For the circuit Figure Q1(b), assume the circuit is in a steady state at t = 0¯ before the switch is closed at t = 0 s. (i) (ii) 5A(1 Determine the value of inductance, L to make the circuit respond critically damped with unity damping factor (α =1) Find the voltage response, VL(t) for t>Os. t=0 s Do + m VI Figure Q1(b) 592 0.1 F lu(-t)

Q: 7.35 Find the solution to the differential equation 2dy (1)/dt+ 3y(t) = x(t) if (a) x(t) = 2te, with…

A: Given data : The differential equation is, 2dytdt+3yt=xt,  if (a). xt=2te-t with initial condition…

Q: .1 A 0.18-um fabrication process is specified to have t = 4 nm, µ̟ = 450 cm'/N s, and V, = 0.5 V.…

A: It is given that: L=0.18 mtox=4 nm=4×10-9 mμn=450 cm2/V.sVt=0.5 VrDS=1 KΩ=1000 Ω at  VGS=1…

Q: 19. What is the minimum distance required for single error detection according to Hamming's analysis…

A: The solution is provided in the following section.

Q: Find the F.T. of the fall wing Signals (functions) f(t) = 3 Sgh(st) - 1+jt ans: F(W) = √w-złew 6

A:

Q: A conductor of 0.5 mm diameter wire has a resistance of 400 Q. Find the resistance of the same…

A: Given, Conductor diameter, d1=0.5 mm Resistance, R1=400 Ω When conductor diameter doubled,…

Q: Referring to Figure 1 below, answer the 2 15 1 05 0 05 -15 10 questions below. 2 15 1 05 0 15 10 12…

A:

Q: A 3 HWCR has a supply of 110V / phase. Find out the value of mean voltage for a delay angle of 150°…

A:

Q: What is the load, in amps, for a three-phase, 208V feeder supplying a load calculated at 96.75kVA

A: Given data, Load KVA S=96.75 KVA Supply voltage VL=208 V

Q: Given the DC Bridge, determine Rx (in 2), if R1 = 6 kQ2, R2 = 19 kQ, R3 = 11 ΚΩ,

A: Given, R1=6 kΩR2=19 kΩR3=11 kΩ

Q: Q4:- Find the load impedance (ZL) for the network in Fig.3 for maximum power to the load and find…

A: Given:

Q: A 6 pole generator with wave wound armature has 50 slots each having 20 conductors. The flux per…

A: Given data, A generator has P=6A=2Slots=50Conductors per slot, 20ϕ=0.01 WbE=220 V

Q: Obtain the simplified Boolean expression for the given circut -F2

A: Given circuit:

Q: B. Solve the following circuits (fill in the missing values). Remember to include your reasoning…

A: Note: As per the policy we can solve only one question, please re-upload the remaining question as a…

Q: 17. What are the basic gates in MOS logic family? a) NAND and NOR b) AND and OR c) NAND and OR d)…

A: The solution will be provided in the following section.

Q: < Notes ● In a 8 bit of distinct opcodes present. Done 10 July 2022 at 8:10 AM microprocessor,…

A: The number of distinct opcodes present in a microprocessor depends on the bit length of the…

Q: The quality factor Q of a circuit at 18 MHz is 50. The equivalent bandwidth is Blank 1 kHz.

A: To find the equivalent bandwidth of a circuit. Given, Quality factor Q = 50 at resonant frequency of…

Q: Generating a discrete signal from its analogue version, the Nyquist theorem should be understood…

A: Nyquist Theorem: A band limited continuous-time signal can be sampled and perfectly reconstructed…

Q: Discuss the economic advantages of electric drive

A: Given: Electric drives

Q: Use the voltage divider principle to find the value of v2 as shown in the figure below. Given: R₁ =…

A: Given circuit:

Q: An amplifier is connected to a load by a trans mission line matched to the amplifier. If the SWIF on…

A: Given: SWR=1.5 Required: Percentage of the available power absorbed by the load,

Q: 8. In 8-bit microprocessor, how many opcodes are present?

A: The correct option along with the explanation is provided in the following section.

Q: 5. Find the F.T. of the following periodic signal 3 -2 2

A:

Q: Question 6 A 470 ohm resistor has 18.8 volts across it. What is the power consumed by that resistor?…

A:

Q: A series RLC circuit is connected to a 400-hZ line with an applied voltage of 35.678 V. The resistor…

A: A resistor 'R', an inductor 'L', and a capacitor 'C' coupled either in series or parallel make up an…

Q: For a 6 pole, 3 phase, 60 Hz induction motor ratio of stator to rotor turns is 2. On a certain load,…

A:

Q: : Find y(t) = X(+) *h(t). For the Signals Shown below h(t) X(X) w w. 4

A: If convolution of x(t) and h(t) is y(t) Then convolution of x(t-a) and h(t-b) is y(t-a-b)…

Q: herical steel ball bearing has a diameter of 2.540 cm at 28.00°C. (Assume the coefficient of linear…

A: Diameter of ball bearing d o=2.540c_{1} Initial temperature I_{1} = 28.0 degrees * C   Coefficient…

Q: A transmission line is to be inserted between a 5 Ω line and a 50 Ω load so that there is maximum…

A: The Given transmission line is to be inserted between 5 ohm line and 50 ohm There is maximum power…

Q: A loss-less 200N line is terminated on a load given by (200-j200)№. Given that the propagation…

A: the Given loss-less 200Ω line is terminated on a load 200-j200Ω The Propagation constant is…

Q: 1. Match the load to the line using a shunt stub: a) Short-circuited Open-circuited a) ZL = 500 ohms…

A: We need to match the load to the line using a shunt stub: a) Short-circuited. b) Open-circuited.…

Q: A 250 kVA transformer is at full load with a power factor of 0.8 lagging. The power factor is to be…

A: Solution is attached with this notes. Thank you.

Q: (a) A 240 Vrms, 50Hz is supplied to a circuit shown in Figure 3. It is estimated that the diode will…

A:

Q: Consider a causal and stable continuous time filter that has a system function- Ha(s) (s+1)/(s+2)²…

A: Impulse Invariance Technique: In this technique, the sampling frequency time period provides the…

Q: In a 8 bit microprocessor, estimate the number of distinct opcodes present.

A: The solution is provided in the following section.

Q: There are 144 slots in a 3-phase, 16-pole, 50 Hz., star connected alternator. There are 4 conductors…

A:

Q: Given the following, Check the circult below. Op Amp Circult. a. Sensor output range (X): 1 - 5V b.…

A: Types of feedback in op-amp circuit Negative feedback Stable output Less gain the circuit can be…

Q: Calculate the maximum aperture of a microwave antenna which has a directivity of 200

A:

Q: Describe the merits and demerits of typical LED lighting system

A: Following are the Merit and Demerits of typical LED (Light Emiting Diode)

Q: The switch in the circuit in Fig. P7.1 has been closed for a long time before opening at t = 0. a)…

A: We are authorized to answer only 3 subparts at a time since you have not mentioned which part you…

Q: Determine the value of ER

A: The voltage across resistor can be found by multiplying current through the resistor and value of…

Q: Answer the following Questions referring the circuit in figure 10. ID E-8V + VD- ✈ Si IR R2.2 k2 VR

A: Given,

Q: What is the function of mccb and rccb? Disadvantages two required?

A: The main purpose of an MCCB is to provide a way to manually open a circuit or automatically open a…

Q: What is the minimum and maximum frequency of square wave that can be generated at any port of 8051…

A:

Q: Figure 1 shows the absorption coefficient for several direct and indirect bandgap semiconductors.…

A: Given:

Q: Consider the system shown below. M(f) (the Fourier transform of m(t)) is also shown. M (f) y(t) NA…

A:

Q: 72. In 132 kV system, the phase to ground ca- pacitance is 0.01 µF and inductance is 6H. The voltage…

A: Given a 132 kV system having, The phase to ground capacitance, C=0.01 μF Inductance, L=6 H…

Q: -2 How did he get the value inside the circle X(t) = 1-t 1-t W₁ = 2 = 211 = xt) = 1-+ 1 ao = = [² x…

A:

Q: The effective resistance and synchronous reactance of a 100 kVA, 440 V single phase alternator are…

A: Let  E= Generated voltage across the synchronous generator V=Terminal voltage across the generator…

Q: 13. Which of the following is not a microprocessor? a) Z8000 b) Motorola 6809 c) Zilog Z8 d) PIC1x

A: The correct option along with the explanation is provided in the following section.

Q: A conducting circular loop, of radius r = 0.060[m] and resistance R = 0.200 [2], is submerged in the…

A: Given,Radius, r=0.060 mResistance, R=0.200 ΩMagnetic field, Bt=+0.200Te-0.300s-1t k^

Sinusoids And Phasors

Sinusoids are defined as the mathematical waveforms that are used to describe the nature of periodic oscillations.

Circuit Theory

Electric circuits are a network that comprises of a closed-loop, which helps in providing a return path for the current through a switch. When the switch is activated, the load operates, and the current accepts a path to finish the circuit at a low potential level from the opposing high potential level. Electric circuits theory is a linear analysis that helps in establishing a linear relation of voltage and current for R (resistance), L (inductance), and C (capacitance).