Not

A: Given: Half wave rectified signal with peak amplitude V. Fourier series of the above mentioned…

Q: Using your own words and without any formula, explain: a- How we deal with the capacitors and DC…

A: Explanation a)In ac analysis as we deal with high frequencies, the impedance offered by capacitance…

Q: A 6 pole generator has a flux of 12 mWb per pole. The armature has a total of 900 conductors and is…

A: We have a generator with, Pole (P) = 6 Flux/pole Ф = 12 mWb = 0.012 Wb…

Q: A 200 V single phase circuit has an apparent power of 5 kVA and a reactive power of 4 kVAr. Then…

A: We have Single phase Circuit with, Apparent Power(s) = 5 KVA Reactive Power (Q) = 4 KVAr And We…

Q: The quantity of charge Q in coulombs (C) that has passed through a point in a wire up to time t…

A: Given: The charge Qt=t3-4t2+6t+4

Q: 3. In a car radio system, it's desired that only one of the four applications namely Bluetooth,…

A: The multiplexer is a device used to convert 2N input into one output line based on the control…

Q: The step size is variable in which of the following:

A: The correct option along with the explanation is provided in the following section.

Q: - What is the configuration of this mplifier? [ - Draw the DC equivalent circuit for the mplifier […

A: The small signal input is applied to the gate of the MOSFET and output is taken at the drian. Hence…

Q: The damping ratio and peak overshoot are measures of: O Speed of response O Steady state error O…

A: So we have to identify what damping ratio and prak overshoot signifies and what parameters we can…

Q: Assume 185 and 122 are signed 8-bit decimal integers stored in sign-magnitude format. Calculate 185…

A: It is given that:∙185∙122

Q: Find the Thevenin equivalent at terminals a-b of the circuit in Fig. 10.24.

A: It is given that:

Q: Fourier series are the basic mathematical tool of Fourier analysis used to analyze periodic…

Q: For the circuit shown below: a- What is the configuration of this amplifier? b- Draw the DC…

A: We need to tell about configuration of the given circuit and DC equivalent of given circuit

Q: H V1 12Vrms 60Hz 0° R1 ww 20 L1 30.5H L2 1H R2 20

A: Given, Voltage=V=12V Resistance: RP=2Ω, Rs=2Ω Inductance: L1=0.5H ,L2=1H Mutual Inductance=M=12H ,…

Q: Consider the feedback control system block diagram in Fig.1

Q: In a second-order system, if the damping ratio is greater than '1', then what would be the nature of…

A: In second order system if the damping ratio is greater than 1 ( over damped ) then the roots or…

Q: Consider the given circuit where V₁ = 11 V and V2 = 20 V. Determine vo using the superposition…

Q: 3. About Transformer efficiency 3.1. Define efficiency 3.2.State the criterion for maximum…

A: 3.1 Transformer efficiency is defined as the ratio of available output power to input power.…

Q: Consider the transfer function H(s) = (s + 8)/(s^2 + 7s + 12). A) Find the inverse Laplace…

A: The inverse Laplace transform can be calculated by using the partial fraction and the system…

Q: Find the current flowing through the RLC circuit connected through an AC source of 240 V as given…

A: Given data, V=240 V, R=100 Ω, L=100 mH, C=100 μF, f=50 Hz Given circuit diagram,

Q: The value of the line integral of B around the closed path in figure is 3.77×10-6 Tm. What is I3? If…

A: Given here the value of the line integral of B→ around the closed path in figure is 3.77 × 10-6…

Q: VIN VD- R₁ W VD+ R3 R₂ A R4 VOUT

Q: 3) Find the mesh currents in the circuit shown in Fig. 13-39.

A: It is given that:

Q: Do the following conversion problem: Calculate the binary equivalent of 2/3 out to eight places.…

A: It is given that: 2310

Q: B1. An electrical engineer tested a 1 kVA, 240/40 V single phase transformer, and the performance on…

Q: 404 PRACTICE PROBLEM 10.6 Calculate v, in the circuit of Fig. 10.15 using the superposition theorem.…

A: Given

Q: - Transformers and Special Locations 7.a. Dry-type transformers are available in what…

A: Transformer:- It is an electrical static device that is used to transfer energy from one circuit to…

Q: ratio to the ratio of 15. Referring to Fig. 16.11, if Vpp = 2 V for the varactor of Fig. 16.10, find…

Q: In the figure shown, the value of the current I (in Amperes) is 5V(+) 5Ω 5Ω 1A Σ10 Ω

A: Given data, Given circuit diagram,

Q: -Calculate the average power of discrete-time wave shown in the fig a? * O -1 01 06 Oo Wala pa pa pa…

Q: (b) Figure Q.1b() shows a feedback system of unit step response of the system in Figure Q.1bii).…

A: Given: Input signal is step signal and a step response has been given. Required: Values of…

Q: Given x[n] = 8[n 1], then the DTFT of x[n] is - Select one: O X(ej) = e-ja O X(ej) = -ejw X(ej") =…

A: Given discrete time signal Need to be converted into DTFT using the properties of DTFT DTFT impulse…

Q: Percentage 0.012% when loaded with a Tensile wire x = 0.3mm) 3. A wine of length 2.50m has a Strain…

A: It is given that: Length of wire=L=2.5 mStrain=∆LL=0.012 %=0.012100

Q: If there are 10A of direct current through the filament of a light bulb, how many coulombs have…

A: Answer: a. 20 C Explanation: a. It is a valid option. The current I is given by Current,I =…

Q: A 30-ohm resistor and a 0.1 H inductor are in series with a voltage source that produces a voltage…

Q: Question-1 Consider the signal below: Given that A = 5 and B = 2 x(t) 0 2B B A t a) [ Write the…

A: Given A=5 B=2 Find Equation of the periodic waveform Express the periodic waveform in Fourier…

Q: -5. Determine the nominal resistance and range of the resistor.

Q: Considering a discrete LTI system, if the input is u[n 2]u[n- 3] what would be the output? -

Q: , and the circuit is

A: Given: Circuit is in steady state with t=0

Q: Transformers are electrical devices that A. generally have three to four moving parts. B. have a…

A: Transformers:- Transformer: A device that steps up or steps down the voltage as it transmits…

Q: A system is represented by the transfer function Y(s) R(s) = T(S) The state variable representation…

A: The state variable representation of the given transfer function can be obtained by dividing the…

Q: A photovoltaic solar cell is given which is rated at 3.7V, 2.6A. Design a photovoltaic solar array…

Question

For the following transfer function H(s), as
the frequency w becomes very large, the magnitude
of this transfer function drops at the rate of what
value per decade?
4 (0)=
-20
-20
O -40
O -80
R² + 20A +3

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

Step 2

Step 3

Step 4

Step 5

Step 6

Step by step

Solved in 6 steps with 6 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

Given the series RLC circuit. If R=10 ohm, find the values of L and C such that the network will have a center frequency of 100 kHz and a bandwidth of 1kHz. The output of the circuit is taken across series LC. Select one: O a. 1.59 mH and 1.59 nF O b. 1.59 mH and 1.59 uF 1.59 H and 1.59 nF 1.59 uH and 1.59 uF O C. O d.
10(1+5s) The transfer function of the system is . The corner frequencies will be s(1+2s) -0.2 and -0.5 -2 and -5 0.2 and 0.5 2 and 5
Given the series RLC circuit. If R=-10 ohm, find the values of L and C such that the network will have a center frequency of 100 kHz and a bandwidth of 1kHz. The output of the circuit is taken across series LC. Select one: O a. 1.59 mH and 1.59 nF O b. 1.59 mH and 1.59 uF Oc 1.59 uH and 1.59 uF O d. 1.59 H and 1.59 nF
How many corner frequencies are in the following sinusoidal transfer function? 1 19 - G(ja) = (10 – jw)(100 + jw)(jw + 1) O A) There are not correct answers O B) four C) two O D) three O E) five
Start by finding the Thévenin equivalent circuit seen by the capacitance. Then, sketch the magnitude of the transfer function H(jw) = Vout/Vin. What is the value of the cutoff frequency?
A tank circuit contains a capacitor and an inductor that produce 30 2 of reactance at the resonant frequency. The inductor has a Q of 15. The voltage of 277V is connected to the circuit. What is the total circuit current of the resonant frequency? Show your work. a) IT= 0.615 A b) IT= 0.423 A c) IT = 0.846 A d) IT= 0.321 A
For a parallel RLC circuit, which one of the following statements is NOT correct? 1. 2. 3. 4. The bandwidth of the circuit decreases if R is increased The bandwidth of the circuit remains same if L is increased At resonance, input impedance is a real quantity At resonance, the magnitude of input impedance attains its minimum value
the transfer function H=Vo/Vi has a magnitude and phase angle of what?
A parallel resonant circuit has a resistance of 2 k2 and half-power frequencies of 86 kHz and 90 kHz. Determine: (a) the capacitance (in nF) (b) the inductance (in uH) (c) the resonant frequency (in krad/s) (d) the bandwidth (in krad/s) (e) the quality factor
The positive values of "K" and "a" so that the system shown in the figure below oscillates at a frequency of 2 rad/sec respectively are K(s+ 1) R (s)- C(s) (s + as? + 2s + 1) O 1,0.75 O 1,0.66 2,0.66 2,0.75
Question 02: A) How do you use Kirchhoff's law? What are the limitations of Kirchhoff's law? B) What is resonance in RLC circuit? Define the Q-factor in RLC series circuit.
Can someone show me how to calculate magnitude and phase of the transfer function below Don't provide answer in handwritten way Only typed answere O