D Question 6 The current in a series inductive circuit is 8 amp at 25 Hz. The circuit takes 450 watts, and the power factor is 0.78. Determine series inductance. A. 48.93 mH C. 38.86 mH B. 40.75 mH D. 35.86 mH

Q: 3. What is the equivalent resistance of the combination of identical resistors between points a and…

A: In this question,  We need to calculate the equivalent resistance across the terminal a and b.  We…

Q: Compare i1= - 5cosωt A with i2=3 sin(ωt-106º).  By what angle does i1 lead i2?

A:

Q: A particular pn junction at T = 300 K is doped with impurity concentrations of N₁ = 1.2 x 10¹4 cm³…

A: Given,T=300 KNd=1.2×1014 cm-3Na=2×1014 cm-3po=1.1×1014 cm-3Vt=25 mV∈s=13.1 ∈0

Q: B- Find the F.T of f(t) = cos(w.t) f(x)

A:

Q: 1. Determine the frequency deviation and carrier swing for a frequency-modulated (FM) signal which…

A: We need to analyse the given frequency modulated signal

Q: 12 V 452 ww X 1=0 5H] i(t) 5Ω (Ι) 3 A

A:

Q: A 35 A current flows through a 47 Q resistor. What is the voltage across the resistor? Ex: 540 V

A: Given, Current, I=35 A. Resistance, R=47 Ω.

Q: You can use Source Transformation to convert Thevenin's equivalent circuit to Norton's. A) True B)…

A: In this question we need to verify the given statement is true or false.

Q: The open-loop DC gain of a unity negative feedback system with closed loop transfer function (S+ 4)…

A: Given, Closed loop transfer function, CsRs=s+4s2+7s+13.

Q: What effect does coupling coefficient have in the secondary winding output voltage?

A: Coupling coefficient:- The percentage of the magnetic flux generated by one coil's current that…

Q: A dc voltmeter has a sensitivity of 1000 92/V. When it measures half full scale in 100 V range, the…

A: Given: A DC voltmeter has, Sensitivity = 1000 ΩV. It measure half full scale in 100 V range.

Q: A Thevenin Equivalent circuit is: An equivalent circuit with a voltage source, A) Vth, in series…

A: We need to select correct option for thevenin equivalent circuit .

Q: A transmission line operating at 11 kV s delivering 10 MW of power. If the line woltage is changed…

A:

Q: .. Find Inverse Z-Transform for the following function: H(z) = 1+2z 1-52-2+62-3 1-32-1+22-2 -, |z|>2

A:

Q: 4 K(s+3) For a unity feedback system with G(s) = s(s+2)(s+4) (s+6)' whether the system can have the…

A:

Q: a. Find VA, VB, IA, IB, Ic, ID, and IE. b. Find the power for each of the sources, using the passive…

A: The required parameters can be calculated by using kirchhoff's voltage law, kirchhoff's current law,…

Q: series generator having a combined armature and field resistance of 0.4 ohm us running at 1000 rpm…

A:

Q: 2. Find current i, and voltage v.o. ↓io ío 0.510 1 + Vo 42 1) 3A

A: Given, The circuit is,

Q: A series R−L−C circuit is connected to a 0.2V supply and the current is at its maximum value of 4 mA…

A: Given that Voltage V = 0.2 V Current I = 4mA = 4×10-3 Resonance frequency ωr = 3 kHz

Q: An A/D converter has a full-scale voltage of 10V. 1. What's the minimum number of bits if a…

A:

Q: Given V₂ = -5.37 V, use Kirchhoff's Laws to find the current I, (in Amps). 5 V + I www Vx + Ix + 5…

A: The given circuit is,

Q: 21) Answer two only A- Sketch the single-sided and double-sided spectra for phase and amplitude of…

A:

Q: 6. These 3 sinusoids are added together, and sampled every 10 ms, Calculate the first 10 points of…

A: Given three continuous time domain signal. Asked to find the digitalized signal sampled at 10ms, and…

Q: B: Find the stability of the system, whose characteristic equation is gi follows F(Z)=Z³ - 2.2Z² +…

A:

Q: X(f) fourian transform -j2in pt - 3x X(+) e id= if X(t) = 2₂ cos (3πT fet) find X(f) and plot

A:

Q: Describe the operation of a transparent latch and possible applications for it.

A:

Q: energy bands in the neutral p and n regions and in the space charge region. b) Draw the space charge…

A:

Q: Given V₂ = -6 V, find the power (in Watts) of the element below. + Q Vx 10 -5 A

A: The given element is, Here the voltage Vx=-6 V.

Q: Draw the logic circuit represented by each expression: (C) ABC (d) AB+CD

A: Given: Boolean expression, ⇒AB+CD

Q: Q3. Draw f(t)-u(t-1) Q4. Draw f(t)-1+u[1-n] tsignal. Assume f-300 Hz. Also fill time axis Ô T 2 180…

A:

Q: For the following voltage function: What is the correct value for the frequency in Hz, for the…

A: In this question,  We need to determine the frequency of the voltage signals.  We know Standard…

Q: 128. A sine wave has a frequency of 50 Hz. Its angular frequency will be A. 50 radians/sec B. 50 n…

A: We need to select correct option for angular frequency

Q: Question: The maximum deviation allowed in an FM broadcast system is 75 kHz, If the modulating…

A: FM is a type of modulation where variations in the carrier wave frequency immediately translate into…

Q: Convolve the spatial impulse response and the input signal h(n₁, n₂) = . (0, x (n₁, n₂) (n₁, n₂) =…

A:

Q: An FM transmission has a frequency deviation of 20 kHz. (i) determine the per cent modulation of…

A: The percentage modulation is the ratio of maximum frequency deviation to the actual frequency…

Q: Given the following linear system: 8 d²y(t)gdy +7 y(t) = 6r(t) dť²2 dt Find Y(s)/R(s) for the above…

A: We need to find out transfer function for given equation

Q: op-Amp circuit that produce output given by V₂ = -(4√₁ + √₂ +0:1√₂) if v₁ = 2 sin wt ; V₂ = 5V, and…

A:

Q: 1. What would a mobile robot most likely use to locate itself in a large vacant parking lot? a.A…

A: Solution of question (1): It is asked what is used by a mobile robot most likely use to locate…

Q: Q2) Tick the correct answer for the following statements 1. An ideal transformer is connected to a…

A: Given: Ideal transformer is connected to a 50 V battery, while the load is 100 Ω. the turn ratio is…

Q: Q5/ for the following circuit Find the voltages V1, V3, a Vab for the network of Fig (5) ? 6V R₂ 601…

A: We need to find out voltage for given circuit

Q: What is the value of Vx in the circuit below? 20Ω www 10V + 5Ω Vx 4Ω 8Ω

A: Given circuit,

Q: Upon checking the spectrum analyzer, a 2 dB single-tone is detected and a noise floor at -5 dB.…

A:

Q: Norton's Equivalent circuit consists of: A) A current source in series with a resistor. B A current…

A:

Q: A fuse is rated at 100 A. The fuse has a round filament. If the fuse must have a fusing factor of…

A:

Q: What are the different types of 4 layered diode

A:

Q: 13. Carol bought %4 meters of yellow lace and 3/8 meters of red lace. How many meters longer is the…

A: Ans.(13) Given: Carol bought 34meters of yellow and 38meters of red

Q: Q2: Suppose you have the following modulated signal with the output wave changes of ± 5.5 Vp: Vam…

A: Since you have posted a question with multiple sub-parts, we will solve the first three sub-parts…

Q: Question 9 50 V 30 www SA Selected Answer: 60 Correct Answer: 60 150 ●0 If R 54 2, then the Thevnin…

A: Given data, R=54 Ω. Circuit diagram is given by,

Q: Consider a causal second-order system with the transfer function G(s) 1 with a unit - step R(s) ==…

A: As per the question, the given transfer function is G(s) = 1s2+2s+1 Unit step R(s) = 1s We have to…

Q: 5V 4 V₁. V₂ i Vzi 1₁: 12: 150 - V₂ + + I toon w 1000. 4702 Vi I₂ 220-2

A:

Nodal Analysis

In the analysis of any electric circuit, nodal analysis is the method of determining the potential difference or voltage between different nodes in an electric circuit. A node is a point where two or more branches connect each other. In the nodal analysis, the voltages are determined in the terms of branch currents. The nodal analysis is also known as the node voltage method or branch current method. The nodal analysis method is one of the several applications of Kirchhoff's Current Law (KCL).