Data at a bit rate R, must be transmitted using either binary NRZ polar signaling or 8-ary PAM NRZ polar signaling. (a) By what factor will the symbol rate be reduced in the 8-PAM case? (b) By what factor will bandwidth required from the lowpass channel be reduced in the 8-PAM case? (c) Assuming the minimum spacing between pulse levels must be the same in both cases, by what factor will the average power be increased in the 8-PAM case? [Hint: take the pulse amplitudes to be ±A in the binary case, and ±4, +34, +54, +74, and recall that scaling pulse amplitude by a factor k scales the pulse energy by a factor K². Assume that the data is random, so that all 8 levels are equally likely, and that the same pulse shape is used in both cases.]

Data at a bit rate R, must be transmitted using either binary NRZ polar signaling or 8-ary PAM NRZ polar signaling. (a) By what factor will the symbol rate be reduced in the 8-PAM case? (b) By what factor will bandwidth required from the lowpass channel be reduced in the 8-PAM case? (c) Assuming the minimum spacing between pulse levels must be the same in both cases, by what factor will the average power be increased in the 8-PAM case? [Hint: take the pulse amplitudes to be ±A in the binary case, and ±4, +34, +54, +74, and recall that scaling pulse amplitude by a factor k scales the pulse energy by a factor K². Assume that the data is random, so that all 8 levels are equally likely, and that the same pulse shape is used in both cases.]

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

1. With the help of Octave program perform the Modulation and Demodulation (AM) of information signal with carrier signal, through subplots with following signals a. Modulating signal b. Modulated signal c. Demodulated signal
Example 1 20M₂ Amplitude of carrier signal is given 10 V, and freq? This carrier is modulated by 16 kHz signal and modulation index is 0.6. Devive the DSB-LC (Full AM) 2 terms And Sketch freq domain single Sided DSB -SC SSB (USB) SSB (LSB) - 3 terms
Explain the data rate (bps), symbol rate, bandwidth and noise. What are the relationship amongthem.
For a 4000 Hz bandwidth channel has a capacity of 40 kbps. The signal to noise ratio of the channel is ?
8.a. Which of the following statements about OSNR and BER is correct?A. BER isn't related to OSNR.B. Lower BER leads to a lower OSNR.C. Higher BER leads to a higher OSNR.D. Higher BER leads to a lower OSNR.8.b. An optical signal has a strength of 2.1 mW. What's this value in dBm?A. 2.11 dBmB. 2.32 dBmC. 3.10 dBmD. 3.22 dBm
What are the maximum rate and bandwidth of BPSK modulation?
Choose the correct answer low HDOP (Horizontal Dilution of Precision) number such as2 indicates a ........................... a.poor fix b.good fix c.poor signal quality d. good signal quality
A voice message of 2 kHz is sampled at DM system for a rate nine times the Nyquest rate. The maximum signal amplitude is unity to avoid slop over load. Assuming the input signal amplitude is uniformly distributed in the range .of (-1,1) determine SNR SNR=148.1 SNR=190.2 SNR=180.3 SNR=140.5 SNR=160.4 SNR=160.5 SNR=150.9
Thirty signals, twenty of them have 4 kHz bandwidth, the other have bandwidth of 3 kHz are FDM/TDM multiplexed then modulated by an RF carrier of 800 kHz using AM modulator: 1- Calculate minimum multiplexing and transmission bandwidths. 2- -Calculate multiplexing and transmission bandwidths if 0.7 kHz guard band is allowed between each two signals and below the first signal.
5. B-frames provide obvious coding advantages, such as increase in SNR at low bitrates and bandwidth savings. What are some of the disadvantages of B-frames?
Which is not true in simultaneous modulation? a. the AM signal is consisting of more than 1 pair of sidebands and a carrier signal b. the AM bandwidth is much wider than single tone modulation c. the effective modulation index is higher than the highest individual modulation index d. the effective modulation index can be lower than any of the individual modulation index
Explain the relationship between (a) the minimum bandwidth required for an FSK system and the bit rate and (b) the mark and space frequencies.