Determine the following quantities for each of the circuits shown below a) the equivalent resistance b) the current from the power supply and the current through each resistor c) the voltage drop across each resistor

Q: 9. Fill the truth table of the comparator shown below, where, A=A1Ao and B-BB Inputs Outputs A: A B…

A: According to the question, we need to write the truth table for the 2-bit compartor circuit.

Q: Linear Feedback Systems

A: The given question is explained in step by step manner.

Q: Q1) If D = 4p² ap - 3p sin(0) a0 C/m², find (a) The volume charge density at (2, 30°, 3) (b) The…

A:

Q: A unity feedback system has the open loop transfer function shown below. Find the angle of…

A: For the given open loop transfer function the angle of departure needs to be calculated.

Q: a Initially the circuit is closed and the steady state is reached. At time t=0, the switch is…

A:

Q: 1. In perfect regulation control system the control effort at transient response must has:

A: (1)LQR is an ideal control technique that requires the least amount of control work to accomplish…

Q: S16_2.pdf For the block diagram in the attached pdf. 1 Find c when D (s) = ― and R(s) = 0. SS S…

A:

Q: 1 Sketch FM and PM waves for the modulating signal m(t) shown in Fig. (a). The constants ky and kp…

A: To sketch the frequency-modulated (FM) and phase-modulated (PM) waves for the modulating signal m(t)…

Q: 2 watt meters are used to measure the input of a 400 V 3 phase motor which has a full load output of…

A: The objective of the question is to find the reading on each watt meter and the full load current of…

Q: Q18. The input voltage of the below ideal op amp circuit is provided in figure (b). Its output…

A:

Q: B. Find the inverse Fourier transform of the following (answer on w+5 w+4 1) F(w) = stion 3: 2) F(w)…

A:

Q: The circuit shown below is in de steady state, find Vc and i₁.

A: The circuit is given ashere we need to calculate the voltage across capacitor and current through…

Q: Find time 't' (m sec). When the transistor enters saturation |VBE = 0.7V,VCE = 0.2V, Blarge (ON)…

A: Given Data: Required Data:We need to find time "t" when the transistor enters saturation region.

Q: A unity feedback system has the open loop transfer function shown below. What is the phase crossover…

A: The phase crossover frequency in control systems refers to the frequency at which the phase of the…

Q: For the below circuit step by step  a) Draw mirrored circuit where voltage indicator and passive…

A: The objective of the question is to analyze a given electrical circuit with various elements such as…

Q: Q3) Find the inverse Z transform for X(z): X(z) = z²+0.5 Z-0.32 (1-0.5 Z-1) (Z - 0.5)²

A: Given Data:A transfer function of a system is given as,To Find:The inverse Z-transform.

Q: CHAPTER 6 Wiring Methods 10. What is the minimum cubic in. volume that is permissible for the…

A: An enclosure in an electrical wire system that provides access to conductors for connecting,…

Q: ind the output voltage vo(t) using the Fourier transform for the circuit given when v(t) = e'u(-t) +…

A: Given Data:An RC circuit of,Here, the input voltage is To Find:The output voltage.The output…

Q: Problem 5. We are transmitting our 12/4 APSK waveform with outer ring voltage 5 Volts and inner ring…

A: We need to find out cancellation ratio for given ASK .

Q: 10. In the circuit, the switch moves from position 1 to position 2 at t = 0, find vo(t), for t≥ 0.…

A: In this question, we need to determine the voltage Vo (t) for time t>0.We know, capacitor act as…

Q: How do you make this conversion?

A: The conversion of rectangular form into polar form needs to be briefed.

Q: Consider the head (the distance between the waterfalls) of the Run-of-River Hydro Power Plant is 5…

A: The objective of the question is to calculate the highest possible power output of a turbine in a…

Q: VCE) is (1), R₂ FISCH) 1 C1 1₂. (C) Input → V(t) Output V₂(t) →>>> roon Ri √₂ (107²2 Find state…

A: The given circuit is shown below.The state variables are defined as  and .Note:(i) Here  is current…

Q: B) Consider the control system shown in Figure below which a PID controller is used to control the…

A: Given Data:A unity, negative feedback system with,Plant PID control system To Find:The values of the…

Q: Problem2) The switch in the circuit in Figure P2 has been open for a long time before closing at t =…

A: Given:A circuit,the switch has been closed for long time before t=0. we need to find:

Q: 2. Consider Is it BIBO stable? -1 * = [¹ 10x + [²]u น 0 y = [-2 3]x2u

A:

Q: Question 10: For the given circuit, find the value of the unknown current i (Hint: You may use…

A: Given:a circuit, we need to find the value of current i.

Q: This is about the integrated fabrication process for microelectronic devices for a bipolar n-p-n…

A: According to the question, we need to explain the fabrication process flow for a bipolar n-p-n…

Q: Question 1 Assume that the switch in Figure 1 has been in position A for a long time and is moved to…

A: An RC circuit consists of a resistor (R) and a capacitor (C) connected in series or parallel. It's…

Q: Problem 3) Assume that at the instant the 60 mA dc current source is applied to the circuit in…

A: The given circuit is shown below.The value of resistance is .Initial conditions are  Volts…

Q: Design a program using the 8085 microprocessor assembly language that performs the following tasks:…

A: Design a program using the 8085 microprocessor assembly language that performs the following…

Q: Problem 4. We are transmitting our 12/4 APSK waveform with outer ring roldon voltage 5 Volts and…

A:

Q: A bipolar junction transistor has ICBO = 0.5 mA, common base current gain a = 0.98 and emitter СВО…

A: Given Data:Required Data:Here, we need to determine the transconductance of the transistor…

Q: Problem #1 a) Solve circuit in Figure 1 using Node Voltage or KVL/KCL method. b) Find and mark all…

A:

Q: = A PV system that used an inverter with Nominal DC Voltage/ Maximum DC Voltage (720 VDC/900 VDC), 2…

A: PV Array Design Given:Inverter Nominal DC Voltage (Vdcn): 720 VDCInverter Maximum DC Voltage…

Q: Derive the equations of active, reactive and apparent powers in a series R-L circuit with sinusoidal…

A: An R-L series circuit,Asked to derive the expressions for the Active, Reactive and apparent powers?

Q: Q2) Explain briefly with figures the data flow control between I/O pins block in Actel FPGA family.

A: According to the question, we need to explain Actel FPGA.

Q: Represent the translational mechanical system shown in Figure Q.2 in state space equation, where x₂…

A: For the given translational mechanical system, the mechanical parameters are as follows:Mass: m1=8…

Q: For one-phase appliance of R-L type (e.g. electrical motor) with active input power P = 10 kW and…

A: The supply voltage is  Volts.Operating power factor of the motor is .New power factor is .Input…

Q: The state variable description of an LTI system is given by X1 a1 x2 + u 00 X3 (0)-(69) (0) (0)-…

A: The state variable description of an LTI system is given.Required Data:Here, we need to determine…

Q: Q1/ Draw the Bode log-magnitude and phase plots for the system shown in figure below, where K=50,…

A: Given:a control system, with K=50we need to do: draw the Bode log magnitude and phase plots for the…

Q: Vin W/L = 30/0.18 1 = 0, voltage gaim = 10, J Power Consumption is 2mW. Un (ox = 200μ A/V², Uthi =…

A:

Q: Consider an LTI system for which the system function H(s) has the pole-zero pattern shown in Figure…

A: Given plot is,(a) Indicate all possible ROCs associated with pole zero plot,(b) System is stable…

Q: Problem 18. The ideal peak gai 12 GHz frequency is? a. 41.0 dBi b. 41.3 dBi c. 42.0 dBi d. 42.3 dBi…

A: Formula for Peak Gain (dBi)G = 10 log10 (4πA / λ^2) hereG = Peak Gain in decibels (dBi) A =…

Q: Find the equivalent resistance of Req of the following circuit where each resistors has a value of…

A:

Q: Determine the equivalent inductance of the following network.

A: Given data:Required information:

Q: Find Thevenin e q. ckt across a-b. I'll 411 VIEAN 1 b PO -jan 11 ± 6 Loºv {11 211.

A:

Q: What is the current in the inductor ILO in continuity mode before opening the switch. R₁ Select one:…

A: The objective of the question is to find the current in the inductor ILO in continuity mode before…

Q: Given the voltage drop & current flowing through an element: (a) indicate whether the element is…

A: Calculate sine waveform  current into cosine form.If voltage and current are in phase with each…

Q: A unity feedback system has the open loop transfer function shown below. Find the imaginary axis…

A: For the given open loop transfer function the point at which the root locus crosses the imaginary…

KVL and KCL

KVL stands for Kirchhoff voltage law. KVL states that the total voltage drops around the loop in any closed electric circuit is equal to the sum of total voltage drop in the same closed loop.

Sign Convention

Science and technology incorporate some ideas and techniques of their own to understand a system skilfully and easily. These techniques are called conventions. For example: Sign conventions of mirrors are used to understand the phenomenon of reflection and refraction in an easier way.