For each ping attempt (ping by IP address), circle whether the ping succeeds or fails. The statedsubnet mask is the subnet mask which A applies to the source and destination IP addresses in theping packet. For this problem, assume that the router is NOT able to send a ping request packet outvia the same port upon which it arrived. Pay close attention to the network connectivity devices. 13IP 200 10.3.3MAC 63SucceedsFailsA pings ZSucceedsFailsSubnet Mask = 255.255.255.0A pings CIP 200.10.3.3MAC 63.IP 200.10.2.2MAC 62A pings ZIP 200.10.4.4MAC 64SucceedsFailsIP 200 10.2.2MAC 62Subnet Mask 255.255.255.0A pings CSucceedsFailsIP 200.10.4.4MAC 64Subnet Mask 255.255.0.0A pings CSucceedsFailsA pings ZSucceedsFailsSubnet Mask 255.255.0.0A pings CSucceedsFailsA pings 2SucceedsFailsIP 200.50.2.2MAC 82IP 200.504.4MAC 84Subnet Mask 255.0.0.0A pings CSucceedsFailsA pings ZIP 200.50.2.2MAC 82opolIP 200.50 4.4MAC 84IP 200.50.3.3MAC 83SucceedsFailsA pings 2IP 200.50.3.3MAC 83Subnet Mask 255.0.0.0A pings CSucceedsFailsSucceedsFails

We need to write the which one succeeded or fails to circle them. So we will see in the more details…

For each ping attempt (ping by IP address), circle whether the ping succeeds or fails. The stated subnet mask is the subnet mask which A applies to the source and destination IP addresses in the ping packet. For this problem, assume that the router is NOT able to send a ping request packet out via the same port upon which it arrived. Pay close attention to the network connectivity devices. /19 IP 200 10.3.3 MAC 63 Succeeds Falls A pings Z Succeeds Fails Subnet Mask255.255.255.0 A pings C IP 200 10.3.3 MAC 63 IP 200.10.2.2 MAC 62 Fails A pings Z IP 200.10.4.4 MAC 64 Succeeds Fails IP 200 10.2.2 MAC 62 Subnet Mask = 255.255.255.0 A pings C Succeeds IP 200.10.4.4 MAC 64 Subnet Mask - 255.255.0.0 A pings C Succeeds Fails A pings Z Succeeds Fails Subnet Mask= 255.255.0.0 A pings C Succeeds Fails A pings 2 Succeeds Fails IP 200.50.2.2 MAC 82 S IP 200.50.4.4 MAC 84 Subnet Mask 255.0.0.0 A pings C Succeeds Fails A pings Z IP 200.50.2.2 MAC 82 opo IP 200.50 4.4 MAC 84 IP 200.50.3.3 MAC 83 Succeeds Fails Fails A pings Z P 200.50.3.3 MAC83 Subnet Mask = 255.0.0.0 A pings C Succeeds Succeeds Fails

For each ping attempt (ping by IP address), circle whether the ping succeeds or fails. The stated subnet mask is the subnet mask which A applies to the source and destination IP addresses in the ping packet. For this problem, assume that the router is NOT able to send a ping request packet out via the same port upon which it arrived. Pay close attention to the network connectivity devices. /19 IP 200 10.3.3 MAC 63 Succeeds Falls A pings Z Succeeds Fails Subnet Mask255.255.255.0 A pings C IP 200 10.3.3 MAC 63 IP 200.10.2.2 MAC 62 Fails A pings Z IP 200.10.4.4 MAC 64 Succeeds Fails IP 200 10.2.2 MAC 62 Subnet Mask = 255.255.255.0 A pings C Succeeds IP 200.10.4.4 MAC 64 Subnet Mask - 255.255.0.0 A pings C Succeeds Fails A pings Z Succeeds Fails Subnet Mask= 255.255.0.0 A pings C Succeeds Fails A pings 2 Succeeds Fails IP 200.50.2.2 MAC 82 S IP 200.50.4.4 MAC 84 Subnet Mask 255.0.0.0 A pings C Succeeds Fails A pings Z IP 200.50.2.2 MAC 82 opo IP 200.50 4.4 MAC 84 IP 200.50.3.3 MAC 83 Succeeds Fails Fails A pings Z P 200.50.3.3 MAC83 Subnet Mask = 255.0.0.0 A pings C Succeeds Succeeds Fails

Comptia A+ Core 1 Exam: Guide To Computing Infrastructure (mindtap Course List)

10th Edition

ISBN:9780357108376

Author:Jean Andrews, Joy Dark, Jill West

Publisher:Jean Andrews, Joy Dark, Jill West

Chapter8: Network Infrastructure And Troubleshooting

Section: Chapter Questions

Problem 8TC

See similar textbooks

Similar questions

Multiple packets may be sent between hosts over a single connection. Timeframes for shipment clearance, please. Is there a predetermined length of time for one delay and some wiggle room for the other?
The first of these packets is from your computer to the DHCP server telling it to release the lease on your IP address. The next 4 packets renew that lease. Note that the source address on the “DHCP Discover” and “DHCP Request” packets is 0.0.0.0. This indicates that your computer does not actually use its new IP address until the interchange has completed. Also note that the destination address in each of the 4 packets is a broadcast address[1]. It should be obvious to you why the first two packets are broadcasted, but what about the last two? Can you explain this? Answer the questions in your Word document right after you post a snapshot of the DHCP packet screen. (#4)
In order to implement a DNS amplification attack, the attacker must trigger the creation of a sufficiently large volume of DNS response packets from the intermediary to exceed the capacity of the link to the target organization. Consider an attack where the DNS response packets are 500 bytes in size (ignoring framing overhead). a. How many of these packets per second must the attacker trigger to flood a target organization using a 30-Mbps link? A 100-Mbps link? Or a 1-Gbps link? b. If the DNS request packet to the intermediary is 60 bytes in size, how much bandwidth does the attacker consume to send the necessary rate of DNS request packets for each of these three cases?
b. Suppose that you are hired by a local company to set up a router that both serves as the network's bidirectional firewall and also NATS hosts in the corporate network. The corporate network consists of about 100,000 machines that simultaneously access the Internet using port-based NAT. What problem could arise if the corporate network only has a single public IP address?
For each subnet assign a private IP address (of the form a.b.c.d/y) such that:• The IP range is contained within 10.0.0.0/24.• The number of wasted IP address in each subnet is minimized.• The Forwarding table in the central router is minimized. Once IP address for each subnet are assigned, provide the forwarding table for the centralrouter. IN THE details PLZ ...
Many packets may travel at once via a connection between two hosts. Please provide a detailed schedule of the steps needed to accomplish a single delivery. Is it assumed that one of the delays will take a certain amount of time, while the duration of the other delay is flexible?
A standard IPV4 datagram with an initial total length 36.253 bytes reaches a router that has an MTU - 684 bytes. • The total number of fragments is • The offset of the second fragment is • The offset of the last fragment is • The number of bytes in the last fragment is
3. A router is blasting out IP packets whose total length (data plus header) is 1024 bytes. Assuming that packets live for 10 sec, what is the maximum line speed the router can operate at without danger of cycling through the IP datagram ID number space?
The packets listed below were received by your network's stateful firewall, and they are shown in the following table in random order. The IP addresses of two hosts in your LAN, IP1 and IP2, and two external hosts, IP3 and IP4, are assumed to be IP1 and IP2, respectively. Indicate the number of established sessions and the number of half-formed sessions by evaluating these packets. established sessions. Packet Direction Pa1 Pa2 Pa3 Pa4 Pa5 раб Pa7 Pa8 Pa9 out Out in Out In in out out In Source IP IP1 IP2 IP3 IP2 IP4 IP4 IP2 IP1 IP4 Dest. IP IP3 IP4 IP1 IP4 O None of them IP2 IP2 IP4 IP3 IP2 Source Dest. Port Port 23 X 25 23 25 y y 80 X n y X y 25 25 n 23 80 SYN 1 1 1 0 1 0 1 0 1 ACK 0 1 1 1 0 1 1 1 0 O The number of established sessions=2 & The number of half established sessions = 1 The number of established sessions=0 & The number of half established sessions - 3 O The number of established sessions 2 & The number of half established sessions = 2 O The number of established…
With Network Address Translation, a router changes a private IP address in the IP header to the public IP address of the router, and the source port number (TCP or UDP) is changed to a port number selected by the router. Assuming the transport layer protocol being used is UDP, what other field of the UDP header may need to be changed? a. Length O b. Destination port Checksum с.
A simple CIDR routing table is shown in Figure 1. For each of the destination IP addresses below, indicate which entry in the table it matches. Indicating none if no routing entry can be matched (hint: given an IP packet, the router will check whether there is a routing entry which can be used to route this packet, by checking the destination IP address in the packet with each routing entry: based on the subnet mask of each routing entry, it can extract the network ID and compare it with each routing entry; if there are a few routing entries which can match, the entry with the longest subnet mask wins). Address Mask Output Port 10.19.0.0/16 1 10.19.128/17 2 10.19.192/18 3 10.19.192/19 4 0.0.0.0/1 5 141.219.2.10 10.10.10.10 10.19.86.141 10.19.193.6 10.19.255.86 10.19.192.18
Given an original class B IPv4 public address, design a subnetted (subnet, sub-subnet, sub sub-subnet) computer network with three levels of subnetting. Find out the aggregated route at each level and the aggregated route for thewhole network through which it would connect to the internet. Write downthe necessary details and IP addresses.