D5.3. Find the magnitude of the current density in a sample of silver for which o = 6.17 x 107 S/m and µe = 0.0056 m²/V ·s if (a) the drift velocity is 1.5 µm/s; (b) the electric field intensity is 1 mV/m; (c) the sample is a cube 2.5 mm on a side having a voltage of 0.4 mV between opposite faces; (d) the sample is a cube 2.5 mm on a side carrying a total current of 0.5 A. %3D

Q: A circular disk of radius 5m has surface charge density ρs = 0.75ρ , where 0

A: This is question related to total charge enclosed . solution is given below.

Q: A front of a building 50 m by 16 m is to be illuminated by sixteen 1000-W lamps arranged so that…

A: The solution can be achieved as follows.

Q: Q5: A) An EM wave of frequency (10 )MHz propagates through a medium has ( o-5 e,-3, H,-10). i)…

A: As per the guidelines of bartleyby I need to answer first subpart question only which contains…

Q: Given the electric field intensity, E = 400 yax + 400xay V/m, find (a) the equation of the…

A: It is given that: E=400yax+400xay Vma)A=2,1,-2b) E=800 V

Q: 4) In free space E(z,t) = 70cos(wt – Bz)z (V/m). Find the average power crossing a circular area of…

A:

Q: Determine the total potential energy stored, in microjoules, in a cylinder of radius 8 m and height…

A:

Q: H.W. 3: A sphere of radius b [m] carries a volume charge density of Pv [C/m³]. Inside this sphere…

A:

Q: A potential difference of 20 V is applied longitudinally to a rectangular specimen of intrinsic Ge…

A:

Q: b) A wire, (o=4.1x10' S/m, ɛ, =1) with radius 10 mm has a conduction current flowing through it with…

A:

Q: 1)An electric dipole of 100 az pC.m is located at the origin. Find V and E at point (0, 0, 10)

A: We are authorized to answer one question at a time, since you have not mentioned which question you…

Q: Develop an electromagnetic field environment equation for the electric field intensity, E provided…

A: We know electric field is negative gradient of potential . By finding gradient of potential we will…

Q: A parallel plate capacitor with plate area of 5 cm and plate separation o 3 mm has a voltage 50 sin…

A: In this question parallel plate capacitor is given...We have to find out displacement current and…

Q: Question 4 a. Find the outer radius of a coaxial cable whose characteristic impedance is 10Q. The…

A:

Q: Q/Let auniform surface chargedensily of 5nclm? be present at z=soplane,auniform line charge density…

A:

Q: In a Cylindrical coordinates, the volume charge density is given as sin o C/m Py = for the volume 0…

A: 0≤r≤2m, 0≤∅≤π,-2≤2≤2to find total charge

Q: 5,8 with the dielectric constant e = 7,8. The electric field is = Kâ, + Lâ, + Mã, for the region…

A:

Q: The electric field intensity is given as E = 5e-2x (sin2ya, – cos2ya, ) v/m. Find the equation of…

A:

Q: A potential difference of 15 V is applied longitudinally to a rectangular specimen insic Ge of…

A: Introduction: In thermal balancing, carriers (e.g., electrons or holes) do not stand still but move…

Q: . Given the electric field intensity, E 10ya, +4xay V/m, find: The equation of the streamline…

A:

Q: Design a dielectric-filled rectangular waveguide for transmission of electromagnetic power at 2.45…

A:

Q: b) A wire, (o=4.1x10' S/m, ɛ, =1) with radius 10 mm has a conduction current flowing through it with…

A:

Q: 1) The electric field component of a uniform plane VLF electromagnetic field vertically down in the…

A: Given

Q: Assume that dry soil has σ = 10−4 S/m, ε = 3εo, and μ = μo. Determine the frequency at which the…

A: Given data, σ=10-4 S/mε=3ε0μ=μ0

Q: A potential difference of 20 V is applied longitudinally to a rectangular specimen of intrinsic Ge…

A:

Q: Question.1 (a): Find the numerical aperture '0' if the MN = 8 cm, PR = 9 cm and the distance from…

A: Note as there are 3 questions and we are asked to solve one question at a time. So please do mention…

Q: Given a dielectric material with conductivity, O = 0.1 S/m, dielectric permittivity &r = 9, and…

A: Option A is correct.

Q: sheet of charge, ρS = 2nC/m2, is pressed at the plane x = 3 in free space, and a line charge, ρL =…

A: In this question we will find magnitude of the electric field intensity at the origin due to sheet…

Q: 2.10 An interactive experiment is being set up between the University of York, Eng- land (latitude…

A: It is given that: The University of York,Englandlatitude 53.5°N,longitude 0.5°WThe Technical…

Q: Coupling Efficiency. (a) A source emits light with optical power Po and a distribution I(0) (1/7)Po…

A: Given n1=1.46n2=1.455n3=3.5

Q: Given the potential field in cylindrical coordinates, V = 100 + 50ρ + 150ρ sinΦ  volts, and point P…

A:

Q: If the ratio of the plate width to the distance between the plates is 2π mm in a parallel plate…

A: In the question,  If the ratio of the plate width to the distance between the plates is 2π mm.  d/D=…

Q: (a) A source emits light with optical power Po and a distribution I(0) = (1/T)Po cos 0, where I(0)…

A: According to the question we have to solve only the first question. According to the question we…

Q: A satellite weighing 311.4 kN is at a 113 km perigee with a velocity of 11 km/sec. Calculate its…

A: Satellite weight = 311.4 kN at 113 km Velocity, V= 11 km/sec Total time is given = 240hr

Q: 2. Seawater plays a vital role in the study of submarine communications. Assuming that for seawater,…

A: From question 2 Permittivity=80×E0 E Per mobality=μ=1.u0 f=100KHZ Phase velocity  vp=1μE…

Q: Problem 5: The electric field intensity in a dielectric medium (e = €„€o, µ = µ) is given by E 150…

A: As per the guidelines of bartleyby I need to answer first three subparts only so kindly repost other…

Q: A potential difference of 20 V is applied longitudinally to a rectangular specimen of intrinsic Ge…

A: WHENEVER WE APPLY A POTENTIAL DIFFERENCE THEN WE WILL HAVE A DRIFT CURRENT CURRENT IN THE…

Q: An Underground cable of length 40 Km has a conductor of diameter of 1.5 cm and a sheath of inner…

A: Given a underground cable of length 40 km The conductor diameter d=1.5 cm The inner diameter of the…

Q: Determine the total potential energy stored, in microjoules, in a cylinder of radius 7 m and height…

A:

Q: 1. Point charges ql and q2 are held in place at the (x,y) coordinates specified below. Point P is a…

A:

Q: Planes x = 2 and y = -3, %3D respectively carry charges 10 nC/m² and 15NC/m². If the line x = 0, z =…

A:

Q: The point charge 6µC located at T(5,3,4) in free space. Find Eρ, E∅, Ez at P(6, 10, 3)

A:

Q: Point charges q1 and q2 are held in place at the (x,y) coordinates specified below. Point P is a…

A: Given q1 =2.778 nC q2 = 1nC   1) To find electric field at point P 2) To find angle of resultant…

Q: A potential difference of 20 V is applied longitudinally to a rectangular specimen of intrinsic Ge…

A:

Q: According to the figure, since r=-0,75, k=6,4, E = 19, 06 ( @ medium boundary) and incident electric…

A:

Q: A rectangular guide with dimensions of 5.7cmX2.524cm has air as its dielectric and operates at a…

A: Since you have posted a question with multiple sub-parts, we will solve the first two sub-parts for…

Q: In a certain region, the electric field intensity is given by: E = (2 cos o / r) a,(r sin 4) ag + (4…

A:

Fault Analysis

In an electrical engineering system, a fault is an abnormal electric current flowing through the system, and fault analysis is the study of these faults. For instance, a short-circuit is a fault where the live wire touches the ground or neutral wire. If a circuit is interrupted by a failure of a current-carrying wire then an open circuit fault occurs. The open-circuit faults are also called series faults. One or more phases or ground may be involved in a three-phase fault or may occur only between two phases. Current flows into the earth in case of a ground fault or earth fault. For most situations, the prospective short circuit current of a fault that is predictable can be calculated. To limit the loss of service because of a failure, the protective devices can detect fault conditions and operate circuit breakers and also other devices. All phases equally can be affected in a poly-phase system which is known as symmetric electrical fault. The asymmetric fault becomes more complicated to analyze if only some phases are affected. By using methods such as symmetrical components, the power system analysis of these types of faults is often simplified. The main objective of power system protection is to design, detect, and interrupt power system faults.