Find the Thevenin equivalent circuit with respect to the terminals a,b for the circuit shown in Fig. P.9.46
Q: 3. The stability of the plant depands on its: a. Gain matrix. b. Sate matrix. c. Input matrix. d.…
A: 3)To analysis the stability of the plant depands on itsa)Gain matrix.b. Sate matrix.c. Input…
Q: Using the Ziegler- Nichols method, the critical gain was found to be 4.2 and the critical period was…
A: It is given that:
Q: Question 1 Figure 4 shows the conveyor systems actuate by a 3 phase induction motor (3-phase 415…
A: Reverse forward starter using DOL starter and safety
Q: 9. In the circuit shown in Fig. 13.43, find the average power absorbed by (a) the source; (b) each…
A: Given Data:A magnetically coupled circuit with,Supply voltage Angular frequency Self inductances…
Q: Design a wideband FM transmitter to achieve an output carrier frequency of fo = 1.7 GHz, and an…
A: Given:Front end of the FM transmitter has,.we need to design:Wideband FM transmitter with Also we…
Q: 6. Select the descriptions (18) that best matches each of Maxwell's equation: A) B) C) D) V.D = P₂…
A:
Q: 8. If x (t) = Asinc (Bt) (where A and B are constants), what is the signal's energy? Hints:…
A: The Fourier transform is a mathematical operation that transforms a function of time (or space) into…
Q: Q2: Given that the shown Fourier transform of the aperiodic voltage signal V(@). Determine: (3) The…
A:
Q: For the circuit shown above, what is the magnitude of the equivalent impedance as seen from the a-b…
A: Given circuit is shown below:To find:
Q: (a) FIND THE EQUIVALENT INDUCTANCE WITH RESPECT TO TERMINALS a, b. 18 мн эт a b a 25 ма т b вомн от…
A: we need to find equivalent inductance and capacitance in part (a) and (b) respectively.
Q: ! Required information In the circuit given below, R₁ = 3 Q and R₂ = 70. 4u(t) A R₁ Determine ( ∞)…
A: In this question, we need to determine the current at infinity and voltage at infinity.
Q: Find the system equations of the system shown in Fig. Also determine the f-V and f-i K DH K₂ K3 M₂…
A: Given:For the system, we need to find the system equations. Also we need to represent system…
Q: Problem 10 In the circuit below, the diodes D1 and D2 are and respectively (state ON / OFF) 5 V + 3…
A: Firstly, determine the open circuit voltage across the diode, and subsequently, identify the diode…
Q: Assume Vi=1∠0oV Find the phase shift of circuit
A: In the given circuit, with we need to find:The phase shift of circuit in computing V0 .
Q: The equations below represent (a) a first order RC circuit and (b) a second order RLC circuit. Use…
A: For the given differential equation of the first order and second order circuits, the value of the…
Q: 12 V 290° 10.66 Ω + j 8 Ω Z₁ Z₂ Find the maximum power that can be delivered to Z₂ Your answer…
A:
Q: The gate- source overlap capacitance is approximately.
A: Given Data:The three-dimensional view of a silicon n-channel MOS transistor is given in the figure.…
Q: V1 S1 L2 (a) ww R2 AICH) V₁ = 10v. C1 ww R1 ww R4 Given the circuit in figure 7 with values R3000…
A: Given circuit:Asked to find the,redraw the circuit with and label all voltages and currentcapacitor…
Q: equivalent impedance
A:
Q: X[n] = cos A data sequence is given by 2πη 16 +2 find the FFT where n = 0, 1, 2, ... 15
A:
Q: B= infinity, Assume BJTs are identical. Find R such that a DC current of 0.25mA for transistors Q1…
A: The amplifier circuit is gievn ashere
Q: 15 V Μ f i2 = 1 A, find i1 ‒‒ Q Search 6 Ω ww 10 Ω 10 V $ ww 4Ω ΤΟ 8:11 AM 12/11/2023 Π 203 A
A:
Q: P 9.5-4 Reconsider Problem P 9.4-1 when L = 640 mH and the other parameters and conditions remain…
A:
Q: Find the rms value of the waveform in Fig. 13 +4 -2 AU (V) 1 cycle Fig. 1: t (s)
A: The waveform figure is shown below,
Q: A 10kW, 125V series-connected DC generator has an armature circuit resistance of 0.1 ohm and a…
A:
Q: 1 B underneath For the vector K = 5z²pap - pz²az, calculate the total flux out of Side A For the…
A:
Q: A series RC circuit has |VR| = 12V and |VC| = 5V. - The magnitude of the supply voltage is: 13 V O…
A: Series RC circuit is an electrical circuit that consists of a resistor (R) and a capacitor (C)…
Q: (a) Determine the amplitude of the current & the phase difference b/w the voltage & current. (b)…
A:
Q: Rather than use transistors your friend W. Too wants to use diodes to implement logic gates. He…
A:
Q: The primary reason for adding an integrator to a closed-loop controller is to O Reduce rise time by…
A: It is asked to determine the primary purpose of adding an integrator to a closed-loop controller.
Q: The Thevenin’s theorem and Norton's theorem can be thought of as a shortcut, a way to reduce the…
A: Thevenin's and Norton's theorems simplify circuit analysis by reducing complex networks to…
Q: 3. Use Laplace transform to find i(t) of the circuit, where is = 0.5 cos 40t. 1092 www 4 H ell
A: Given:A circuit,we need to find:the current i(t) using Laplace transform.
Q: Refer the circuit in Figure Q3(a). Calculate the following: the Thevenin voltage, VTH. the Norton…
A:
Q: Q4) For the control system shown below, find a, K, K1, K2 and K3 if Known that 10 (S+ 1) R(S) + K K3…
A: The block diagram is given byThe transfer function of the system is given…
Q: An ideal transformer has 500 primary turns and 3000 secondary turns. If the primary voltage is 240…
A: Based on the given specifications of the ideal transformer the value of the output voltage needs to…
Q: The NMOS transistor has KP-50 μA/V², Vto-2 V, L=10 μm, and W=400 μm. Find the midband voltage gain,…
A:
Q: YT ZT R • 20 Ω XL 110 Ω calculate the magnitude of the input impedance in ohm
A: In given circuit we have given the two impedance in parallelSo let us say from the circuit resistive…
Q: (a) VTh= (b) ZTh= +j +j V. rounded to one decimal place 2. Rounded to one decimal place
A:
Q: Determine the values of K, m, J, and the expression of the output, if MPO = 28%, Tp = 2.2 sec, and…
A: The given block diagram of the closed-loop control system is shown below.The percentage overshoot is…
Q: Write an introduction to floating solar energy technology, you should consider the following key…
A: Floating solar energy technology is an innovative approach to harnessing solar power by deploying…
Q: A closed loop control system shown in figure below uses a PID controller. K R(s) C(s) 10+ 10k, S +…
A:
Q: 4. With respect to the following figure, explain why vo does not follow v₁ until VÂ – Vy and follows…
A: Given:A diode circuit, with output waveform, we need to explain:the operation of the circuit. Assume…
Q: 5 cos 1000t V i, (t) 40 6 mH :50 µF 10 Ω
A:
Q: 1. For a BJT with the following parameters, find the Beta cutoff frequency for this transistor * B =…
A:
Q: A zero order hold device and an electronic instrument have a transfer function g(s) =(43+1)-The…
A:
Q: H(s) = w = 20 rads-1 w = 2 x 104 rads-1 V₂(s) V₁(s) 8 + 200 8 +20 (d) Find v₂ (t) when v₁ (t) = 0.1…
A: The transfer function is given as
Q: The questions below pertain to the circuit above. The load requires 18V at 0.6A, and US standard 60…
A: According to the question, for the given circuit as shown belowWe need to analyze the above circuit.
Q: .A 1Ø 2,000kVA transformer has a primary voltage of 12kV, and a secondary voltage of 2.4kV What is…
A: The objective of this question is to calculate the full-load current of the primary and secondary…
Q: THE OP AMP IN THE FIND VO IN TERMS +₁1 5V 24 кл M 16K52 -M 24K2 M Us CIRCUIT BELOW IS IDEAL. OF US.…
A:
Q: Find the current I1 in amps. b. Find the current I2 in amps. c. Find the current I3 in amps.
A: In this question, we need to determine the currents I1 , I2 and I3 as shown in the circuit. We…
Find the Thevenin equivalent circuit with respect to the terminals a,b for the circuit shown in Fig. P.9.46
Step by step
Solved in 3 steps with 2 images
- For the sinusoidal waveform shown in Figure Q9 (i), Estimate: i. Frequency i. Amplitude ii. Magnitude of the voltage iv. RMS value of the voltage Sms 0.2 100ms 10 40 50ms Vollts/cm time/cmWhat is the mutual admittance, Y41, of the electric circuit shown in Figure 1? j0.1 Select one: a. -j0.4 b. -2-j3 c. 0 d. j0.4 2-j4 1-j4 j0.2 2 2-j5 j0.3 3 13 2-j3 4 j0.4 14The rms value of v(t)=Vmaxcos(t+) is given by a. Vmax b. Vmax/2 c. 2Vmax d. 2Vmax
- Let a 100V sinusoidal source be connected to a series combination of a 3 resistor, an 8 inductor, and a 4 capacitor. (a) Draw the circuit diagram. (b) Compute the series impedance. (C) Determine the current I delivered by the source. Is the current lagging or leading the source voltage? What is the power factor of this circuit?Ooredoo 876% D 9:31 Red Bull MOBILE Assignment EP se..6c205abd8b27a - Saved Q1. A square waveform with following specifications RMS Voltage 163.21 Time for two cycle 35ms Sketch the Square waveform. [1] Q2. A coil impedance of 680 is connected and the circuit has capacitance of 0.002mF isFor the phasor diagram in figure 6 express the voltages in sinusoids for a period of 5ms. Im Re )e,=45° e,=20 Vz=10 V2=8 Figure 7 a. Va(t)=. b. V2(t)=. c. What is the rms voltage of V1 = d. What is the rms voltage of V2=_ e. What is the frequency in Hz = f. What is the angular frequency =. In terms of lagging and leading what is the exact phase relationship between V, (t) and V2(t) g.
- (b) An engineer is required to analyse a sinusoidal waveform for the voltage and current using oscilloscope. The voltage waveform produced Root Mean Square (RMS) value at 75 V with positive-going zero crossing at 30°. While the RMS value of current is 66.71 A with negative-going zero crossing at 0.349 rad. Assume the frequeney of both waveforms is 50 Hz. (i) Sketch the voltage and current waveform in the same axis by showing the important point. (ii) Determine instantaneous voltage when t = 8ms . (iii) Determine phase relationship between voltage and current waveform.Convert -20 sin (wt + 10°) to cosine. A 20 cos(wt + 100) B) 20 cos(wt - 80) (c) 20 cos(wt + 190) D 20 cos(wt - 170)7 Find the average and effective values of voltage for sinusoidal waveform shown in Figure. Vm = 100 V 2x x14 9714 [Ans: 27.17 V, 47. 67 V]
- Given the circuit shown, answer the following questions 1 40 I U8 VS-24/60° V (+ one of the following statements is correct: Choose... Choose... 12 in Ampere equals to: 2.65-j0.54 the equivalent impedance in Ohm of the circuit is 7+j1.88 12 leads Vs by 60° 12 lags Vs by 71.58° -0.47+j1.75 12 leads Vs by 71.58° 12 leads Vs by 11.58° 3.26+j15.93 12 lags Vs by 11.58° 2.18+j1.21 8.24+j4.94 V2 in Volts equals to: m13-4-2021 Jump to...For the below sinusoidal voltage trace displayed by the CRO, the time/cm switch is on 0.2ms/cm and the volt/cm switch is on 1 V/cm. a) the frequency will be Hz b) the r.m.s value will be In CRO the beam can also be shifted vertically by applving a suitable DC voltage to theFind the average power for each element in the given circuit. In the given circuit, Vm 46.0020° V. (Include a minus sign if necessary.) Vm ΔΩ www j2 m -j2: 20/90° The power absorbed by the resistor is W. The power absorbed by the 46.0020° V source is The power absorbed by the 20.90° V source is The power absorbed by the inductor is W. The power absorbed by the capacitor is W. W. W. (Round the final answer to three decimal places.)