Do it all please Learning Goal:After conducting the experiment, you have collected data that needs analysis.In this experiment, a mixture of 0.087 g of hydrogen peroxide mixxed with an inert substance decomposed to evolve oxygen gas and water. You measured the following masses of evolved oxygen gas from four trials: 0.203 g. 0.200 g. 0.199 g. 0.205 g.Part AWhat is the average mass of oxygen gas evolved from the decomposition of hydrogen peroxide??gramsSubmitRequest AnswerPart BUsing the above calculated average mass, what is the percent of the original mixture that was hydrogen peroxide?SubmitRequest AnswerPart CIf the accepted value for mass percent is 52.3%, calculate the percent error.SubmitRequest Answer

In this experiment, a mixture of 0.987 g of hydrogen peroxide mixed with an inert substance…

Answered: Do it all please

Science

Chemistry

Do it all please

World of Chemistry, 3rd edition

3rd Edition

ISBN:9781133109655

Author:Steven S. Zumdahl, Susan L. Zumdahl, Donald J. DeCoste

Publisher:Steven S. Zumdahl, Susan L. Zumdahl, Donald J. DeCoste

Chapter7: Chemical Reactions: An Introduction

Section: Chapter Questions

Problem 47A

See similar textbooks

Similar questions

Alkali metal hydroxides are sometimes used to “scrub” excess carbon dioxide from the air in closed spaces (such as submarines and spacecraft). For example, lithium hydroxide reacts with carbon dioxide according to the unbalanced chemical equation :math>LiOH(s)+CO2(g)Li2CO3(s)+H2O(g) ppose a lithium hydroxide canister contains 155 g of LiOH(s). What mass of CO2(g)will the canister be able to absorb? If it is found that after 24 hours of use the canister has absorbed 102 g of carbon dioxide, what percentage of its capacity has been reached?
Magnesium ribbon reacts with acid to produce hydro- gen gas and magnesium ions. Different masses of magnesium ribbon are added to 10 mL of the acid. The volume of the hydrogen gas obtained is a measure of the number of moles of hydrogen produced by the reaction. Various measurements are given in the table below. (a) Draw a graph of the results by plotting the mass of Mg versus the volume of the hydrogen gas. (b) What is the limiting reactant in experiment 1? (c) What is the limiting reactant in experiment 3? (d) What is the limiting reactant in experiment 6? (e) Which experiment uses stoichiometric amounts of each reactant? (f) What volume of gas would be obtained if 0.300 g of Mg ribbon were used? If 0.010 g were used?
A possible practical way to eliminate oxides of nitrogen(such as NO2 ) from automobile exhaust gases uses cyanuricacid, C3N3(OH)3 . When heated to the relatively lowtemperature of 625°F, cyanuric acid converts to gaseousisocyanic acid (HNCO). Isocyanic acid reacts with NO2 inthe exhaust to form nitrogen, carbon dioxide, and water,all of which are normal constituents of the air. (a) Write balanced equations for these two reactions. (b) If the process described earlier became practical, howmuch cyanuric acid (in kilograms) would be requiredto absorb the 1.71010kgNO2 generated annuallyin auto exhaust in the United States?
The simplest example of the hydrogenation of a carbon-carbon double bond is the reaction between ethene and hydrogen in the presence of nickel: CH2=CH2+H2NiCH3CH3. When 5.20g of ethene react with excess hydrogen gas, the reaction yields 4.75g of ethane. What is the percentage yield for this reaction?
Electrolysis Determine the theoretical and percent yield of hydrogen gas if 36.0 g ofwater undergoes electrolysis to produce hydrogen and oxygen and 3.80 g of hydrogen is collected.
A single-replacement reaction occurs between copper and silver nitrate. When 63.5 g of copper reacts with 339.8 g of silver nitrate, 215.8 g of silver is produced. Write a balanced chemical equation for this reaction. What other product formed? What is the mass of the second product?
Small quantities of ammonia gas can be generated in the laboratory by heating an ammonium salt with a strong base. For example, ammonium chloride reacts with sodium hydroxide according to the following balanced equation: :math>NH4Cl(s)+NaOH(s)NH3(g)+NaCl(s)+N2O(g) at mass of ammonia gas is produced if 1.39 g of ammonium chloride reacts completely?
he production capacity for acrylonitrile (C3H3N)in the United States is over 2 billion pounds per year. Acrylonitrile, the building block tor acrylonitrile fibers and a variety of plastics, is produced from gaseous propylene, ammonia, and oxygen: :math>2C3H6(g)+2NH3(g)+3O22C3H3N(g)+6H2O(g) l type='a'> Assuming 100% yield, determine the mass of acrylonitrile which can be produced from the mixture below: l> Mass Reactant msp;5.23102g propylene td> msp;5.00102g ammonia td> msp;1.00103g oxygen td> i>What mass of water is formed from your mixture? Calculate the mass (in grams) of each reactant after the reaction is complete.
Write a chemical equation representing the decomposition of water into two gaseous products. What are the products?
In a blast furnace at high temperature, iron(III) oxide in ore reacts with carbon monoxide to produce metallic iron and carbon dioxide. The liquid iron produced is cooled and weighed. The reaction is run repeatedly with the same initial mass of iron(III) oxide, 19.0 g, but differing initial masses of carbon monoxide. The masses of iron obtained arc shown in this graph. (a) Write the balanced chemical equation for this reaction. (b) Calculate the mass of CO required to react completely with 19.0 g iron(III) oxide. (c) Calculate the mass of carbon dioxide produced when the reaction converts 10.0 g iron(III) oxide completely to products. (d) From the graph, determine which reactant is limiting when less than 10.0 g carbon monoxide is available to react with 19.0 g iron(III) oxide. (e) From the graph, determine which reactant is limiting when more than 10.0 g carbon monoxide is available to react with 19.0 g iron(III) oxide. (f) Calculate the percent yield if 24.0 g iron(III) oxide reacted with 20.0 g carbon monoxide to produce 15.9 g metallic iron. (g) Calculate the minimum mass of additional limiting reactant required to react with all of the excess of nonlimiting reactant from part (f).
onsider the balanced chemical equation :math>4Al(s)+3O2(g)2Al2O3(s). at mole ratio would you use to calculate how many moles of oxygen gas would be needed to react completely with a given number of moles of aluminum metal? What mole ratio would you use to calculate the number of moles of product that would be expected if a given number of moles of aluminum metal reacts completely?
Upon heating, mercury (II) oxide undergoes a decomposition reaction: 2HgO(s)2Hg(l)+O2(g) A sample of HgO weighing 7.22g was heated. The collected mercury weighed 5.95g. What was the percentage yield of the reaction?