Calculate Zin at the load using smith chart for total transmission lines, while thewavelength is 10 cm for two lines?2.4 cm3.5 cmZ01 = 100 NZ02 = 750R = 1500Zin

Answered: Image /qna-images/answer/3509500e-f958-48b5-8bff-56dc75488391.jpg

Answered: Calculate Zin at the load using smith…

Calculate Zin at the load using smith chart for total transmission lines, while the vavelength is 10 cm for two lines? 2.4 cm 3.5 cm Z01 = 100 N Z02 = 752| |R = 1502 %3D Zin

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter4: Transmission Line Parameters

Section: Chapter Questions

Problem 4.27MCQ: In terms of line-to-line capacitance, the line-to-neutral capacitance of a single-phase transmission...

See similar textbooks

Related questions

Q: A short transmission line is represented by an impedance of 0.01 + jo.04. What is the voltage…

A: Given data, A short transmission line has Z=0.01+j0.04 ΩI=1.93∠-8° puVs=1∠0° pu

Q: Part A] Assuming a transmission line with Zo=50 ohms, draw the corresponding Bergeron diagram. (the…

A: Given circuit uses driver and load whose non-linear I-V characteristic is shown. Assuming a…

Q: An extra high voltage transmission line of length 300 km can be a lossless line having propagation…

A: Given: An EHV lossless line, l=300 kmPropagation constant (β)=0.0027

Q: The transmission line has the following data weight of the conductor = 6.5 kg/m, Tension in the…

A: For the given sag condition need to find the distance between the towers

Q: We say a transmission line is matched when: a) ZĻ=Zo b) Z_=vZo c) ZL=Zo/2 d) Z, =2Z.

A: For a transmission line, two of the most common parameters under consideration are: 1. The…

Q: The sending end and receiving end voltages of a 30 transmission line at a 200MW load are equal. The…

A: Consider the given data: The maximum power transmitted per phase is 9 MW The per phase line…

Q: Q3: A lossless transmission line as shown below. Find Kr, S, and Zin? -1%3D0.35%- Zin Zo = 100 Q ZL=…

Q: The data of a Medium transmission line are: A= D = 0.98 <3°, B = 110 275° ohm, C = 0.0005 280°…

A: As it is medium transmission line so Apply formula

Q: Q4: Lossless transmission line of 0.25 having Z. ZL = 40 + j 30 . Find the following numerically…

A: We need to find out input impedance and reflection coefficient and standing wave ratio .

Q: A single phase transmission line has two parallel conductors 2.5 meters apart with 2.5cm diameter.…

Q: -3-phase line conductor 3/5 E the dielectric strength of citical voltage for the line. actor mo=…

Q: B 0.5m 0.5m 12m 12m A three phase,50 Hz transmission line with bundled conductors is shown in the…

Q: Transposition of transmission line is done to А. balance the line voltage drop В. reduce the corona…

A: Transposition is done to reduce unbalancing of transmission line.

Q: The A and C constants of a medium length transmission line is 0.936 + j0.016 ohms and (-5.18 + j914)…

A: Basic problem on transmission line in power system.

Q: I need the answer quickly

Q: Q4: Lossless transmission line of 0.25 2 having Z, ZL = 40 + j 30 Q. Find the following numerically…

Q: :A 502 lossless transmission line of 1.622 length is terminated with (70-j70)Q load. Find: (a) VSWR,…

A: As per Bartleby guidelines we are allowed to solve only three subparts, please ask the rest again.…

Q: Problem statement: A three phase 60- Hz, 550- kV transmission line is 300 km long. The line…

A: we have given ;A three phase system frequency f=60Hzsource voltage =550kVlength of transmission line…

Q: Transposition of transmission line is done to А. balance the line voltage drop В. reduce the corona…

A: Transposition of the transmission line is the physical rotation of the conductor that is the…

Q: For a transmission line terminated with short circuit (ZL=0), the value of Z at (I = N4 )is: * O je…

A: This question belongs to the concept of transmission lines.

Q: If the maximum and minimum voltages on a transmission line are 4 V and 2 V, respectively, for a…

A: Given, Maximum voltage on a transmission line is Vmax = 4 volts Minimum voltage on a transmission…

Q: Match a load of ZL=120+80j Ω to a Z0=100 Ω transmission line using a shunt single stub if the stub…

Q: Q3: A lossless transmission line as shown below. Find Kr, S, and Zin? -1 = 0.352 - Zin Zo = 100 2 ZL…

Q: 10. A new cable section is being spliced to replace a broken section of cable. The loss before the…

A: The solution is given below

Q: A long transmission line of 370 N surge impedance is connected to two cables each of surge impedance…

A: According to question we have to calculate the value of junction voltage, current wave and voltage…

Q: Example: A 3-6 transmission line 250 km long has the following constants: Resistance/phase/km 0-16 2…

A: Answer -

Q: A 50 Q air-filled transmission line of 3.45A is terminated in a load C. impedance of ZL = 90 - j30…

A: Given Zo = 50 ohm ZL = 90-j30 ohm L= 3.45 λ In smith chart we move towards the generator only…

Q: Erample: A 3-o transmission line 250 km long has the following constants: Resistance/phase/km = 0-16…

Q: The transmission line has the following data weight of the conductor = 4.1 kg/m, working tension =…

A: Weight w=4.1kg Sag S=2.7m T= 1342kg

Q: дноши for the lossless transmission lin below, the n is driven with a generator that has Eg=30 Vrms…

A: Given, Z0=50 Ωl=50 cmEg=30 VZg=25 Ω VSWR = 3.7

Q: a single-phase transmission line has two parallel conductors, 1.5 meters apart. the radius of each…

A: According to question: Let A and B be two conductor of single phase transmission line, so inductance…

Q: 4.3 Find the voltage and current on a finite transmission line with a point current source shown in…

Q: (Q1] Determine the input impedance of a short-circuited 50 2 coaxial line with B =8.5 rad/m when its…

Q: Example: A 3-ø transmission line 250 km long has the following constants: Resistance/phase/km = 0-16…

Q: In short transmission line calculations, the effects of the line capacitance are neglected because…

Q: Kelvin's Law gives the cross section of a feeder conductor, based on an economic balance between the…

A: The cost of conductor material is a vital part of the total cost of a transmission line. Therefore,…

Q: 2. A 3-phase transmission line, 160 km long, has the following constants: Resistance/phase/km = 0-2…

A: The correct solution can be achieved as follows.

Q: 3. Stability requirements limit the power-handling capability of: a. Long lines. b. Short lines. c.…

A: Stability requirements limit the power - handling capability of Long lines. Option A is the correct…

Q: 2. Construct a bounce diagram and plot the voltage vs time at both ends of the transmission line for…

Q: For a three-phase long transmission line, Z, = 406.4/-5.48" 2, V = 215/0" kV und I = 335.7/0 A, all…

Q: A single phase transmission line is composed of three solid 2.5 cm radius copper wire and two solid…

A: a) & b) The transmission line arrangement can be drawn as

Q: The voltage drop (VS - VR) in the line is expressed as a percentage of receiving end voltage VR and…

Q: For a given power transfer which of the following is true. Star is associated with larger line…

A: a) Star is associated with larger line current-FALSE

Q: The power obtained at the receiving end of a transmission line is generally less than the sending…

A: The power obtained at the receiving end of a transmission line is generally less than the sending

Q: A 220 kV three-phase transmission line is 90 km long. The resistance is 0.1 92/km and the inductance…

A: Given- Three-phase transmission line, VR=220 kV,D=90 km,R=0.1 Ω/km,L=1 mH/km. To Find- (i) voltage…

Q: TUTORIAL PROBLEMS 1. A single phase transmission line has two parallel conductors 1-5 metres apart,…

A: Since you posted the multiple questions, so I am solving 1st questions for you

Q: 2. Compare the performance of the transmission line (regulation, efficiency) with pure resistive…

Q: lossless transmission line has a chara of Zo=302, load reflection coefficient load impedance? 90 120…

Q: 5. The propagation constant of a transmission line with impedance and admittance of 9 and 16…

Concept explainers

Single Phase AC Circuit

Alternating Current (AC) is a type of electric power in which the electric current changes, both in magnitude and direction, at regular intervals. This AC Circuits can deliver power in either a Single Phase system or a Three Phase system.

Question

Calculate Zin at the load using smith chart for total transmission lines, while the
wavelength is 10 cm for two lines?
2.4 cm
3.5 cm
Z01 = 100 N
Z02 = 750
R = 1500
Zin

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step 3

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 3 steps with 3 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Analysis of Single Phase and Three Phase System

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

One circuit of a single-phase transmission line is composed of three solid 0.12" radius wires. The return circuit is composed of two 0.15" radius wires. Find the inductance of the complete line in mH/mi. The distance between wires are 40" horizontally and 25" vertically. A. 2.54 mH/mi B. 2.478 mH/mi C. 2.488 mH/mi D. 2.567 mH/mi Provide Clear Explaination
4/ Which parameter is neglected or ignored in Short Transmission Lines? A. SHUNT CAPACITANCE ONLY B. SERIES CONDUCTANCE AND SHUNT CAPACITANCE C. SHUNT CONDUCTANCE AND SHUNT CAPACITANCE D. SHUNT CONDUCTANCE ONLY
A single-phase transmission line consisting of two conductors, the radius of each conductor is 0.4 cm, the distance between the conductors is three and half meters and the height above ground is eight meter. Determine 1)The capacitance in uF/km without effect of ground 2)The capacitance in uF/km with effect of ground
For the Figure 8 shown: A 181 -mile long, 60 Hz, three-phase, transmission line is composed 2 parallel lines. The conductors in the lines are stranded with GMR of 0.3146 -inch each. If the distance D in the figure is 6 ft., What is inductance per line in (mH)? Figure 8 o ‘O 1.732D 1.732D b' D 1.732D 2D D 1.732D 。
For the Figure 9 shown: A 273 -km long, 47 Hz, three-phase, transmission line is composed 2 parallel lines. The conductors in the lines are stranded with GMR of 13.59 -mm each. If the distance D in the figure is 4.78 m., What is inductive reactance per line in (ohm)? Figure 9 b D 1.732D 2D 1.732D 1.732D D b' 3 1.732D
For the Figure 9 shown: A 65 -km long, 59 Hz, three-phase, transmission line is composed 2 parallel lines. The conductors in the lines are stranded with GMR of 15.92 -mm each. If the distance D in the figure is 2.46 m., What is inductive reactance per line in (ohm)? Figure 9 $0 D 1.732D 2D 1.732D 1.732D D b' 1.732D
The affect of the earth plane is to slightly increase the capacitance, and as the line height increases, the effect of earth becomes negligible. True False
In terms of line-to-line capacitance, the line-to-neutral capacitance of a single-phase transmission line is Same Twice One-half
Ideally, a dc load line is a straight line drawn on collector characteristic curves between which of the following? Please select one: a. Q Point and shear b. Q Point and saturation c. V_CE (interrupt) and I_C (sat) d. I_b = 0 and I_B = I_C/ß_DC
An over head transmission line supported from two towers location at the same level. The distance between the towers is 200 m. The tension in the wires is 9000 N. The weight of one meter of the conductor is 10 N. The sag of the wires is * 2.55 m 1.55 m 4.55 m 5.55 m Non of them
Paragraph Styles The power factor must be close to in the transmission lines will be reduced To insure that losses D(Ctrl) -
λ A section of a 600 22 transmission line, short 2 circuited at one end and open circuited at the other end, is shown in the figure is 100 V/7522 generator is connected at the mid point of the section as shown in the figure. Find voltage at the open circuited end of the line. 7562 + 100v 1/4 1/4.