dipole dipole interaction between aspirin and silica explanation pls and steps also

Q: Advantages and disadvantages relationship of conductance and conductivity.

A: Conductance It is defined as the reciprocal of resistance of a conductor or the ability of any…

Q: Make an analysis about this table: LIQUID DISTANCE TIME DISHWASHING LIQUID 30CM 59.25s

A: The above experiment is measurement of viscosity of dishwashing liquid.

Q: An ostwald viscometer was used to determine the time of flow of syrup at 20°C Data of water: Time of…

A: Viscosity is called the fluidity, a measure of the ease of flow. Relationship between viscocity of…

Q: 2.5 Polymer/Filler Interface and Mechanical Properties Talk in general about the influence of…

A: A series of composites that may be based on the low and high density polyethylene matrices with…

Q: Density and viscosity fatty acid at 42.5 degree and 1 atm

A: Answer as follows :- Explanation:

Q: Please give me a paragraph of discussion for Polyacrylonitrile (PAN) membrane.

A:

Q: Sketch portions of a linear polypropylene molecule that are (a) syndiotactic, (b)atactic, and (c)…

A: We have to sketch portions of a linear polypropylene molecule that are (a) syndiotactic, (b)atactic,…

Q: Carbowax column means the stationary phase used is O 50% phenyl polydimethyl siloxane O polyethylene…

A: Carbowax is a widely used polar stationary phase in gas column chromatography. This carbowax columns…

Q: NaOBut CH,NO2

A: nucleophilic addition of carbanion to α,β-unsaturated carbonyl compound (MICHAEL REACTION)  example…

Q: true or false A desirable solvent should be highly pure, commercially available, low viscosity and…

A: The given statement is " A desirable solvent should be highly pure, commercially available, low…

Q: ssing through a medium causes areas of:

A: This question is related to waves.

Q: How ion rotate in magnet of analyzer which ion deflect more with higher radius and low?

A: When the ion beam enters into a magnetic field (the region between two poles of a magnet). When a…

Q: os the enrgy cost to break IMFs for acetone to mix with water likely larger or smaller?

A: We found generally that acetone evaporates much more quickly than water, suggesting that the IMFs…

Q: 3) Answer the following questions on structural imperfections. a) Classify the structural…

A: Any deviations from the ideal behavior are known as imperfection or defects. Defects exist any all…

Q: 7) Calculate the viscosity (micropoises) of molecular oxygen at 273.2 K and 1 bar. The molecular…

A: From given data's Initially we are calculating mass of molecule of oxygen and then using viscosity…

Q: An Ostwald viscometer was used to determine the time of flow of dishwashing soap at 20 °C. Data for…

A:

Q: If a non-polar mobile phase is used in a non-polar stationary phase, the polar components in a…

A: In the given question,  the nature of chromatograpy is discussed based on the polarity concept of…

Q: A small amount of resin weighing 4.56g occupies a height of a 10-mL graduated cylinder equivalent to…

A: A small amount of resin weighing 4.56g occupies a height of a 10-ml graduated cylinder equivalent to…

Q: Which of these graphs allows you to determine your CMC? CMC CMC In(concentration) Concentration…

A: The CMC is an important characteristics of surface tension. The surface tension changes strongly…

Q: Write short note on the given topics:  Co acervation method of microencapsulation

A: Write short note on the given topics: Coacervation method of microencapsulation.

Q: What is the best way to differentiate between Cohesion and Adhesion?

A: When to different type of molecules attract each other then it is known as adhesion. Whereas the…

Q: Syneresis is a process by which there is the loss of water trapped within the gel matrix through the…

A: Syneresis is a process by which there is loss of water trapped within gel matrix through release of…

Q: Having too much sample can cause an inaccurate melting point under these Sir how will the observed…

A: If heating occurs too quickly, the material cannot reach thermal equilibrium. Pure substances melt…

Q: To test melting point the sample should: * O expose to high rate of heating be in large amount…

A: The sample should be in large amount inside the capillary tube.

Q: Describe the phenomena used for stabilization of emulsion and suspension?

A: As mentioned, emulsions are stabilized with surfactants (emulsifying agents) that have affinities…

Q: Sol Gel Aerosol Emulsion Foam Solid in Liquid Liquid in Gas Liquid in Solid

A: The mixtures given are,

Q: Could you determine the density of bromoform using water? why or why not?

A: Introduction: Density: Density is measured as mass per unit volume. The substance with high density…

Q: REPORT SHEET Rr (show calculations below the Distance from Distance from Color of spot(s) origin to…

A: The components in the unknown sample can be identified by comparing their colors and Rf values with…

Q: EASSY ABOUT SURFACE CHARACTERIZATION OF COPPER NANOPARTICLE USING TEM

A: Transmission electron microscopy (TEM) is a microscopy technique in which a beam of electrons is…

Q: stung field d syateme square planes gienaty?

A: Strong field ligands The types of ligands that produces large splitting is called strong field…

Q: Define angle strai

A: The branch of chemistry that explains the structure, properties and chemical reactions of organic…

Q: How does PEG / PPG Dimethicone (below) differ from a regular linear Dimethicone. What…

A: PEG/PPG dimethicone differ from a regular linear Dimethicone in the sense that these polymers have a…

Q: Make an analysis about this table LIQUID DISTANCE TIME COOKING OIL 45 CM 20.47

A:

Q: In a surfactant molecule the active head surface area was 70 (secured angstroms) whereas it is…

A: Calculation of critical packing parameter: CPP=Vao×lc                                     ...... (1)…

Q: Are the IMFs stronger in relaxed or stretched rubber?

A: Solution :        Elastomers are those polymers in which chains of polymer are held by weak…

Q: - Discuss the relationship between wetting and contact angle and describe the applications of…

A: “Since you have asked multiple question, we will solve the first question for you. If youwant any…

Q: Introduction Measurement of Latent Heat of Evaporation

A: Heat energy absorbed by the liquid to convert into vapor at its normal boiling point and pressure is…

Q: O Is it easier to fit a interstitial atom above or below the dislocation line shown bolow? 出

A:

Q: Discuss the importance of bulk vs. surface properties of biomaterials. Briefly describe the…

A:

Q: Top Down View Chair Form ОН ОН OH HO ОН НО HO, НО ОН Figure 2: Top-down and 3D (Chair) views of B-D…

A: Top-down projection, Haworth projection and Chair projections are conveniently used to show the…

Q: 1. What is the purpose of the boiling chips?

A:

Q: Conclusion about Types of Water Sampler

A:

Q: Distance Between Atoms You can click the Custom Attraction radio button and set the Interaction…

A: From the given graph between potential energy versus distance between atoms the following results…

Q: -uld hydrogen bonding be expected?

A:

Q: Prepare a report explaination on Bending Test - Compression Test

A: What is a Compression Test? compression test is any test in which a material experiences opposing…