Describe the preparation of a 700 mL of 4.36% (w/v) aqueous ethanol (C2H; OH, 46.1 g/mol). Weigh ___ g ethanol and add enough water to give a final volume of ____ mL. 700 g of 4.36% (w/w) aqueous ethanol. Mix ____ g ethanol with ____ g water. 700 mL of 4.36% (v/v) aqueous ethanol. Dilute ____ mL ethanol with enough water to give a final volume of ____ mL.

Q: Dissolve 1000 g of Potassium Iodide in 650 mL hot purified water using a 2 L capacity beaker. Allow…

A: Mass of Potassium iodide added = 1000 g Volume of Potassium iodide solution = 1 L = 1000 mL For…

Q: Preparation of Solution: Describe how to make the following solutions: a. 500.0 g of a 5.32% w/w…

A: a) Given: %(w/w) of H2S = 5.32 % And mass of solution = 500.0 g.

Q: Prepare 1 liter of 0.5M sulfuric acid from a concentrated aqueous solution. Sulfuric acid density is…

A: H2SO4 We have to determine the concentration of H2SO4 first and then dilute to prepare 1 L of 0.5 M…

Q: A student observes crystals at the bottom of a flask that contains a solution of LiBr in water.…

A: Interpretation: We have to check whether crystals will be forming or not when LiBr is taken in…

Q: At 25.0 °C the Henry's Law constant for nitrogen monoxide (NO) gas in water is 0.0019 M/atm.…

A: According to Henry's law at constant temperature, molar concentration of a gas dissolved in a liquid…

Q: 2. Which statement is true about the solubility of alcohols in water?       A. Alcohols are always…

A: Answer:- This question is answered by using the simple concept of solubility of alcohol in water and…

Q: Calculate the hardness of a water sample containing 21.4 ppm Mg2 and 51.9 ppm Ca2. O 165.1…

A: The hardness of water is due to the presence of calcium and magnesium ions. There are two types of…

Q: Household bleach is one of the most commonly used disinfectants this pandemic. Its major chemical…

A: There are several ways to express the concentration of solutions. Some of them are molarity,…

Q: The latent heat of vaporization of water at 100 oC is 539 kcal/kg. Calculate the boiling point of…

A: The boiling point of water can be determined by the Clausius-Calyperon equation. It can be given as:…

Q: Calculate the mass in grams for pure oxygen at 1.00 atm dissolved in 3.00 L of water with a kH =…

A: Given  pressure of gas =1.00 atm Volume of water = 3.0 L temperature = 20.0 oC. Henry constant (kH)…

Q: Which of the following is FALSE regarding water treatment? A Settling of floc during sedimentation…

A: It discusses some of the important processes involved in the purification of water body by means of…

Q: If the solubility of sucrose in 100 mL of H 2O is 204 g at 20 °C and 260 g at 50 °C, label each of…

A: Hi, since you have posted questions with multiple subparts we will answer the first three subparts…

Q: A 9.97 M solution of NaOH has a density of 1.33 g/cm3 at 20°C.  Assume you have 1.00 L of solution.…

A: 1. First calculate the mole of NaOH. NaOH moles=1.00L×9.97M=9.97mol Next the mass of NaOH, solution…

Q: 2.91 moles of silcon dioxide (SiO2) are dissolved in a 1.93 kg aqueous solution. What are the ppm of…

A: Given,  1. Moles of SiO2 = 2.91 mole  Mass of solution = 1.93 kg  What are the ppm of SiO2 in this…

Q: 500 mL of 1.0 M HCl solution from a concentrated reagent. Concentrated HCl is 36% (w/w)

A: The molarity of the solution is the number of moles of solute present in 1 litre of the solution.…

Q: If the solubility of KCl in 100 mL of H 2O is 34 g at 20 °C and 43 g at 50 °C, label each of the…

A:

Q: What does the process of recrystallization accomplish? 1) Place toxic chemicals into pure materials…

A: Recrystallization is the process of purification of organic compounds. Hence, the process of…

Q: How much distilled water must be added to a 25.00 mL 0.5104 M aqueous H2SO4 solution to prepare a…

A:

Q: 1. What are some common uses for simple distillation? What are some common uses for fractional…

A:

Q: How would you prepare 1.10 L of a 0.40-M solution of each of the following? 1. H2SO4from…

A: NOTE - As per our company guideline we can answer only 3 sub parts. kindly repost the question…

Q: A student took 6 g ethanol (density 1.5g/ml) and made a cream of them whose total weight = 200g,…

A: The mass of ethanol is = 6 g The total mass of ethanol and cream is = 200 g The percent…

Q: 28. A solution contains 125 g of a compound and 555 g water.   The boiling point  of the pure…

A: We have to predict the molar mass of compounds.

Q: 2. What is the percent by mass of a solution that contains 20 g of sodium hydrogen carbonate…

A:

Q: At 25.0 °C the Henry's Law constant for hydrogen sulfide (H₂S) gas in water is 0.087 M/atm.…

A: Given :  Henry law constant (KH) = 0.087 M/atm  Volume of water = 575 ml  Partial pressure of H2S =…

Q: Calculate the solubility of oxygen in water at the top of Mt. Everest where the atmospheric pressure…

A: Henry law: Pressure of a gas is directly proportional to the mole fraction of that component.…

Q: how you would make 500 mL of a 3.5% (v/v) ethanol solution (m.w. = 46.1 g/mol).

A:

Q: ns Lewis structures for I2, acetone, ethanol, and acetic acid. 2. If a student wanted to make an…

A: Atomic mass of iodine = 126.9g/mol Molecular mass of iodine = 2 × 126.9   = 253.8g/mol Volume of…

Q: 114.7 mg of NaCl (MM=58.44 g) is dissolved in 246.42 L of water. What is the concentration of Na+…

A: A numerical problem based on concept of solutions, which is to be accomplished.

Q: What is the partial pressure of CO2 (in atm) above a solution if if 8.86 g are dissolved in 371.7 mL…

A: Given: Mass of CO2 is 8.86 g. Volume of water is 371.7 mL. Henry’s law constant (KH) for CO2 is…

Q: Name: CH 103 – Introduction to Inorganic and Organic Chemistry Exp. 14 - Solutions and Solubility…

A:

Q: 1) Use the experimental data and the graph on the next page to construct a Beer's Law plot. 2) If an…

A:

Q: Calculate the mole fraction of sulfuric acid (H2SO4) in 8% (w/w) aqueous H2SO4 solution. Assume that…

A: w/w % concentration of sulfuric acid = 8 %Mass of aqueous solution = 100 gHere we have to…

Q: The boiling point of pure water (MM = 18.016 g/mol) is 100°C.  What is the boiling point of a…

A: Answer:- This question is answered by using the simple concept of elevation in the boiling point…

Q: 1-melting point helps to identify unknown samples. true or false 2-the reaction of one mole of hydro…

A: 1-melting point helps to identify unknown samples. True Reason: melting or depression in melting…

Q: . Place a cup of water in a beaker or a pan. Then heat it using a hot plate or stove. Place a…

A: Since you have asked multiple question, we will solve the first question for you.If you want any…

Q: Calculate grams of sucrose that must be added to 112.5 grams of water to prepare a 12.5 % by mass…

A:

Q: A dilute solution of NaCl has a weight per volume percentage of 15% (w/v). What mass of NaCl pellets…

A: We have to calculate mass of NaCl pellets needed to prepare the solution

Q: To what volume should you dilute 45.00 ml of a 6.00 M nitric acid solution to produce a 2.25 M…

A: Given: Volume of initial solution is 45 mL. Molarity of initial solution is 6.00 M. Molarity of…

Q: please highlight the correct answer

A: Since you have asked multiple questions, we will solve the first question for you. If you want any…

Q: (A)The following figure is the open chain structure of Glucose molecule. There are certain…

A: Hey, since you have asked multiple question, we will solve the first question for you. If you want…

Q: For questions #23 - #27 A solution is made by dissolving 6.26g NaOH in 25.2g water. 19. What is the…

A: The number of moles of a substance is given as the mass of the substance upon its molar mass. The…

Q: Which of the following would be expected to have the highest solubility in water! Η Η | I H-C-C-O-H…

A: The functional groups are responsible for the different chemical reactions shown by the organic…

Q: Why cannot oils and water-soluble products be mixed and heated together? Why should heating be at…

A: Oils and fats are non-polar compound (hydrocarbon) and water is non-polar compound and water…

Q: A solution contains 125 g of a compound and 555 g water.   The boiling point  of the pure solvent is…

A: Given :-  Mass of compound = 125 g   Mass of solvent = 555 g or 0.555 kg  boiling point  of the…

Q: Please help me With an in-depth explanation

A: A) The alcohol (Ethanol) has lower boiling point because the water has two OH bonds and two lone…

Q: The density of concentrated ammonia, which is 28.0% w/w NH3 is 0.899 g/mL. What volume of this…

A: Given, Concentration of concentrated ammonia solution = 28.0 % w/w Density of NH3 solution = 0.899…

Q: Compare the percentages of water for each trial?  Are they close to one another?  Why/why not?…

A: Given: percentages of water for each trial: trial 1 = 28.6% trial 2 = 29.8% trial 3 = 24.8% trial 4…

Q: How many milliliters of water should be added to 3.3 mL of 18.2 MH 2SO4 in order to prepare 0.10 M…

A: Since you have asked multiple questions, we will solve the first question for you. If you want any…

Q: What is the molarity of ethanol in 90% proof whisky? Density of alcohol = 98 g/mL A. 8.73 M C. 8.37…

A: