defeat Water is pumped from a lake to a storage tank 80 m above at a rate of 0.005 m³/s. If the GL pump-motor efficiency is 75%, and the irreversible head loss is 15 m. a) Find the consumed electric power by the pump. b) Find the pressure difference across the pump. 20 80 m ZT² Pump Storage tank 20 Zz Z

defeat Water is pumped from a lake to a storage tank 80 m above at a rate of 0.005 m³/s. If the GL pump-motor efficiency is 75%, and the irreversible head loss is 15 m. a) Find the consumed electric power by the pump. b) Find the pressure difference across the pump. 20 80 m ZT² Pump Storage tank 20 Zz Z

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

USE EXCEL Water at 20 degrees celsius is to be pumped from a reservoir (ZA=2m) to another reservoir at a higher elevation (ZB=9m) through two 25 m long plastic pipes connected in parallel. The diameters of the two pipes are 3cm and 5cm. Water is to be pumped by a 68 percent efficient motor pump unit that draws 7kw of electric power during operation. The minor losses and the head loss in the pipes that connect the parallel pipes to the two reservoirs are considered to be negligible. Determine the total flow rate between the reservoirs and the flow rates through each of the parallel pipes
What is the required pump power (Pa) for the system below? The source reservoir is on the right side of the figure The outflow is released as a water jet to the atmosphere (on the left) Discharge rate is 0.11 m3/s Pipe total length is 180 m Pipe diameter is 0.2 m Friction factor (f) is 0.01 Minor losses are negligibleCHOOSE ONE: 25 KiloWatt 169 KiloWatt 269 KiloWatt 112 KiloWatt
Pump BC shown brings oil (SG = 0.72) to reservoir D at 170 L/sec. The energy lost from A to B is 1.1 J/N and from C to D is 4.7 J/N. El. 84 m D EL 22.6 m A 0.30-m Ø B El. 2.8m How many hp does the pump supply the system? O 108.164 hp O 112.069 hp O 150.228 hp O 80.690 hp
A closed tank contains liquified butane gas whose specific gravity is 0.60. The tank pressure is 1.7 Mpa gage which is also the equilibrium vapor pressure of butane at the pumping temperature. Suction lines losses is 1.5m of gas and the static elevation gain is 4m. What is the NET POSITIVE SUCTION HEAD AVAILABLE?(NPSHa)
Question 2 Oil (SG = 0.85) is flowing in a 10cm diameter pipe. The elevation of the pipe is 5m above the datum line and the pressure in the pipe is -24KP.. If the discharge in the pipe is 30 L/s, determine the power (in watts) in the stream at that point. A 843.17 Watts B 648.28 Watts (c) 926.41 Watts D No answer among the choices E 716.69 Watts
A pump is to deliver 80 GPM of water at a density of 61. 83lb/ft cubed with a discharge pressure of 150 psig. Suction pressure indicates a 2 HG vacuum. The diameter of the suction and the discharge are 5 in. and 4 in. respectively. The pump has an efficiency of 70% while the motor efficiency is 80%. Determine the (a) water horsepower of the pump (b) bhp of pump motor (c) power input to drive the motor.
Q2/ If the turbine extracts 400 kW from the flow, what flowrate must be passing through the system? Water El. 105 600 m 0.6 m d-/0.020 600 m El. 30
in a pelton wheel, the bucket peripheral speed is 8m/s, the water jet velocity is 20m/s and volumetric flow rate of the jet is 0.1m^3/s. Is the jet deflection angle is 120 degree and the flow is ideal. Determine the power developed ?
40gal/min of water is pumped and the energy loss in the discharge line is13.5 feet and at the suction line it is 2.5 feet. If the steel suction pipeis 2.5” in diameter and the steel discharge is 1.5” in diameter. The pressureat the distribution tank is 30 psi. Determine a) the pressure at the outlet of thepump b) the power in kW of the pump.
If water is pumped from reservoir 1 to reservoir 2 through a 20 cm pipe with a length L1=70 m, and flow rate of 150 L/s, determine the pump power. -6' 2 (take kinematic viscosity= 1.3 10 m/s, Ks=0.02 mm) Elevation =35 m Elevation = 15 m L1 .40 m- Select one: a. 46.32 kW b. 45.13 kW c. 43.93 kW d. 41.55 kW
[CE Hydraulics] 3. In a pipeline with converging diameter, will the gradient of the total energy line be steeper or milder than the gradient of the piezometric head line? Why?
The allowable Net Positive Sustion Head (NPSH) for a pump provided by the manufacturer for a flow of 0.05 m³/s is 3.3 m. The temperature of water is 30° C (vapour pressure head absolute = 0.44 m), atmosphere pressure is 100 kPa absolute and the head loss from the reservoir to pump is 0.3 N-m/N. Find the maximum height of the pump above the sustion reservoir.