Find the currents in the following circuit 6Ω www 20 V I₁ im 12. 452 www 13 10 V

Q: The spectrum X(jw) of input signal x(t) is given below: X(jw) -6 x(t) 1 2π 2 w/wo Moreover, the…

A: Given Data:A system with a noise of,To Find:The energy of the noise signal.

Q: Sample Problems Sample Problem 17: Finite Sheet of Charge The finite sheet 0 ≤ x ≤ 1,0 ≤ y ≤ 1 on…

A:

Q: 1. Design a digital Butterworth lowpass filter with the following specifications: Maximum…

A: Digital Butterworth Low pass filterIt is a type of filter that attenuates higher-frequency…

Q: Lin w=10 krad/s aQ + ν - V- duF O a. Zin = 690,00 +j141,92 ohm O b. Zin = 460,00 + j177,92 ohm O c.…

A: Given circuit:To determine:The input impedance of the circuit.

Q: What is the equivalent resistance in kOhm if three resistors of 4.3 kOhm, 1.4 kOhm, and 2.2 kOhm are…

A: Resistances are given,

Q: v. With reference to an 50 Hz3 phase alternator explain how P,Q,V and F are controlled.

A: It is asked to explain the control of P (active power),Q (reactive power), V (voltage) and F…

Q: In the series RLC circuit shown in Fig 2.1 below, find the current i(t) _t=0 Vin=20 V с 10 uF i(t)…

A:

Q: a question by considering the annual load time curve for an electric station as a straight line from…

A: Total capacity of Substation is the sum of power rating of each plant connected to that Substation…

Q: What is the difference between D Latch and D FF? a.) D FF is time dependent while D is not Latch b.)…

A: The flipflop is an edge-triggered device whereas the latch is a level-triggered device. so the…

Q: Input data at 75 bits/s are channel encoded using a rate encoder. The coded bits are then modulated…

A: Input data at 75 bits /s 1/2 encoder Coded bits are modulated using 8-ary FSK Frequency hopping rate…

Q: Shown below are four poles in the s-domain. Using Bilinear transformation with T = 1, pole A maps…

A: What is Bilinear Transformation?Bilinear transformation is a mathematical mapping of variables. It…

Q: In a time division multiplexing (TDM) system, consider a scenario where 10 different sources, each…

A: Time division multiplexing (TDM) system,Number of sources = 10Data rate per source = 1MbpsTDM frame…

Q: 2) A delta-connected load is supplied from a 230 V, 50 Hz source. If the load has R=100, L = 100 mH…

A:

Q: If v(t) = 180 cos 50t V and i(t) = –63 sin (50t – 30°) A, calculate the instantaneous power and the…

A:

Q: X(w) = π[8(w - 12) + 8(w + 12)] Find x(t). O a. cos(2pi12t) O b. cos(12t) O c. sin(12t) O d.…

A:

Q: Explain the phase locked loop and its sub components. Also explain where it is used in real life…

A: Explain the phase-locked loop and its sub-components. Also, explain where it is used in real-life…

Q: Question 2 Analyze the circuit shown in Figure Q2 to obtain Thevenin equivalent circuit at terminal…

A: We need to find out thevenin equivalent circuit and maximum power transferred to RTh .

Q: The impulse response of a digital filter is described by h[n] = (0.4)'u[n]. Evaluate and plot the…

A:

Q: 12V +1 A 3 ww www B 3 ww 6 2 www www 2 ww 4 4

A:

Q: A) State superposition theorem. B) Use superposition to determine the current i2 if vs=10V, is=2A,…

A:

Q: Candela is the unit of Select one: O wavelength O Luminous intensity O Luminous flux

A:

Q: 8. Determine the current through Ra in figure below using Superposition theorem. R3 2V R₁ Μ 1.0 ΚΩ…

A: According to superposition theorem the response of any branch can be calculated by the addition of…

Q: determine the pole and zero of this

A: In this questionWe need to determine the zeros and poles of the X(z).

Q: Also from same question, he required the value of K to make the system Marginally and the value of…

A:

Q: Example 2.1 A resistor of 1210 N is fed by an AC voltage source with frequency 50 Hz and voltage 220…

A: Given data:Supply voltage Resistance R = 1210 OhmsFrequency f = 50HzTo determine:Active power…

Q: IN www RB = 630K ww www Vcc=30V Rc =1.5K5 -IE-OUT B=100 RE1=50052 RE2 = 270

A: DC Analysis of the Circuits DC Analysis Value of Frequency Value of capacitance Substitutes the…

Q: m /6° v7 -j1 Ω Η I₁ j2 Ω 11 /45° V + 12 Μ 2Ω V ΤΟ

A:

Q: 2) The switch in the Circuit in Figure has been in position 1 for a long time. At t=0 it moves…

A: Step-1->We have the circuit

Q: A shunt motor on a 240- V line has an armature current of 75 A. If the field- circuit resistance is…

A: Line voltage Armature current Field resistance

Q: Find Req for the given circuit.

A: It is given that:

Q: ΧΩ M Ζ— j2Ω 1Ω 2Ω Η ΤΩ 202 Soru 1) X=57 olduğuna eşdeğer empedans Z değerini hesaplayınız. Question…

A:

Q: 3. Implement the function f(x₁,x₂₁x²₁x₁₁x) = x₁x₂x₂x² + x, x₂ + x₁x₂ + x₁x₁ + xxx by using a 4-to-1…

A: Given:A boolean function, To do:We have to implement the above given function function using 4:1…

Q: Can you please circle the answer of questions c and e because iits complicated

A: The above question is based on the root locus.

Q: 21, 4 Ω Find Vo (+) 12 V (m) V₁. ww 12 Ω V₂

A:

Q: (i) A 100 KVA, 4000 V / 200 V, 50 Hz single-phase transformer has 100 secondary turns. Determine:…

A: We are authorized to answer one question at a time, since you have not mentioned which question you…

Q: Question 3 Plot the root locus for the C.E. of system as 0<K<∞0. K S³ + 3s² + 2s 1+ E) Find Angle of…

A: As this is a follow up questions. The missing part in the solution provided was (E). The solution to…

Q: A coil of 100 turns and area 50 square centimeter is placed in a magnetic field B=2T The normal to…

A: Number of turns N = 100.Area Magnetic field B = 2 T.Angle between normal of the plane and coil

Q: 7. If the internal resistance of battery ignored, what is the electric current in the circuit shown…

A: It is given that:

Q: In the figure a 27 V battery is connected across capacitors of capacitances C₁ = C6 = 4.5 µF and =…

A: For the given capacitance circuit, the value of total capacitance, charge across the total…

Q: Using the superposition method, find the current value that only the voltage source has passed…

A: Given:A circuit, To find:Current through C4 capacitance due to only voltage source using…

Q: 1. Present complete solution to find the requirements in the problem described. Given: V1 5 R1 250…

A:

Q: 4) A balanced delta connected load of ...+j18 ohm per phase is connected at the end of a three phase…

A: It is given that a balanced delta connected load of  per phase is connected at the end of a…

Q: X(w) = π[ô(w — 8) + d(w + 8)] Find z(t). O a.sin(8t) O b. cos(2pi8t) O c. sin(2pi8t) O d. cos(8t)

A:

Q: it is Rth of the circuit below given that Vocis ss the 2 ohm resistor? = remove the 20 resistance…

A:

Q: 3) The Switch in the circuit shown in Figure has been closed for a long time. The Switch opens at…

A:

Q: Choosing the braking capacity of a circuit breaker must be: Select one: O Exactly equal bolted…

A: Here is a table that summarizes the braking capacity requirements for different types of short…

Q: QUESTION 12 An 6.6 kV. three-phase star-connected synchronous motor is working at full load and…

A:

Q: current in the circuit?

A: It is given that:

Q: A three port network that is completely characterized at the same frequency (f) by the following…

A: Solution:Given Data:Three Port network:Find :Here find Reflection Coefficient  Port 1 and…

Q: Motor driven by PWM using full-bridge operation provides finer resolution than half-bridge operation

A: Given statement:Motor-driven by PWM using full-bridge operation provides finer resolution than…

Current Division Method

The generalized current divider formula is given by the following relation below,