Find the drift velocity varift of conduction electrons in a gold wire of diameter 2.98 mm when a current of 0.175 A flows in it. The density of conduction electrons in gold is 5.90 x 1028 m-3, O 15.8 x 10-6 m/s O 17.8 x 10 6 m/s O 4.32 x 10 6 m/s O 2.66 x 106 m/s

Find the drift velocity varift of conduction electrons in a gold wire of diameter 2.98 mm when a current of 0.175 A flows in it. The density of conduction electrons in gold is 5.90 x 1028 m-3, O 15.8 x 10-6 m/s O 17.8 x 10 6 m/s O 4.32 x 10 6 m/s O 2.66 x 106 m/s

Electricity for Refrigeration, Heating, and Air Conditioning (MindTap Course List)

10th Edition

ISBN:9781337399128

Author:Russell E. Smith

Publisher:Russell E. Smith

Chapter12: Electronic Control Devices

Section: Chapter Questions

Problem 14RQ

See similar textbooks

Related questions

Q: 1. Calculate the component values necessary to give the design of a Class B common emitter amplifier...

Q: A copper wire of radius a = 0.172 mm has an aluminum jacket of outer radius b = 0.231 mm. There is a...

A: Data Given , Inner Radius of the wire ( a ) = 0.172 mm = 0.172 × 10-3 m Outer Radius of wire ( b ) ...

Q: Please use f=60 hz then solve Vrms and Vaverage. Always wrong answer pleasw help

A: In this question Sinusoidal waveform is given. So determine the rms and average value of the given ...

Q: E=14V R1=471 ohm R2=363 ohm R3=450 ohm Calculate ID2

A: In this question, If E=14V, R1=471ohm , R2=363 ohm, R3=450 ohm Calculate diode current in the dio...

Q: 196 G (s) = s (s + 8) Find the frequency domain specifications for the system

Q: Is it not important to match lamps to ballast because no harm will occur if they are mismatched

A: The ballast is used with the lamp specifically with the fluorescent lamp. The ballast is used to pro...

Q: Determine the terminal voltage of a 4-pole, 3-phase alternator that is running at 50 hz. The alterna...

A: Per phase induced emf = 4.44×f×flux×per phase turns× winding factor.

Q: 13- Find the Thevenin and Norton equivalent circuits between ab. 2 A b a 4Ω 6Ω 18 V 3 A 10 V Zoom 14

Q: Find current I, in the following circuit using the phasor approach, if Z1= 40 0, Zz= j30 0, Zg= 40 0...

Q: 10 V a 30 V 8 V

Q: Why are transformers more efficient than rotating electrical machines? *Cite your reference* Subject...

Q: A unity feedback system has been operated for 5 years and need to be evaluated. It has an open loop ...

A: Solution- Gs =Ks(s+1) (s+3) a) for 4.32% overshoot , e-πξ/1...

Q: 12 0 20 0 40 V 25 0 5A 40 0 Q#2. Find voltage V across the 40 O resistance using Superposition Metho...

Q: A six-pole three-phase wound-rotor motor is to be used as an induction frequency converter. The stat...

A: The solution is given below

Q: QUESTION 13 Save Answer A 4 unit apartment complex has a 150-ampere panel in each unit. What ampere ...

A: Given, A 4 unit apartment has a 150-ampere panel in each unit. Number of unit, n = 4 Each unit has c...

Q: A load of 1500 KW is connected at the receiving end of a 3 phase transmission line 80 km long. The p...

A: Given Transmission line Length L=80 kmLoad PL=1500 kwReceiving end voltage VL=21 kvPower factor PF...

Q: Q2/ For the current shown in the figure below, find the charge waveform and then find the value of c...

A: The solution is given below

Q: The three-phase balanced load in the figure below has impedance per phase of Zy =6 + 8j ohm. If the ...

A: Given, ZY=6+8j ΩVL=220 V

Q: Consider the circuit in Figure 2 below, with transistor parameters ß = ∞, V,

Q: 1. For the circuit shown below, a. determine the current I, by the nodal analysis. 12 0 ww 24 V 623 ...

A: Given circuit,

Q: Consider the signal x(t) whose Fourier transform is { 1, w| w. X(jw)

A: We have,fXω=∫-∞∞eipxXxdx=∫-∞-WeipxXxdx+∫-WWeipxXxdx+∫W∞eipxdx =∫-∞-Weipx0dx+∫-WWeipxXxd...

Q: Answer fast please Voltage is 60 volts and current is 4 amps.Find Resistance and power?

A: The solution is given below

Q: For the armature controlled DC motor shown, find the transfer function. Assume the following numeric...

A: Solution

Q: Find the wave impedance for the dominant mode in an air filled rectangular waveguide of dimension 8 ...

A: Given, Air filled rectangular wave-guide with dimensions a=8 cm=0.08 mb=5 cm=0.05 m Operating freque...

Q: Q2/ For the current shown in the figure below, find the charge waveform and then find the value of c...

A: The solution is given below

Q: Determine the exponential Fourier series for the impulse train shown below. x(t) 1 -2T -T 0 T 2т. 3п...

A: The solution is given below

Q: Q7: For the circuit in Fig 7, find i, iy, and the power dissipated by (absorbed by) the 3 S resistor...

A: In this question We need to determine the currents ix and iy as shown in the circuit. Power absorb ...

Q: polar coordinates are used mostly for drawing

A: 1)ANSWER IS ANGULAR LINES WE USE POLAR COORDINATES FOR ANGULAR LINES IN AUTOCAD FOR ELLIPSE AND CIRC...

Q: A circuit is operated at its resonant frequency, which is designed to be 240 Hz. The circuit contain...

Q: 3. Determine V, and V2. 1 + Vi lov( + V2_

A: Given circuit:

Q: HoW: Find xcn) if: +る Bns: xcn)-- 80 (t)^+ 80 (+)"-52n (t) +12n* (b)"

Q: A three-phase converter has a d-c rating of 120kw and 600volts. Assuming an efficiency of 94 percent...

Q: R1 XMM1 1k0 t01 R3: 5000 R2: 1kQ V1 12V

Q: What is the smallest number of poles that can be used in two synchronous machines if it is desired t...

Q: Use Kirchhoff's current law to determine the magnitudes and directions of the indicated currents in ...

A: This question belongs to electrical circuit theory . It is based on the concept of kirchhoff's curre...

Q: A 400V, 25hp, 601 4 pole, Y-connec induction motor I the following

A: Given that 400V,25hp,60Hz,4pole Y-coonected induction motorR1=0.641ΩRF=11.080ΩXl=1.106ΩXF=6.68ΩPr+W=...

Q: Three Impedances each of (9 - j18)N are connected in mesh across a three-phase 415V ac supply. Deter...

Q: 2 Efud inductoniee pes km per phace.

Q: 4.41 Find the Thevenin and Norton equivalents at terminals a-b of the circuit shown in Fig. 4.108. 1...

Q: A Karnaugh Map is shown below. Which function is the correct minimum sum derived from the Karnaugh M...

A: Given Karnaugh map,

Q: V2 R1 (+ 1 1000 0.7 V1 V 12 .OP +) (+)

Q: A short shunt compound generator has an armature,shunt field and series field resistances of 0.02 oh...

Q: Write the voltage as a function of the transformer turns ratio for the following circuits respecting...

A: This question belongs to electrical machine . It is based on the concept of relation between transfo...

Q: a) Design a saturated load inverter shown in the figure below with VDD = 3.3 V and VL = 0.25 V. Assu...

A: “Since you have asked multiple question, we will solve the first question for you. If you want any s...

Q: What size branch circuit THW conductors would you need (bare minimum) for an AC 3 phase 40 horse pow...

Q: 3- In a High Pass Filter, the filter response curve has a slop of 6dB/ octave with a cut of frequenc...

Q: Three identical capacitors are connected in delta to a 408 V, 50HZ, 3-phase supply. If the line curr...

A: Given data, Connection is delta, Line voltage VL=408 V For delta connection VL=VP=408 V Line curren...

Q: Voltage Peak value RMS value Average value Peak-to- peak value O V Time VT = Vmsinwt

A: Given, The wave form is sinusoidal. Please find the below attachment for the clear explanation.

Q: Q3. A discrete time LTI system described by y[n] + 0.5y[n – 2] – 0.3y[n – 3] = x[n] – 2x[n – 2]. Det...

A: Givenyn+0.5yn-2-0.3yn-3=xn-2xn-2

Q: Determine the operating power factor of a 6.6kV Y-connected synchronous motor has a synchronous reac...

A: Givenlet δ be the excitation angleThen excitation voltage Ef=6.6∠δ°KvInduced voltage V=5.16Kv/ph

Concept explainers

Capacitor

The capacitor is an element used to store electrical energy in the electrical field. A capacitor is a form of passive energy.

Question

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

How many valence electrons are generally contained in materials used for insulators?
The voltage sensitivities of Barium Titanate and Quartz are respectively 12 × 10-³ Vm/N and 15 × 10-3 Vm/N. Their respective permitivites are 12.5 × 10-⁹ F/m and 40.6 × 10-12 F/m. What are their charge sensitivites?
A resistor in the shape of a spherical shell is made up of a material with resistivity of 1.93 x 10-80-m has inner and outer radii of 1.5 mm and 3.7 mm, respectively. Determine the resistance of the said resistor. O 12.1038 microohms O The answer cannot be found on the other choices. O 608.8035 nanoohms O 902.9482 nanoohms
The voltage sensitivities of Barium Titanate and Quartz are respectively 12 X 10-3 Vm/N and 50 X 10-3 Vm/N. Their respective permittivities are 125 X 10-8 F/m and 40.6 X 10-12 F/m. What are their charge sensitivities?
If the are unknown semiconducting material how do you identify its type n . p or intrinsic
Four point charges are placed at corners of a square . At the top left is a charge of - 1 C, at the top right is a charge of - 2 C, at the bottom right is a charge of -3 Cand at the bottom left is a charge of - 4 C. What is the direction of the net electric force due to the four point charges on a positive charge Q located at the center of square ? O due North O due South O Sw O SE
Two parallel wires made of copper are placed in air. The inductance of each wire is 0.9 µH/m with diameter of 2mm. The external inductance is? 0.85 µH/m 0.85 H/m - 0.85 µH/m 0.85 mH/m 0.85n µH/m None O uH/m - 0.85 µH/m -0.85n µH/m
two dentiaal conducting SPheres have eta Charges 5.147 pC anl To851 pC sthe are Brought Ynto contacf and allowes do reaek equilibrow How many elcehouics are transfares equilibrum is attained
6 6 - A dielectric is a material that is: A) a semiconducting B) a nonconducting C) a superconducting D) none of them E) a conducting
QUESTION 3 E-05, PC-05. While testing of capacitor with the Multimeter it will show value of? will indicate charge voltage. some resistane. Cwill indicate amount of current it has. QUESTION 4 E-05, PC-02. What are the factors affecting the capacitance of capacitor. Area of plates only. O Area of plates and Dielectric media. O Area of plate, dielectric and distance between plates.
A certain batch of copper wire was found to have a conductivity of 98% at 20°C. What is its resistivity in u0-cm?
8. Liquids with solid impurities a) Have higher dielectrie strength b) Of large size have higher dielectric strength c) Have lower dielectric strength as compared to pure liquids d) None of the above 9. Peak to peak ripple is defined as a) the difference between average de voltage and peak value b) the difference between maximum and minimum de voltage c) the difference between maximum ac and average dc voltages d) the difference between ac (rms) and average de voltages 10. In a Cockroft-Walton circuit, input voltage 100 kV load current 25 mA, supply frequency 100 Hz, each capacitor 10 nF. The optimum no. of stages for maximum output voltage is a) 1 b) 2 c) 10 d) 35